Extron electronics MTP 1500RL 15HD A SEQ Manuel utilisateur

MTP 1500RL 15HD A SEQ • Setup Guide

This guide provides basic instructions for an experienced installer to set up and operate the

Extron MTP 1500RL 15HD A SEQ twisted pair receiver.

For full details, see the MTP 1500RL 15HD A SEQ User Guide, available online at www.extron.com.

MTP 1500RL Series

POWER

12V

1.0A MAX

MTP 1500RL 15HD A SEQ

OUTPUT

MONO

AUDIO

RGB

PEAKING

LEVEL

DELAY

RED

GREEN

BLUE

SELECT

ADJUST MIN/MAX

INPUT BUFFERED OUTPUT

H +

V +

CSYNC

SOG

VIDEO

END

SPARE

MTP

Installation and Setup

Step 1 — Mounting

Turn off or disconnect all equipment power sources. Mount the MTP 1500RL 15HD A SEQ receiver as required.

Step 2 — Connect input

Connect the RJ-45 cable from an MTP transmitter to the Input port on the MTP 1500RL 15HD A SEQ receiver.

Terminate the cable as shown below right, using the same standard (A or B) at both ends.

Input

Source

MTP Tx

Device Display

MTP RL Rx

Device

Input

Source

MTP Tx

Device MTP 1500RL

15HD A Device Display

1500 feet (457 m) maximum

Transmission distance with one device before the MTP 1500RL 15HD A SEQ

Transmission distance with more than one device before the MTP 1500RL 15HD A SEQ

VGA

cable

VGA

cable

MTP 1500RL

15HD A Device

1500 feet (457 m) maximum

VGA

cable

VGA

cable

NOTE: The transmitter and receiver are designed for and perform best with Extron Enhanced Skew-Free™AV cable

terminated in accordance with the TIA/EIA T568A standard. CAT 5 cables are acceptable but less preferable.

Using preterminated and tested cables is also recommended. Cables terminated on site should be tested before

use to ensure that they comply with Category 5 speciﬁcations.

Step 3 — Connect outputs

Attach the applicable output cables (video, audio, and buffered output).

a. High resolution video output — Connect a display device to the 15-pin HD connector (RGB).

b. Audio connector —Connect an audio device to the 5-pole captive screw connector for mono audio output

MONO AUDIO

Unbalanced Output Balanced Output

Do not tin the wires!

Mono output 1-

Sleeve(s)

Mono output 1+

Mono output 2+

Mono output 2-

Sleeve(s)

Mono output 1

Mono output 2

NO GROUND.

CAUTION

For unbalanced audio, connect the sleeve(s) to the ground contact.

DO NOT connect the sleeve(s) to the negative (-) contacts.

c. Buffered output — Connect up to 5 daisy-chained MTP receivers to this RJ-45 connector.

CONTINUED ON SIDE 2

Pin T568A Wire

Color

T568B Wire

Color

1 White-green White-orange

2 Green Orange

3 White-orange White-green

4 Blue Blue

5 White-blue White-blue

6 Orange Green

7 White-brown White-brown

8 Brown Brown

RJ-45 Connector

12345678

Insert Twisted

Pair Wires

Pins:

MTP 1500RL 15HD A SEQ • Setup Guide (Continued)

Extron Headquarters

+800.633.9876 Inside USA/Canada Only

Extron USA - West Extron USA - East

+1.714.491.1500 +1.919.863.1794

+1.714.491.1517 FAX +1.919.863.1797 FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+4000.EXTRON

+4000.398766

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron

Middle East

+971.4.2991800

+971.4.2991880 FAX

Extron Korea

+82.2.3444.1571

+82.2.3444.1575 FAX

Extron India

1800.3070.3777

Inside India Only

+91-80-3055.3777

+91 80 3055 3737 FAX

Step 4 — Receiver DIP switches

zH sync (H+) and V sync (V+) switches — Set these switches up (On) for positive sync

or down (Off) for negative sync.

zComposite Sync, SOG, and Video switches — Set these switches as shown

in the table (see right) to output the indicated format.

zEnd Unit switch — Set this switch up if either of the following is true:

a. The receiver being conﬁgured is the only receiver connected to the transmitter.

b. The receiver being conﬁgured is the last receiver in a daisy-chained system.

Step 5 — Power

a. Plug the included 12 VDC power supply into the 2-pole

captive screw connector.

b. Wire the connector as shown at right.

Step 6 — Peaking and Level

Adjust image sharpness with the Peaking control. Increased peaking compensates for mid- and high-frequency detail loss.

The LED lights red when minimum (zero) and maximum peaking is reached.

Adjust image brightness using the Level control. View the image and adjust either control for the best

image quality.

Step 7 — Skew compensation

Pair skew can be measured with test equipment or by viewing a crosshatch test pattern. The SEQ receivers have built-in

skew compensation capabilities. Adjust the equalization as follows:

a. Set the skew delay to zero for red, green, and blue by pressing and holding the Select

button in for 3 seconds, using a Tweeker or small screwdriver. When the Red, Green, and

Blue LEDs all go out, release the Select button.

b. Use UTP cable test equipment or examine the displayed image to determine which video

signal — red, green, or blue — is shifted furthest to the left.

c. Adjust the furthest left video signal by using a Tweeker or screwdriver to press and release the Select button

until the LED for the left-shifted color lights.

d. Slowly rotate the Adjust control clockwise until the shifted color is properly aligned.

e. Repeat steps 7c and 7d to align the third color if needed.

68-1554-50 Rev. B

01 12

DELAY

RED

GREEN

BLUE

SELECT

ADJUST

RGB

PEAKING

LEVEL

MIN/MAX

Power Supply

Output Cord

SECTION A–A

Ridges

Smooth

Captive

Screw

Connector

Tie Wrap

16 (5 mm) Max.

MTP1500RL 15HD A SEQ

POWER

12V

0.5AMAX

OUTPUT

MONO

AUDIO

H+

V+

CSYNC

SOG

VIDEO

END

SPARE

INPUT BUFFEREDOUTPUT

MTP

MTP1500RL 15HD A SEQ

POWER

12V

0.5AMAX

OUTPUT

MONO

L R

AUDIO

H+

V+

CSYNC

SOG

VIDEO

END

SPARE

INPUT BUFFEREDOUTPUT

MTP

Flat Panel

Display

Flat Panel

Display

1,000' (305 m) UTP Cable

(CAT 5/5e/6)

Audio

AudioAudio

RGBHV

RGBHV500' (152 m) UTP Cable

(CAT 5/5e/6)

RGBHV

Extron

MTP 1500RL 15HD A SEQ

Extron

MTP T 15HD A

Extron

MTP 1500RL 15HD A SEQ

Figure 1. Example of a typical MTP 1500RL 15HD A SEQ application

H +

V +

CSYNC

SOG

VIDEO

END

SPARE

Format

Output

Format C Sync SOG Video

RGBHV

RGBS

RGsB

Component*

S-video*

Composite*

* Input video format must match.

Autres manuels pour MTP 1500RL 15HD A SEQ

Ce manuel convient aux modèles suivants

Autres manuels Extron electronics Récepteur

Extron electronics

Extron electronics MTP 1500RL 15HD A SEQ Manuel utilisateur

Extron electronics

Extron electronics MTP 15HD A Series Manuel utilisateur

Extron electronics

Extron electronics FOXBOX SR HDMI Manuel utilisateur

Extron electronics

Extron electronics Twisted Pair Transmitter TP T 15HD A Manuel utilisateur

Extron electronics

Extron electronics MTP 15HD RS Series Manuel utilisateur

Extron electronics

Extron electronics FOXBOX SR HDMI Manuel utilisateur

Extron electronics

Extron electronics HC 402 EU Manuel utilisateur

Extron electronics

Extron electronics VersaTools MTP T SV Manuel utilisateur

Extron electronics

Extron electronics MTP R 15HD RSA D Manuel utilisateur

Extron electronics

Extron electronics MTP U R A Manuel utilisateur

Extron electronics

Extron electronics XTP FT HD 4K Manuel utilisateur

Extron electronics

Extron electronics MTP/HDMI U R Manuel utilisateur

Extron electronics

Extron electronics MTP C7 T 15HD RS Manuel utilisateur

Extron electronics

Extron electronics MTP 15HD A Series Manuel utilisateur

Extron electronics

Extron electronics XTP SFR HD 4K Manuel utilisateur

Extron electronics

Extron electronics MTP R 15HD RSA D Manuel utilisateur

Extron electronics

Extron electronics Receivers TP Series Manuel utilisateur

Extron electronics

Extron electronics PowerCage FOX SR HDMI Manuel utilisateur

Extron electronics

Extron electronics XTP SR HDMI Manuel utilisateur

Extron electronics

Extron electronics XTP T HDMI Manuel utilisateur

Extron electronics

Extron electronics XTP SR HDMI Manuel utilisateur

Extron electronics

Extron electronics DDTX/DDRX DVI Manuel utilisateur

Extron electronics

Extron electronics Fiber Optic Transmitters-Receivers FOX 2G Rx... Manuel utilisateur

Extron electronics

Extron electronics Twisted Pair Transmitter VTT001 Manuel utilisateur

Manuels Récepteur populaires d'autres marques

Garmin

Garmin GA 23 Manuel utilisateur

Aiphone

Aiphone PS-12F Manuel utilisateur

IMES

IMES TCS-01CA-PMI Manuel utilisateur

BWI Eagle

BWI Eagle AIR-EAGLE SR Manuel

AMIMON

AMIMON AMN12310 WHDI Manuel utilisateur

Dual

Dual DMCPA79BT Mode d'emploi

Sound Associates

Sound Associates SA652P Manuel utilisateur

Sherwood

Sherwood NewCastle R-772 Manuel utilisateur

Audio

Audio A10-RX Series Manuel utilisateur

AllSee

AllSee PushShare PSRV1.1 Manuel utilisateur

DEMAG

DEMAG DRC-DR D2 Manuel utilisateur

Teleco

Teleco TVRCL868A02 Manuel utilisateur

Bosch

Bosch RF3222E Manuel utilisateur

Kramer

Kramer 631R Manuel utilisateur

Xpress

Xpress xmc10 Manuel utilisateur

JVC

JVC KD-MR1BTS Manuel utilisateur

Omega Engineering

Omega Engineering UWTC-REC3 Manuel utilisateur

e-survey

e-survey E300 Pro Manuel utilisateur