fThe rated speed of the grinding accessories
fThe outside diameter and the thickness of your
Incorrectly sized accessories can-
f
Accessories that do not
match the mounting hardware of the power tool
will run out of balance, vibrate excessively and may
f-
-
long, the mounted wheel may become loose and
f
wheels for chips and cracks, sanding drum
-
sory is dropped, inspect for damage or install
installing an accessory, position yourself and
accessory and run the power tool at maximum
Damaged acces-
f -
pending on application, use face shield, safe-
wear dust mask, hearing protectors, gloves
The eye pro-
f
f
only, when performing an operation where the
cutting accessory may contact hidden wiring or
Cutting accessory contacting a “live”
tool “live” and could give the operator an electric
f
The reaction torque of the
motor, as it accelerates to full speed, can cause the
fUse clamps to support workpiece whenever
hand and the tool in the other hand while in
such as dowel rods, pipes or tubing have a tenden-
cy to roll while being cut, and may cause the bit to
fPosition the cord clear of the spinning acces-
If you lose control, the cord may be cut or
snagged and your hand or arm may be pulled into
fNever lay the power tool down until the acces-
The spinning
accessory may grab the surface and pull the power
f-
ments, make sure the collet nut, chuck or any
other adjustment devices are securely tight-
Loose adjustment devices can unexpectedly
shift, causing loss of control, loose rotating com-
fDo not run the power tool while carrying it at
Accidental contact with the spinning
accessory could snag your clothing, pulling the ac-
fThe
motor’s fan will draw the dust inside the housing
and excessive accumulation of powdered metal
f
fDo not use accessories that require liquid cool-
-
KICKBACK AND RELATED WARNINGS
snagged rotating wheel, sanding band, brush or
-
es rapid stalling of the rotating accessory which
in turn causes the uncontrolled power tool to be
forced in the direction opposite of the accessory’s
that is entering into the pinch point can dig into
the surface of the material causing the wheel to
toward or away from the operator, depending on
direction of the wheel’s movement at the point
f-
-
fUse special care when working corners, sharp
-
Corners, sharp edges or bouncing have a
tendency to snag the rotating accessory and cause
f Such blades
English | 7
www.ffgroup-tools.com
SRT 180 EASY
