c
23mm
2
4
7
1
1"
5
67
6
8
5
8
c
23mm
2
4
7
1
1"
5
67
6
8
1/4" (6mm)
1 1/4"Flat Head Screw (4 pcs)
1840mm
1510mm
76"
63"
72 1/2"
59 1/2"
7/8" 7/8"
1840mm
1510mm
76"
63"
72 1/2"
59 1/2"
INSTALLATION PROCEDURE / STEP 3
3
LEFT HAND ASSEMBLY RIGHT HAND ASSEMBLY
1. Outside distance between rail wall bracket assembly (7) and door guide(19) should be 1.
2. Remove top plates from both rail wall bracket assemblies (7).
3. Measure straight up the wall to a point 3 ½ less than the overall height of the enclosure
(Distance C in the table below) and mark it.
4. Position the rail wall bracket (7) so that the front bottom corner of the bracket is at the point shown
in the drawing below. (3 ½"below overall height and 7/8"behind the front edge of the door guide).
Make certain the bracket is level and square before tracing the bracket and marking the screw holes.
5. Drill hole with 1/4drill bit.
6. Glue a little silicone into the hole, then insert wall anchor(6).
7. Fix rail wall bracket against the wall with flat head screw 4x 1 1/4(8).
HINT: Before proceeding to Step 4, to ease the installation process, it is recommended that you set the
inner glass panel against the back wall of the shower. Be sure to first put down a towel or piece of card-
board as a cushion to protect the glass and your shower floor from possible damage and to position the
glass so that the H2OFF® protectant is on the side of the glass that is against the back wall.
- 5 -
5
8
1 1/4"Flat Head Screw (4 pcs)
Overall Height Overall Height
Distance C Distance C
1/4" (6mm)
