Extech Instruments TG20 Manuel utilisateur

User's Guide

Wire Tracer Probe and Transmitter

Model TG20

Shop for Extech products at: 1.877.766.5412

ShopExtech.ca

TG20-EU-EN-V1.0 03/12

Introduction

Congratulations on your purchase of Extech’s Model TG20. This tone generator and amplifier probe

set is used to quickly trace and identify cables or wires within a group and also check the operation of

phone lines. With proper use and care, this meter will provide many years of reliable service.

Meter Description

1. Modular connector

2. Test leads

3. Function LEDs

4. Power switch

5. Probe tip

6. Power/Sensitivity control

Operating Instructions

Note: To extend battery life, remember to turn off the probe and transmitter after tracing the cables

Self Check

1. Turn the probe on and set the transmitter to TONE.

2. The RED LED on both units will light up. Replace the batteries if they do not.

3. Touch the probe to the transmitter wires and check for the generated tone..

Cable/Wire tracing

CAUTION: Do not connect the transmitter to any wire or cable with an active circuit of more than

24VAC.

1. Connect the transmitter to the cable

a) For cables terminated at one end, connect the red alligator clip to a wire and the black

alligator clip to equipment ground

b) For un-terminated cables, connect the red alligator clip to one wire and the black alligator

clip to another wire.

c) For cables with modular connectors, insert the RJ11 plug directly into the connector.

2. Set the transmitter power switch to the TONE position. The red TONE LED will turn on.

3. On the probe, rotate the Power/Sensitivity control so that the POWER LED is on..

4. Hold the insulated probe tip against the wire in question to pick up the signal generated by the

transmitter.

5. Rotate the volume/sensitivity control on the probe for the appropriate level and sensitivity to

identify and trace the wire.

6. The tone will be the loudest on the wires connected to the tone generator.

Continuity testing

CAUTION: Disconnect power and loads from any circuits to be tested.

4. Connect the test leads to the wire under test.

5. Switch the transmitter to the CONTINUITY position.

6. The CONTINUITY LED will glow GREEN for if the resistance is less than 10,000 ohms. The

LED intensity will be very bright for very low resistances and will decrease in intensity as

resistance increases.

Shop for Extech products at: 1.877.766.5412

ShopExtech.ca

TG20-EU-EN-V1.0 03/12

Identifying telephone cable Tip and Ring – Using Alligator Clips

1. Switch the transmitter to the OFF position

2. Connect the BLACK clip to ground

3. Connect the RED clip to a line.

4. The LED color identifies the line.

5. GREEN indicates the Ring line, RED indicates the Tip line.

6. If both RED and GREEN light up, AC voltage is present (do not exceed 24V)

Identifying telephone cable Line Condition

1. Switch the transmitter to the OFF position

2. Plug the connector into the phone line or connect the RED clip to the RING line and the

BLACK clip to the TIP line.

3. The LED color identifies the line condition.

a. GREEN indicates a clear line.

b. RED indicates a busy line.

c. Green with a flashing RED indicates a ringing line.

Battery replacement

Open the battery cover and replace the battery as needed.

You, as the end user, are legally bound (Battery ordinance) to return all used batteries

and accumulators; disposal in the household garbage is prohibited!

You can hand over your used batteries / accumulators at collection points in your

community or wherever batteries / accumulators are sold!

Disposal: Follow the valid legal stipulations in respect of the disposal of the device at the

end of its lifecycle

Specifications

Power 9V battery (1 for transmitter and 1 for probe))

Dimensions Probe - 8.7x2x1.3" (220x50x32mm)

Transmitter - 2.6x2.7x1.1" (65x68x28mm)

Weight Probe 3.2oz (91g);

Transmitter3.2oz (91g)

www.extech.com

Shop for Extech products at: 1.877.766.5412

ShopExtech.ca

Table des matières

Autres manuels Extech Instruments Instrument de mesure

Extech Instruments

Extech Instruments 407740 Manuel utilisateur

Extech Instruments

Extech Instruments ET38 Manuel utilisateur

Extech Instruments

Extech Instruments ExStik PH100 Manuel utilisateur

Extech Instruments

Extech Instruments 45118 Manuel utilisateur

Extech Instruments

Extech Instruments SDL310 Manuel utilisateur

Extech Instruments

Extech Instruments MO230 Manuel utilisateur

Extech Instruments

Extech Instruments AN200 Manuel utilisateur

Extech Instruments

Extech Instruments 451104 Manuel utilisateur

Extech Instruments

Extech Instruments 461891 Manuel utilisateur

Extech Instruments

Extech Instruments 407780A Manuel utilisateur

Extech Instruments

Extech Instruments HD450 Manuel utilisateur

Extech Instruments

Extech Instruments LT40 Manuel utilisateur

Extech Instruments

Extech Instruments HDV7C-55-HD-1 Manuel utilisateur

Extech Instruments

Extech Instruments RPM33 Manuel utilisateur

Extech Instruments

Extech Instruments MA250 Manuel utilisateur

Extech Instruments

Extech Instruments CT-3060 Manuel utilisateur

Extech Instruments

Extech Instruments 451181 Manuel utilisateur

Extech Instruments

Extech Instruments MultiScope 381270 Manuel utilisateur

Extech Instruments

Extech Instruments 700 Series Manuel utilisateur

Extech Instruments

Extech Instruments UV510 Manuel utilisateur

Extech Instruments

Extech Instruments NON-DISPLAY PORTABLE Manuel utilisateur

Extech Instruments

Extech Instruments FM300 Manuel utilisateur

Extech Instruments

Extech Instruments 461880 Manuel utilisateur

Extech Instruments

Extech Instruments RH401 Manuel utilisateur

Manuels Instrument de mesure populaires d'autres marques

Suaoki

Suaoki D40 Manuel utilisateur

Elster

Elster BK-G1.6 Manuel utilisateur

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manuel

Duratool

Duratool D03128 Manuel utilisateur

Vega

Vega VEGAPULS 65 Manuel utilisateur

Tonghui

Tonghui TH2618B Manuel utilisateur

Tenmars

Tenmars TM-801 Manuel utilisateur

MSR

MSR 145 Manuel utilisateur

TPS

TPS WP-82 Manuel utilisateur

ELMETRON

ELMETRON CP-511 Manuel utilisateur

PCB Piezotronics

PCB Piezotronics 003C30 Manuel utilisateur

Tenma

Tenma 72-10465 Manuel utilisateur

Endress+Hauser

Endress+Hauser Proline Promag 50 Caractéristiques techniques

Siemens

Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces

KLINGER

KLINGER CMF V Series Manuel utilisateur

EXFO

EXFO FTB-2 Manuel d'exploitation et d'entretien

Keysight

Keysight M8290A Manuel utilisateur

ADTEK

ADTEK MW-5 Manuel utilisateur