Extron electronics PC 101 Manuel utilisateur

PC 101 Power Controller • Setup Guide

The Extron PC 101 Power Controller provides remote power management for AV devices. When paired with an Extron controller

or control processor with relays, such as the MediaLink MLC 226 IP or the IP Link IPL 250, the PC 101 can be set up to power an

AV device on or off at scheduled times. It has a contact closure control input for remote control of a device and a tally port that

can be used for status feedback. Its power rating of 100-240 VAC, 50-60 Hz, provides worldwide compatibility. A front panel test

switch enables manual power cycling for setup and test purposes. This guide provides instructions for an experienced installer to

set up and connect a PC 101.

NOTE: For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics,

see the Extron Safety and Regulatory Compliance Guide at www.extron.com.

ATTENTION:

• Use electrostatic discharge precautions (be electrically grounded) when making connections. Electrostatic discharge

(ESD) can damage equipment, although you may not feel, see, or hear it.

• Prenez des précautions contre les décharges électrostatiques (soyez électriquement relié à la terre) lorsque vous

effectuez des connexions. Les décharges électrostatiques (ESD) peuvent endommager l’équipement, même si vous ne

pouvez pas le sentir, le voir ou l’entendre.

Rear Panel Features and Connections

EDD

CBB

TALLY

1+V

CONTACT

10A MAX

INPUT

OUTPUT

PC 101

BREAKER

100-240 ~ 50-60Hz 100-240 ~ 50-60Hz

Figure 1. PC 101 Rear Panel

ABreaker — 10 A rated circuit breaker. When an over

current condition occurs, the PC 101 stops outputting

AC current and ceases to function. Press this button

to manually reset the circuit breaker.

BInput — Power input with a 6-inch IEC cable

attached. Connects AC power to the PC 101.

COutput — Power output with a 24-inch (60 cm) IEC

cable attached. Connects power to an output device.

DOutput power LED — This green LED lights when

AC power is supplied to the Output connector. (The

front panel contains an output power LED which

performs the same function. Both LEDs reflect the

same status for the Output port.)

Make sure that the device being controlled can

support an AC power cycle.

ETally port — 2-pole captive screw port

that toggles between high and low states.

An LED indicator can be connected to

this port to show when the connected

device is receiving power from the PC 101.

• When the AC output is off, the tally

pin is in the high (oating) state.

• When AC power is present on the

output, tally pin 1 toggles to the low

(grounded) state.

FContact In port — 2-pole captive screw contact

closure input connector.

When pins 1 and G (ground) of this connector are

shorted together, the AC input passes power to the

output. If an LED is connected to the Tally port (E),

the LED lights when power is passed.

ATTENTION:

• No greater than 10 A of current should pass through the unit.

• Pas plus de 10A de courant ne devrait passer au travers de l’unité.

TALLY

1+V

Extron Headquarters

+800.633.9876 Inside USA/Canada Only

Extron USA - West Extron USA - East

+1.714.491.1500 +1.919.850.1000

+1.714.491.1517 FAX +1.919.850.1001 FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.299.1800

+971.4.299.1880 FAX

Extron Australia

+61.8.8113.6800

+61.8.8351.2511 FAX

Extron India

1800.3070.3777

(Inside India Only)

+91.80.3055.3777

+91.80.3055.3737 FAX

Installation Steps

1. (Optional) Mount the PC 101 to a rack shelf or furniture using mounting hardware such as an Extron under-desk mount kit.

2. Connect the male IEC connector on the 6-inch input cable (see ﬁgure 1, B, on the previous page) to a 100-240 VAC power

source, using a standard IEC power cord.

3. Connect the female IEC connector on the 24-inch output cable (C) to the device to be controlled. In many instances the

output cable can be plugged directly into the device being controlled. Alternatively, you can use the provided IEC adapter.

4. Connect a push button or control processor to the Contact In port (F) to enable the PC 101 to turn the Output connector

power on and off by contact closure. You can optionally monitor the status by connecting an LED from the +V (+5 volts) pin

to pin 1 of the Tally port (E).

CAUTION:

• When using the NEMA 5-15R receptacle adapter, connect the equipment only to a nominal 120 VAC source of supply.

• Replacement of fuses should be by service personnel only.

ATTENTION:

• Lorsque vous utilisez la prise de courant NEMA 5-15R, veillez à ne connecter le dispositif qu’à une source d’alimentation

nominale de 120 Vca.

• Le remplacement des fusibles doit être effectué uniquement par un technicien qualié.

Front Panel Features

BBC

OUTPUT POWER

TEST

POWER

CONTACT PC 101

Figure 2. PC 101 Front Panel

AInput Power LED — Lights when the unit is powered

on.

BContact LED — Lights when the Contact input port is

active.

CPower LED — Lights when AC power is being

supplied to the rear panel Output connector (same

function as the Cable Receptacle Power LED on the

rear panel).

DTest button — This button tests the power connection

to the output. Use a small screwdriver to press this

recessed button to enable AC power to pass to the

output. Power is off by default when AC power is first

applied to the PC 101. Subsequent presses of the

button toggle power to the output on and off.

EPower test LED — This LED is off by default when

AC power is applied to the unit. Thereafter, the LED

toggles on and off with each press of the Test button.

Application Diagram

INPUT

LAN

POWER

12V

500mA

MAX 123 4

COM3 IR

SG S G

TxRx 4

RELAY

COM1

TxRx

RTSCTS

COM2 IR

SGS G

TxRx 2

RELAY

TALLY

1+V

CONTACT

1 G

8A MAX

INPUT

OUTPUT

PC 101

BREAKER

100-240 ~ 50-60Hz 100-240 ~ 50-60Hz

Extron

To Display

Adapter

Flat Panel Display

Relay

Ethernet

Extron

IPL 250

IP Link Control

Processor

TCP/IP

Network

Extron

TLP 710TV

7" TouchLink

Touchpanel

Extron

PC 101

Power Controller

GlobalViewer

V Resource

Management and

Remote Control

pplication

Figure 3. PC 101 Application Using an IPL 250

NOTE: Use the provided IEC adapter if the PC 101

output cable cannot plug directly into the device to

be controlled.

68-2263-50 Rev. B

07 17

Autres manuels Extron electronics Contrôleurs

Extron electronics

Extron electronics MLC 206 Manuel de la liste des pièces

Extron electronics

Extron electronics CCI Pro 700 Manuel utilisateur

Extron electronics

Extron electronics RAC 104 Manuel utilisateur

Extron electronics

Extron electronics MLC 104 IP Plus Series Manuel utilisateur

Extron electronics

Extron electronics HD CTL 100 Manuel utilisateur

Extron electronics

Extron electronics VNM EC 201 Manuel utilisateur

Extron electronics

Extron electronics MediaLink MLC Plus 50 Manuel utilisateur

Extron electronics

Extron electronics MLC 62 IR D Manuel utilisateur

Extron electronics

Extron electronics CTR 8 Manuel utilisateur

Extron electronics

Extron electronics MEDIALINK MLC 52 Series Manuel utilisateur

Extron electronics

Extron electronics TLP Pro 720C Manuel utilisateur

Extron electronics

Extron electronics MediaLink MLC Plus 100 Manuel utilisateur

Extron electronics

Extron electronics MLC 104 IP PLUS Manuel utilisateur

Extron electronics

Extron electronics MediaLink MLC Plus 50 Manuel utilisateur

Extron electronics

Extron electronics MLC Plus 84 EU Manuel utilisateur

Extron electronics

Extron electronics MLC Plus 84 D Manuel utilisateur

Extron electronics

Extron electronics MLC 62 Series Manuel utilisateur

Extron electronics

Extron electronics MEDIALINK MLC 206 Manuel utilisateur

Extron electronics

Extron electronics FPC 6000 Manuel utilisateur

Extron electronics

Extron electronics IPA T RLY4 Manuel utilisateur

Extron electronics

Extron electronics Basic MediaLink Controllers MLC 52 RS Manuel utilisateur

Extron electronics

Extron electronics MEDIALINK MLC 206 Manuel utilisateur

Extron electronics

Extron electronics HD CTL 100 Manuel utilisateur

Extron electronics

Extron electronics MLC 60 Series Manuel utilisateur

Manuels Contrôleurs populaires d'autres marques

Digiplex

Digiplex DGP-848 Mode d'emploi

YASKAWA

YASKAWA SGM series Manuel utilisateur

Sinope

Sinope Calypso RM3500ZB Manuel utilisateur

Isimet

Isimet DLA Series Style 2 Manuel d'installation

LSIS

LSIS sv-ip5a Manuel utilisateur

Rockwell Automation

Rockwell Automation 1769-L31 Manuel utilisateur

Airflow

Airflow Uno hab Manuel utilisateur

ABB

ABB ACS580-01 drives Manuel utilisateur

Panasonic

Panasonic GM1 Series Manuel utilisateur

Emerson

Emerson SW93 Manuel utilisateur

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuel utilisateur

Panasonic

Panasonic FP? Positioning Unit RTEX Manuel utilisateur

Samson

Samson Type 5824 Manuel de service

Alpha IP

Alpha IP MIOB 21001 Manuel utilisateur

Siemens

Siemens OpenAir GMA 1 Series Manuel utilisateur

Surecom

Surecom SR-629 Manuel utilisateur

Fishman

Fishman TriplePlay Manuel utilisateur

Regulus

Regulus SRS1 T Manuel utilisateur