Operating Instructions Operating Instructions
PM2.5（ug/m³）
000-050
051-100
101-150
151-200
>200
Standard
PM2.5
Air Purifier Level
Healthy
Good
Fair
Unhealthy
Poor
Speed(Auto)
1
2
3
4
Turbo
Color
Blue
Green
Yellow
Orange
Red
1 .Power On/Off
Press to turn the appliance on or off.
2. Speed
The Speed 1 and “ ” is fully bright by default after turning on the appliance.
Click on “ ” to accelerate the fan speed,while “ ” is to decelerate. Press the
button one time to accelerate or decelerate one gear.
3 .Slide Controls
Control the wind speed according to the speed finger slides .Slide right to increase wind
speed,instead, slide left to decrease wind speed. Fan speed increases by two fan lights,
there are four fan speeds total.
4. Turbo Mode
Press “ ” or “ ” until max speed to reach Turbo mode. The “ ” and all speed
indicators will be fully illuminated.
5. AUTO mode
Press “Auto” to enter AUTO mode. Auto mode will adjust the fan speed automatically
between 1 to 5 according to the air quality level.
6. UVC
The UVC lamp is ON by default when the appliance is turned on. Press the UV button to
turn on or off, indicated by the shield light indicator. If the light is on, the uVC lamp is on,
if the light is off, the UVC lamp is off. When the UVC lamp needs to be replaced, the UVC
indicator will blink notifying the user. After the UVC light is replaced, press, and hold the
UVC light change indicator for 5 seconds to reset the UVC light indicator.
7.Child Lock
After the purifier is turned on, press and hold the UVC button for 3 seconds to turn on the
child lock. Press and hold the UVC shield icon for 3 seconds again to turn child lock off.
While the child lock is on, all buttons will be disabled except to turn off the child lock.
8.Filter Reset
The Filter icon will blink when the filters require replacement. After replacing the filters
press and hold the Auto mode button for 5 seconds to reset the filter indicator.
9.Power off before removing filter cover
Before replacing the filter, power off the appliance and remocve power cord from outlet.
After replacing the filter, plug appliance back into outlet and power on. Ensure the filter
covers are fully installed and closed, otherwise the power indicator will flash slowly.
10.Light Sensor function and Sleep Mode
The appliance will enter Sleep mode if the surround environment is dark for over 1 minute
and the unit is in Auto mode. When in Sleep mode, if the surrounding environment is
bright for more than 1 minute, the unit will return to its previous mode before it enters
Sleep mode. The Light sensor only functions in Auto mode.
11.Particle Sensor and Fan Speed
The PM2.5 sensor requires a 1-minute warmup beofre displaying the PM2.5 value in
real time. A 60 second countdown will be displayed until the PM2.5 readings are
presented. The PM2.5 readings, corresponding IAQ colors and AUTO mode fan speed
are provided in the following table below.
