Fanvil I16S-02P Manuel utilisateur

i16S-02P SIP Intercom

Quick Installation Guide

www.fanvil.com

1) Panel

Device size

Package Contents

Physical specification

SIP Intercom

Quick Installation

Guide

Connector

Mounting Template

195 x 120 x 40 (mm)

Screw and tool

Speaker

MIC

SOS Key DSS Key

i16S-02P SIP Intercom

Quick Installation Guide

www.fanvil.com

2) Interface description

①

② ③ ④ ⑤ ⑥ ⑦ ⑧

Serial

number Description Wiring port description(example above)

①Ethernet interface: standard RJ45 interface, 10/100M

adaptive, it is recommended to use five or five types of

network cable

Two groups of short-circuit input detection

interfaces: for connecting switches, infrared probes,

door magnets, vibration sensors and other input devices

Left positive, right grounded

Two groups of short-circuit output control

interface: used to control electric locks, alarms,

etc.

Left grounded, right recording output

Recording output interface: Mix the device and the

sound of the far-end call. One is the recording signal

line, and the other is the ground line (be sure to ground

the line, otherwise there will be noise)

Left grounded, right external active speaker

②

③、⑤

④、⑥

⑦

⑧

Power interface: 12V/1A input

Left IN, right OUT

Left (NC): Normally Close Contact

Center (COM): Common Contact

Right (NO): Normally Open Contact

External active speaker interface: external active

speakers for audio power amplification. One is the audio

signal line, and the other is the ground line (be sure to

ground the line, otherwise there will be noise)

Open the rear case of the device, there is a row of terminal blocks for connecting the power supply,

electric lock control, etc. The connection is as follows:

1) Use built-in screw tool to remove the surface shell;

2) Based installation dimensions, mounting hole in the wall to draw, use an electric drill holes lay;

3) The white rubber plugged into the wall and the bottom fixed with screws to the wall;

4) After connecting the power cord and network cable, screw the surface shell fixed.

Installation Diagram

Fanvil Technology Co., Ltd

Website: www.fanvil.com

EMail: [email protected] [email protected]

Tel: +86-755-2640-2199 Fax: +86-755-2640-2618

Add: 10/F Block A, Dualshine Global Science Innovation Center,

Honglang North 2nd Road, Bao'an District, Shenzhen, China

Method 2:

Long press DSS key for 3 seconds(after power-on for 30 seconds), and when the speaker beeps

rapidly, press DSS key again quickly, the beeps stop ,the intercom will report the IP address by itself.

Step 1:Log in to the device page

Use the web browser input IP (for example: http://192.168.1.128) access.

The default user and password are admin.

There as shown below to search the device.

Methods 1:

Download address: http://download.fanvil.com/tool/iDoorPhoneNetworkScanner.exe

Open the iDoorPhone Network Scanner. Press the Refresh button to search the device and

find the IP address.

Method 3:

In addition, device provides the device surface DSS key operation to switch IP address acquisition mode:

In the standby mode, long-press the DSS key for 3 seconds and the beep will last for 5 seconds.

Within 5 seconds, press the DSS key three times quickly to switch to the network mode.

a. If it is in the mode of DHCP and doesn't receive the IP address, switch it to the mode of

static IP (192.168.1.128), broadcast the IP address after the successful switch.

b. If it is in the mode of static IP address (192.168.1.128), switch it to the DHCP mode, broadcast

the IP address after the successful switch.

c. If it is in the mode of DHCP and obtain the IP address, the mode will not be switched and directly

broadcast the IP.

Searching device

Fast settings

Default Setting

Default DHCP Client

Voice broadcast

IP address

Enabled by default

Hold the DSS key for 3 seconds,

then press the DSS key again.

Static IP address

Default Web port

192.168.1.128

i16S-02Pi16S-02P

Step 3: Set the volume (if not connected can skip)

Intercom settings => Media Settings => Media Settings

Set the device volume size, as shown below, click [Apply].

Speakerphone volume setting: set the speaker volume of normal calls.

Handsfree Mic Gain: set the microphone volume of call.

Step 4: Set function key (if not connected can skip)

Set the function key as shown below for a quick start, click [Apply] to save this settings.

Type: Memory key

Number 1 (Value): the function key will dial to this number 1

Number 2 (Value 2): if number 1 is unavailable, it will be forwarded to number 2.

Subtype: speed dial

Line: working line

Step 5: Set the security function

1 set of short-circuit input and output settings, tamper alarm server settings.

Step 2: Set SIP account

Set SIP server address, port, user name, password and SIP user with assigned SIP account parameters.

Select “Activate”, and then click [Apply] to save this setting.

Table des matières

Autres manuels Fanvil Système d'interphone

Fanvil

Fanvil i20S Manuel utilisateur

Fanvil

Fanvil i55A Manuel utilisateur

Fanvil

Fanvil i12 Manuel utilisateur

Fanvil

Fanvil Y50r-Y Manuel utilisateur

Fanvil

Fanvil I20-T Manuel utilisateur

Fanvil

Fanvil i16S Manuel utilisateur

Fanvil

Fanvil i16V Manuel utilisateur

Fanvil

Fanvil i55A&i55A-Z Manuel utilisateur

Fanvil

Fanvil V65 Manuel utilisateur

Fanvil

Fanvil i31S Manuel utilisateur

Fanvil

Fanvil PA2 Manuel utilisateur

Fanvil

Fanvil i20S IP DoorPhone Manuel utilisateur

Fanvil

Fanvil i12-02 Manuel utilisateur

Fanvil

Fanvil i23S Manuel utilisateur

Fanvil

Fanvil I20-T Manuel utilisateur

Fanvil

Fanvil i30 Manuel utilisateur

Fanvil

Fanvil i31S Manuel utilisateur

Fanvil

Fanvil i66 Manuel utilisateur

Fanvil

Fanvil i18 Manuel utilisateur

Fanvil

Fanvil i33V Manuel utilisateur

Fanvil

Fanvil i10 Manuel utilisateur

Fanvil

Fanvil i23 Manuel utilisateur

Fanvil

Fanvil i10V Guide d'installation et d'utilisation

Fanvil

Fanvil i16V Manuel utilisateur

Manuels Système d'interphone populaires d'autres marques

Bticino

Bticino LINEA 3000 Manuel utilisateur

MSI

MSI MSI-140 Manuel utilisateur

golmar

golmar Stadio Plus Manuel utilisateur

CyberData

CyberData 011211 series Manuel

Vidos

Vidos duo M1021 Manuel utilisateur

Vimar

Vimar ELVOX 7539/E Manuel utilisateur

SSS Siedle

SSS Siedle BTSV 850-03 Manuel utilisateur

Dahua

Dahua VTO Series Manuel utilisateur

Elvox

Elvox 5651 Manuel utilisateur

Videx

Videx VIDEOKIT Series Manuel utilisateur

Rocom

Rocom Doortello Business FW T2.05W2.04 Manuel utilisateur

Viking

Viking E-35-EWP Manuel utilisateur

Safeguard Supply

Safeguard Supply LRA-EX1000 Manuel utilisateur

SSS Siedle

SSS Siedle BFCV 850 Series Manuel utilisateur

GRD

GRD MAX V2 Manuel utilisateur

Alecto

Alecto ADI-250 Manuel utilisateur

Aiphone

Aiphone IE-8MD Manuel utilisateur

Perel

Perel EDB4 Manuel utilisateur

Fanvil i16S-02P Manuel utilisateur

Manuels Système d'interphone populaires d'autres marques