Extech Instruments 461995 Manuel utilisateur

User's Manual

Model 461995

Laser Photo / Contact Tachometer

Laser

Photo/ Contact

PHOTO CONTACT

min

f t

min

rpm

MEMORY

46 19 95

Tachometer

www.GlobalTestSupply.com

Find Quality Products Online at: sales@GlobalTestSupply.com

461995-EU-EN v1.5 07/13 2

Introduction

Congratulations on your purchase of Extech's Laser Photo/Contact Tachometer, Model 461995.

This Tachometer provides contact/non-contact RPM and Linear Surface Speed measurements. The

laser pointer beam provides accurate long distance measurements for photo tachometer

measurements. This meter, with proper care, will provide years of safe reliable service.

Safety

1. Use extreme caution when the laser beam is on

2. Do not point the beam toward anyone's eye

3. Be careful not to let the beam strike the eye from a reflective surface

4. Do not use the laser near explosive gases or in other potentially explosive areas

www.GlobalTestSupply.com

Find Quality Products Online at: sales@GlobalTestSupply.com

461995-EU-EN v1.5 07/13 3

Meter Description

1. Photo Tachometer sensor and laser source

2. LCD display

3. MEMORY button

4. Function switch

5. Contact tachometer rotating ring

6. MEASURE button

7. Battery compartment (rear)

www.GlobalTestSupply.com

Find Quality Products Online at: sales@GlobalTestSupply.com

461995-EU-EN v1.5 07/13 4

Meter Operation

Reversible LCD Display

The 461995 LCD display indicates Photo Tachometer measurements in one direction and Contact

measurements in the opposite direction. This permits the user to easily read the measurement digits

in both measurement modes with the meter held in either direction.

Photo Tachometer Measurements (refer to diagram below)

1. Apply an appropriately sized square piece of reflective tape to the surface of the object under

test.

2. Move the Function switch to the PHOTO position.

3. Point the laser pointer end of the meter toward the device under test at a distance of 2" to 79"

(50 to 2000mm).

4. Press the Measure button (located on the right side of the meter) and align the laser pointer

beam with the reflective tape.

5. Verify that the Monitor Indicator appears on the upper left hand section of the LCD when the

object under test passes through the light beam.

6. Release the Measure button when the RPM reading stabilizes on the LCD.

7. If the rpm is under 50, apply additional squares of reflective tape. Divide the reading shown on

the display by the number of pieces of reflective tape squares to calculate the actual rpm.

NOTE: Bright ambient light may interfere with the reflected light beam. Shading the target area may

be necessary in some cases.

CAUTION: Rotating objects can be dangerous. Use extreme care.

Photo Tachometer

Rotating object

Reflective tape

Light source

and reflection

www.GlobalTestSupply.com

Find Quality Products Online at: sales@GlobalTestSupply.com

461995-EU-EN v1.5 07/13 5

Contact Tachometer RPM Measurements

1. Move the Function switch to the CONTACT position.

2. Press the Measure button while lightly pressing the rotating ring against the center opening

of a rotating shaft.

3. Release the Measure button when the display stabilizes (approx. 2 seconds).

Linear Surface Speed (ft/min or m/min) Measurements

1. Slide the Function Switch to "SURFACE SPEED ft/min" or "m/min" position.

2. Install the surface speed attachment on the meter rotating ring.

3. Press the Measure button and hold the surface speed wheel against the device being

measured.

4. Release the Measure button when the display stabilizes (approx. 2 seconds).

MIN/MAX and Last Reading Memory Recall

The 461995 can record Maximum, Minimum, and Last Reading for the period of time the Measure

button is held. These stored values can then be read directly on the meter's display. The memory

will automatically clear after approximately 10 seconds of meter inactivity. Access the memory data

immediately after the measurements have been taken as follows:

1. Press the Memory key once and hold it down: The Last Reading is displayed followed by the

"LA" icon.

2. Press again and hold: The Maximum value is displayed followed by the "UP" icon

3. Press again and hold: The Minimum value is displayed followed by the "dn" icon

Battery Replacement

The low battery indication appears as "LO" on the display. To replace the batteries, slide the rear

battery compartment cover off of the meter, replace the four 1.5V AA batteries, and replace cover.

You, as the end user, are legally bound (EU Battery ordinance) to return all used

batteries, disposal in the household garbage is prohibited! You can hand over your

used batteries / accumulators at collection points in your community or wherever batteries

/ accumulators are sold!

Disposal: Follow the valid legal stipulations in respect of the disposal of the device at the

end of its lifecycle

www.GlobalTestSupply.com

Find Quality Products Online at: sales@GlobalTestSupply.com

461995-EU-EN v1.5 07/13 6

Specifications

General Specifications

Circuit Custom one-chip LSI microprocessor circuit

Time base Quartz crystal 4.194 MHz

Display Reversible 5 digit 0. 10mm (4") LCD display

Laser light source Less than 1mW; Class 2 red laser diode (645nm approx.)

Detecting Distance 50 to 2000 mm (2 to 79") depending on ambient light and RPM

Memory Last reading and MIN/MAX readings

Operating Conditions 0 °C to 50 °C (32 °F to 122 °F); RH 80% Max

Power Supply 4 x 1.5 V AA batteries

Power Consumption 20mA DC approx.

Weight 300g (10.6oz) including battery)

Size 210 x 67 x 38 mm (8.5 x 2.6 x 1.5")

Accessories (4) x 1.5V batteries, reflective tape 600mm (24"), surface

speed/rpm rotating attachments, and carrying case

Range Specifications

Range Resolution Accuracy (%rdg)

Photo

Tachometer

10 to 99,999 rpm 0.1 rpm (<1000rpm)

1 rpm (>1000 rpm)

± (0.05% + 1d)

Contact

Tachometer

0.5 to 19,999 rpm 0.1 rpm (<1000rpm)

1 rpm (>1000 rpm)

Surface

Speed

0.2 to 6560 ft/min 0.1 ft/min (<1000ft/min)

1 ft/min (>1000ft/min)

± (1% + 1d)

Surface

Speed

0.05 to 1999.9 m/min 0.01 m/min (<100m/min)

0.1 m/min (>100 m/min)

ISO 9001 Certified

www.GlobalTestSupply.com

Find Quality Products Online at: sales@GlobalTestSupply.com

Table des matières

Autres manuels Extech Instruments Instrument de mesure

Extech Instruments

Extech Instruments 480846 Manuel utilisateur

Extech Instruments

Extech Instruments CO80 Manuel utilisateur

Extech Instruments

Extech Instruments MO57 Manuel utilisateur

Extech Instruments

Extech Instruments PH90 Manuel utilisateur

Extech Instruments

Extech Instruments Oyster-10 Manuel utilisateur

Extech Instruments

Extech Instruments RH300 Manuel utilisateur

Extech Instruments

Extech Instruments SDL600-NIST Manuel utilisateur

Extech Instruments

Extech Instruments MA145 Manuel utilisateur

Extech Instruments

Extech Instruments 461920 Manuel utilisateur

Extech Instruments

Extech Instruments PH220 Manuel utilisateur

Extech Instruments

Extech Instruments UV510-NIST Manuel utilisateur

Extech Instruments

Extech Instruments MO290-NISTL Manuel utilisateur

Extech Instruments

Extech Instruments 381235 Manuel utilisateur

Extech Instruments

Extech Instruments DT40M Manuel utilisateur

Extech Instruments

Extech Instruments UV510 Manuel utilisateur

Extech Instruments

Extech Instruments MO500 Manuel utilisateur

Extech Instruments

Extech Instruments VT30-E Manuel utilisateur

Extech Instruments

Extech Instruments 382095 Manuel utilisateur

Extech Instruments

Extech Instruments 407123 Manuel utilisateur

Extech Instruments

Extech Instruments 407355 Manuel utilisateur

Extech Instruments

Extech Instruments 382152 Manuel utilisateur

Extech Instruments

Extech Instruments EasyView EA31 Manuel utilisateur

Extech Instruments

Extech Instruments 401027 Manuel utilisateur

Extech Instruments

Extech Instruments Extech 380976 Manuel utilisateur

Manuels Instrument de mesure populaires d'autres marques

Suaoki

Suaoki D40 Manuel utilisateur

Elster

Elster BK-G1.6 Manuel utilisateur

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manuel

Duratool

Duratool D03128 Manuel utilisateur

Vega

Vega VEGAPULS 65 Manuel utilisateur

Tonghui

Tonghui TH2618B Manuel utilisateur

Tenmars

Tenmars TM-801 Manuel utilisateur

MSR

MSR 145 Manuel utilisateur

TPS

TPS WP-82 Manuel utilisateur

ELMETRON

ELMETRON CP-511 Manuel utilisateur

PCB Piezotronics

PCB Piezotronics 003C30 Manuel utilisateur

Tenma

Tenma 72-10465 Manuel utilisateur

Endress+Hauser

Endress+Hauser Proline Promag 50 Caractéristiques techniques

Siemens

Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces

KLINGER

KLINGER CMF V Series Manuel utilisateur

EXFO

EXFO FTB-2 Manuel d'exploitation et d'entretien

Keysight

Keysight M8290A Manuel utilisateur

ADTEK

ADTEK MW-5 Manuel utilisateur