EtherWAN EX33000 Series Manuel utilisateur

W70G-NX33000Q2 Page 1

Installation Guide

EX33000 Series | Industrial Unmanaged Switch

1Unpacking

Open the carton and unpack the items. Your package

should include:

▪One EX33000 Switch

▪DIN rail mounting kit

If any items are missing or damaged, notify your

EtherWAN representative. If possible, save the carton

and packing material in case you need to ship or store

the switch in the future.

2Equipment Needed

▪Category 5 or better cable for RJ-45 ports

▪Appropriate fiber cable for fiber ports

3Select a Location

▪Installation: DIN rail. Place the device on the DIN

rail from above using the slot. Push the front of

the device toward the mounting surface until it

audibly snaps into place.

▪Choose a dry area with ambient temperature

between -10°C to +60°C (14°F to 140°F).

▪Keep away from heat sources, sunlight, warm air

exhausts, hot-air vents, and heaters.

▪Be sure there is adequate airflow.

▪This device has been evaluated for conformity for

use in a business environment. If used in a home

environment, there is a danger of interference.

4Connect to the Data Ports

Depending on the model, your switch can have the

following ports:

▪16 10/100Base-TX Ports

▪15 100Base-FX Port + 1 100BASE-FX port

▪14 100Base-FX Port + 2 100BASE-FX ports

5Connect Power

The switch has two pairs of power inputs:

▪A 12-48VDC terminal block

▪A 12VDC jack

Only one power input is required to operate the

switch. However, redundant power supply

functionality is supported.

Terminal Block

The switch provides two power inputs on a 12-48VDC

terminal block. The terminal block has 5 terminal

posts.

Description

Power 2

12-48VDC

−

Power Ground

Power 1

12-48VDC

−

Power Ground

Earth Ground

Relay Output

Rating

1A @ 24VDC

DC Jack

Description

Power 3

12VDC

Power Failure Alarm

A 2-pin terminal block is provided for power failure

detection. Do not connect a power source to these

pins.

The relay contact closes if:

▪Power 1 and Power 2 are both failed, but Power 3

is ON.

▪Power 3 is failed, but Power 1 and Power 2 are

both ON.

Power-Up Sequence

When the switch is powered up:

▪All Link/ACT LEDs blink momentarily.

▪The Power LED lights up and stays lit.

▪LEDs for every port connected to a device will

flash, as the switch conducts a brief Power On Self-

Test (POST).

W70G-NX33000Q2 Page 2

Installation Guide

EX33000 Series | Industrial Unmanaged Switch

6LED Indicators

LED

State

Indication

10/100Base-TX, 100Base-FX

LINK/ACT

Steady

Network connection

established

Flashing

Transmitting or receiving data

7DIN Rail Installation

DIN-Rail Assembly Startup, and Dismantling

▪Assembly: Place the Switch on the DIN rail from

above using the slot. Push the front of the Switch

toward the mounting surface until it audibly snaps

into place.

▪Startup: Connect the supply voltage to start up the

Switch via the terminal block.

▪Dismantling: Pull out the lower edge and then

remove the Switch from the DIN rail.

Manufacturer information:

EtherWAN Systems, Inc.

33F, No. 93, Sec. 1, Xintai 5th Rd., Xizhi Dist., New

Taipei City, 221 Taiwan

The full product manual can be downloaded from:

www.etherwan.com

Autres manuels EtherWAN Changer

EtherWAN

EtherWAN EX73900X Series Manuel utilisateur

EtherWAN

EtherWAN EX78000 Series Manuel utilisateur

EtherWAN

EtherWAN L-EX17008A Manuel utilisateur

EtherWAN

EtherWAN EX38000 Series Manuel utilisateur

EtherWAN

EtherWAN EX17908A Manuel utilisateur

EtherWAN

EtherWAN EX87000 Series Manuel utilisateur

EtherWAN

EtherWAN EX77000 Series Manuel utilisateur

EtherWAN

EtherWAN EX34000 Manuel utilisateur

EtherWAN

EtherWAN EX42395BT Manuel utilisateur

EtherWAN

EtherWAN EX26262F Series Manuel utilisateur

EtherWAN

EtherWAN InfraGreEn IG5 Manuel utilisateur

EtherWAN

EtherWAN EX26484 Series Manuel utilisateur

EtherWAN

EtherWAN EX17908 Series Manuel utilisateur

EtherWAN

EtherWAN EX17016 Manuel utilisateur

EtherWAN

EtherWAN EG97023 Series Manuel utilisateur

EtherWAN

EtherWAN EX70900 Manuel utilisateur

EtherWAN

EtherWAN EX78900X Series Manuel utilisateur

EtherWAN

EtherWAN TG103H Manuel utilisateur

EtherWAN

EtherWAN EX33000 Series Manuel utilisateur

EtherWAN

EtherWAN EX78162 Series Manuel utilisateur

EtherWAN

EtherWAN EX32908 series Manuel utilisateur

EtherWAN

EtherWAN EX19164A Manuel utilisateur

EtherWAN

EtherWAN EX42914 Series Manuel utilisateur

EtherWAN

EtherWAN EG99000 Series Manuel utilisateur

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur