Fritz! FRITZ!WLAN 310 Manuel du propriétaire
FRITZ!WLAN Repeater 310 Installation and Operation Instructions
1
FRITZ!WLAN Repeater 310 Installation and Operation Instructions
2
Button and LEDs
The Fritz!WLAN Repeater has a button and various LEDs on the front panel.
Button
The Following functions are operated using the button:
Function Press for at Least
Switch wireless LAN on and off 1 second
Initiate WPS quick connection 6 seconds
Reset the repeater to factory settings 15 seconds
LEDs
LED Condition Meaning
Flashing No connection with WLAN base station or searching for WLAN base station
Up to 5 LEDs
are lit up The more LEDs are lit up, the stronger the signal of the WLAN radio
connection between the WLAN base station and the Fritz!WLAN Repeater.
Power Flashing •Fritz!WLAN Repeater starts
•Updating the firmware of the Fritz!WLAN Repeater
On Fritz!WLAN Repeater is ready for operation
WLAN
Flashing •Fritz!WLAN Repeater adopts WLAN settings
•Switching WLAN radio network on or off
•Performing WPS
Flashing
rapidly WPS procedure was aborted: More than two WLAN devices are performing
WPS at the same time. Repeat the procedure.
On The WLAN module of the Fritz!WLAN Repeater is ready for operation
All Flashing Factory setting are loaded
FRITZ!WLAN Repeater 310 Installation and Operation Instructions
3
Connecting Fritz!WLAN Repeater with a Base Station
This chapter describes how to connect the Fritz!WLAN Repeater with your Fritz!Box or with another
wireless LAN base station via a wireless radio network.
You can also register two or more Fritz!WLAN Repeater with your Fritz!Box.
Establishing a Connection Using WPS
Using WPS (Wi-Fi Protected Setup), you can establish quickly and easily a secure WLAN connection. You
can use WPS if the following prerequisites are met:
Prerequisites
•The WLAN base station must support WPS (the latest Fritz!box models support WPS).
•WPS must be enabled in the WLAN base station.
WPS is enabled upon delivery in the latest Fritz!Box models. In older Fritz!Box models, enable
the WPS method in the user interface under “WLAN / Security / WPS Quick Connection”.
•The WLAN base station must support the WPA or WPA2 encryption standard.
•The SSID (radio network name) of the WLAN base station must be set to “visible” (announced).
The SSID of a Fritz!Box is visible upon delivery.
•If a MAC address filter is active in your WLAN base station, the MAC address of the Fritz!WLAN
Repeater must be entered there as an exception. You can also disable the MAC address filter
until the connection to the Fritz!WLAN Repeater is established.
FRITZ!WLAN Repeater 310 Installation and Operation Instructions
4
Connecting Fritz!WLAN Repeater via WPS with Fritz!Box
This section describes how to connect the Fritz!WLAN Repeater with any other WLAN base station that
supports WPS as described below. In this case, please also take note of the instruction in the
documentation of your WLAN base station.
1. Connect the Fritz!WLAN Repeater to an electrical outlet in the vicinity of the Fritz!Box.
2. Press the “WPS” button on the Fritz!WLAN Repeater. Hold the button down until the “WLAN” LED
begins flashing. This takes about 6 seconds.
FRITZ!WLAN Repeater 310 Installation and Operation Instructions
5
3. Now press the “WLAN” button on the Fritz!Box within the next two minutes. Hold
the “WLAN” button down until the “WLAN” LED of the Fritz!Box begins flashing.
This takes about 6 seconds.
The connection between the Fritz!WLAN Repeater and the Fritz!Box has been
established when the LEDs that display the strength of the wireless radio signal stop
flashing and remain lit.
The Fritz!WLAN Repeater is preconfigured so that that the radio network
name (SSID) and WLAN key of the Fritz!Box are adopted automatically
upon connection with the Fritz!Box.
Table des matières
Autres manuels Fritz! Répétiteur
Fritz!
Fritz! Fritz!Repeater 1200 Guide rapide
Fritz!
Fritz! Fritz!Repeater 1200 Manuel utilisateur
Fritz!
Fritz! Powerline 1220E Manuel du propriétaire
Fritz!
Fritz! Repeater 6000 Manuel utilisateur
Fritz!
Fritz! 1750E Manuel du propriétaire
Fritz!
Fritz! 310 Manuel du propriétaire
Fritz!
Fritz! Repeater 6000 Manuel utilisateur
Fritz!
Fritz! Fritz!Repeater 1200 Manuel du propriétaire
Fritz!
Fritz! 310 Manuel du propriétaire
Fritz!
Fritz! FRITZ!WLAN Repeater 300E Mode d’emploi
Fritz!
Fritz! 3000 AX Manuel utilisateur
Fritz!
Fritz! 310 Manuel utilisateur
Fritz!
Fritz! Fritz!Repeater 600 Guide rapide
Fritz!
Fritz! 1160 Manuel du propriétaire
Fritz!
Fritz! Dect 100 Manuel utilisateur
Fritz!
Fritz! FRITZ!WLAN Repeater 300E Manuel utilisateur
Fritz!
Fritz! WLAN Repeater Manuel du propriétaire
Fritz!
Fritz! 1750E Guide rapide
Fritz!
Fritz! DVB-C Manuel du propriétaire
Fritz!
Fritz! AC430 MU-MIMO Guide rapide
