Announcement
TheinformationinthismanualrepresentsnopromiseorguaranteebyEVOC.EVOC
reserves the right to make changes to the manual, without prior notice to customer.
EVOC will notbe held liable for any direct,indirect, intended or unintended losses
and/orhiddendangersduetoinstallationorimproperoperation.
EVOC is a registered trademark of EVOC Intelligent Technology Co., Ltd. All
trademarks,registeredtrademarks,andtradenamesusedinthisUser’sGuidearethe
propertyoftheirrespectiveowners.
EVOCIntelligentTechnologyCo.,Ltd.©2008,CopyrightReserved.Nopartofthis
manual may be reproduced in any form or by any means, electronic or mechanical,
withoutpermissioninwritingfromEVOC.
SafetyInstructions
1. Pleasereadtheuser'smanualcarefullybeforeusingtheproduct.
2. Before inserting, removing or reconfiguring motherboard or expansion card,
firstdisconnectthecomputerandperipheralsfrom theirpowersources;
3. Before removing boards or computer, first turn off all power resources and
disconnectthepowercordfrompowersource;
4. Forwholeset,wheninsertingorremovingboards,firstdisconnectthecomputer
andperipheralsfromtheirpowersources;
5. Before you connect or unplug any signal cable, make sure all power cords are
unpluggedinadvance;
6. Toavoidpoweron/offcomputerfrequently,waitatleast30secondsafterturning
offthecomputerbeforereturningonthecomputer.
7. Staticelectricitycanharmsystemboards.PerformserviceatanESDworkstation
andfollowproperESDproceduretoreducetheriskofdamagetocomponents;
8. If there's no ESD workstation, You can take the following steps to prevent
damagefromelectrostaticdischarge(ESD):
a) Weara groundedwriststrapagainstyour skinto eliminate staticon your
body;
b) Always touch the metal chassis or frame before you touch any
componentsinthechassis;
c) Keep partof yourbodyincontact withthemetalchassisto dissipatethe
staticchargewhilehandlingcomponents;
d) Avoidallunnecessarymovement;
e) Handlecomponentsandboardswithcare.Don’ttouchthecomponentsor
contacts on a board. Hold a boardby its edges or by its metal mounting
bracket;
f) Placethecomponentsonagrounded,staticfreesurface.Useaconductive
foampadifavailablebutnotthecomponentwrapper.
g) Donotletthecomponentsslideontheoperatingplatform.
9. Usecrossheadscrewdrivertooperate.Amagneticscrewdriverisrecommended
(magnettocollectscrews).Donot leaveanytoolsorscrewsinsidethechassis;
10. Assureabundantcoolingandstreamlineventilation.
