F&F BIS-411 Manuel utilisateur
- 1 -
BIS-411
Bistable relay
Electronic bistable pulse relay BIS-411 allows switching on or off
the lighting or other device from several different points by pa-
rallel connected, momentary (bell) control switches.
The receiver is switched on after a current pulse caused by pres-
sing any momentary (bell) button connected to the relay. After
the next pulse, the receiver will be switched off.
The relay does not have a „memory” of the contact position,
which means in the event of a power failure and its subsequ-
ent return, the relay contact will be set to „off”. This prevents
the controlled receivers from being switched on automatically
without supervision after a prolonged power failure.
Purpose
Functioning
F&F Filipowski sp. j.
Konstantynowska 79/81, 95-200 Pabianice, POLAND
phone/fax (+48 42) 215 23 83 / (+48 42) 227 09 71
www.fif.com.pl; e-mail: biuro@fif.com.pl
Do not dispose of this device in the trash along with other waste!
According to the Law on Waste, electro coming from households free of charge and can
give any amount to up to that end point of collec� on, as well as to store the occasion of
the purchase of new equipment (in accordance with the principle of old-for-new, regard-
less of brand). Electro thrown in the trash or abandoned in nature, pose a threat to the
environment and human health.
- 2 -
1.Disconnect the power supply.
2.Fix the relay on a rail in the control box.
3.Connect the power wires to terminals 1-3, any polarity for AC
voltage and for DC voltage: connect „+” to terminal 3, „–” to
terminal 1.
4.Momentary switches connected in parallel connect to terminal
6 and the wire, to which terminal 3 is connected.
5.Powered receiver connect in series to terminals 11-12.
Mounting
Wiring diagram
- 3 -
BIS-411 is not compatible with backlit buttons.
1-3 relay power supply 9÷30 V AC/DC
6 control input
10 output – break contact (passive)
11 input – power supply contact
12 output – closing contact (active)
- 4 -
power supply 9÷30 V AC/DC
contact separated 1×NO/NC
maximum load current (AC-1) 16 A
activation delay 0.1÷0.2 s
power indication green LED
signalling activation red LED
power consumption
standby 0.15 W
on 0.6 W
terminal 2.5 mm² screw terminals
tightening torque 0.4 Nm
working temperature -25÷50°C
dimensions 1 module (18 mm)
mounting on TH-35 rail
ingress protection IP20
Table for loads supplied with 230 V AC:
tungsten halogen fluorescent energy-saving LED
2000 W 1250 W 1000 W 500 W 250 W
The above data are indicative and will heavily depend on the
design of a specific receiver (that is especially important for
LED bulbs, energy-saving lamps, electronic transformers and
pulse power supply units), switching frequency and operating
conditions.
For more information visit: www.fif.com.pl.
Technical data
Power table
- 5 -
The F&F products are covered by a warranty of the 24 months
from the date of purchase. Effective only with proof of purchase.
Contact your dealer or directly with us.
F&F Filipowski sp. j. declares that the device is in conformity
with the essential requirements of The Low Voltage Directive
(LVD) 2014/35/EU and the Electromagnetic Compatibility (EMC)
Directive 2014/30/UE.
The CE Declaration of Conformity, along with the references to
the standards in relation to which conformity is declared, can be
found at www.fif.com.pl on the product page.
Warranty
CE declaration
E200409
Table des matières
Autres manuels F&F Relais
F&F
F&F BIS-409 Manuel utilisateur
F&F
F&F BIS-419-LED Manuel utilisateur
F&F
F&F SWITCH & ENERGY Wi-R1S1-P Manuel utilisateur
F&F
F&F BIS-411i Manuel utilisateur
F&F
F&F PCS-516UNI Manuel utilisateur
F&F
F&F 5908312592389 Manuel utilisateur
F&F
F&F MST-03 Manuel utilisateur
F&F
F&F PP-1Z-LED Pico Manuel utilisateur
F&F
F&F CP-721-FPV Manuel utilisateur
F&F
F&F BIS-413M Manuel utilisateur
F&F
F&F PZ-829 RC Manuel utilisateur
F&F
F&F BIS-410-LED Manuel utilisateur
F&F
F&F BIS-412M 24V Manuel utilisateur
F&F
F&F BIS-411 1R1Z Manuel utilisateur
F&F
F&F PCS-517.2 Manuel utilisateur
F&F
F&F BIS-411i Manuel utilisateur
F&F
F&F BIS-404 Manuel utilisateur
F&F
F&F BIS-408 Manuel utilisateur
F&F
F&F PCR-513 Manuel utilisateur
F&F
F&F PP-2Z Manuel utilisateur
