2. Your terminal must be connected to an AT&T tower to successfully download the updated files
3. From the VMAC FIS WIC screen
a. Press the BLUE Bubble to the right of the ALPHA Bubble at the bottom of your screen
b. This will bring up the Network Control Panel (NCP)
i. Verify you are connected to AT&T and your Signal Strength is more than 11%
ii. If your terminal is not connected to AT&T; power down your terminal and then
power it back up so it can connect to the nearest AT&T tower
WIC Download/Update steps:
1. At the same time
a. Press the Green ENTER button and number (7) one time
2. When the screen says Please Enter Password
a. Type 166831
b. Press ENTER
3. From the VERIX TERMINAL MGR screen
a. Press (2) Edit Parameters
4. When Group ID: _1 appears
a. Press ENTER
5. When the screen says Please Enter Password
a. Type 166831
b. Press ENTER
6. When File: CONFIG. SYS appears
a. Press ENTER
7. You are now in the Parameters File, you will be looking for *ZA *ZN *ZT
a. Press the Green ENTER button to scroll through the Parameters
b. Verify Parameter: *ZA has Value: *MA
i. Press ENTER multiple times until you see *ZN
c. Verify Parameter: *ZN has Value: SSLGTWYD1.FNIS.COM:8013 or SSLGTWYD1.FNIS.COM
or SSLGTWYP1.FNIS.COM:8013 or 67.23.53.172:8013
i. If *ZN Value is empty, press (3) to Edit
ii. Very Slowly, Type in 67.23.53.172:8013 instructions directly below (if type too
quickly, the numbers will change into other characters)
1. Press 6 then 7 then (press (1) three times quickly for the .)
2. Press 2 then 3 then (press (1) three times quickly for the .)
3. Press 5 then 3 then (press (1) three times quickly for the .)
4. Press 1 then 7 then 2 then (press (#) multiple times to get the colon : )
5. Press 8 then 0 then 1 then 3
6. Press ENTER when done, to go back to the Parameters
iii. Press Enter multiple times until you see *ZT
d. Verify Parameter: *ZT has your WIC POS ID as the Value, for example (F123456001)
