EtherWAN EX34000 Manuel utilisateur

Hardened PoE Ethernet Switch

This quick start guide describes how to install and use the Hardened PoE Ethernet Switch. Capable of operating at temperature extremes of

-10°C to +60°C, this is the switch of choice for harsh environments constrained by space.

Physical Description

The Terminal Block and Power inputs

Power Input Assignment

Power3 48VDC DC Jack

＋48VDC

Power2 －Power Ground

＋48VDC

Power1 －Power Ground

Earth Ground

Terminal Block

Relay Alarm Assignment

FAULT

*Relay warning signal disable for following:

1. The relay contact closes if Power1 and

Power2 are both failed but Power3 on.

2. The relay contact closes if Power3 is failed

but Power1 and Power2 are both on.

DC Terminal Block Power Inputs: There are two pairs of power inputs can be used to power up this switch. Redundant power supplies function is

supported.

The 10/100Base-TX and 100Base-FX Connectors

The 10/100Base-TX Connections

The following lists the pinouts of 10/100Base-TX ports.

Pin Regular Ports Uplink port

1 Output Transmit Data + Input Receive Data +

2 Output Transmit Data - Input Receive Data -

3 Input Receive Data + Output Transmit Data +

4 NC NC

5 NC NC

6 Input Receive Data - Output Transmit Data -

7 NC NC

8 NC NC

The 100Base-FX Connections

The fiber port pinouts

The Tx (transmit) port of device I is connected to the Rx (receive) port of device II, and the Rx (receive) port of

device I to the Tx (transmit) port of device II.

The WDM 100Base-FX Connections

The fiber port pinouts

Only one single-mode optical fiber is required to transmit and receive data.

Hardened PoE Ethernet Switch

The Port Status LEDs

LED State Indication

10/100Base-TX, 100Base-FX

Steady A valid network connection established.

Link/ACT

(Green) Flashing Transmitting or receiving data.

ACT stands for ACTIVITY.

Functional Description

•Meets IEC61000-6-2 EMC Generic Standard Immunity for industrial environment.

•Supports IEEE802.3af Power over Ethernet (PoE) Power Sourcing Equipment (PSE).

•Supports IEEE802.3/802.3u/802.3x. Auto-negotiation: 10/100Mbps, Full/Half-duplex, Auto-Negotiation, Auto MDI/MDIX.

•100Base-FX: Multi/Single mode SC or ST type, WDM Single mode SC type.

•Supports 1024 MAC addresses. Provides 1M bits buffer memory.

•Alarms for power and port link failure by relay output.

•Power Supplies: Redundant 48VDC Terminal Block power inputs and 48VDC DC JACK with 100-240VAC external power

supply.

•Operating voltage and Max. current consumption: 1.5A @ 48VDC. Power consumption: 72W Max.

•Operating temperature ranges from -10℃to 60℃.

•Supports DIN-Rail, Panel, or Rack Mounting installation.

Assembly, Startup, and Dismantling

•Assembly: Place the switch on the DIN rail from above using the slot. Push the front of the switch toward the mounting

surface until it audibly snaps into place.

•Startup: Connect the supply voltage to start up the switch via the terminal block (or DC JACK).

•Dismantling: Pull out the lower edge and then remove the switch from the DIN rail.

Autres manuels pour EX34000

Autres manuels EtherWAN Changer

EtherWAN

EtherWAN EX19162 Manuel utilisateur

EtherWAN

EtherWAN EX87000 Series Manuel utilisateur

EtherWAN

EtherWAN EX63000 Series | Manuel utilisateur

EtherWAN

EtherWAN EX17162 Manuel utilisateur

EtherWAN

EtherWAN EX78900X Series Manuel utilisateur

EtherWAN

EtherWAN EX17082 Manuel utilisateur

EtherWAN

EtherWAN EX33000 Series Manuel utilisateur

EtherWAN

EtherWAN EX38000 Series Manuel utilisateur

EtherWAN

EtherWAN EX33000 Series Manuel utilisateur

EtherWAN

EtherWAN EX61000A Manuel utilisateur

EtherWAN

EtherWAN EX83304 Series Manuel utilisateur

EtherWAN

EtherWAN EG97000 Series Manuel utilisateur

EtherWAN

EtherWAN EX77900 Series Manuel utilisateur

EtherWAN

EtherWAN EX46900A Series Manuel utilisateur

EtherWAN

EtherWAN EX75900 Series Manuel utilisateur

EtherWAN

EtherWAN EX89000 Manuel utilisateur

EtherWAN

EtherWAN EX78900X Series Manuel utilisateur

EtherWAN

EtherWAN EX19164 Manuel utilisateur

EtherWAN

EtherWAN EX78000 Series Manuel utilisateur

EtherWAN

EtherWAN EX78000R Manuel utilisateur

EtherWAN

EtherWAN EX77000 Series Manuel utilisateur

EtherWAN

EtherWAN EX27000 Series Manuel utilisateur

EtherWAN

EtherWAN EX29000 Manuel utilisateur

EtherWAN

EtherWAN EX25611 Manuel utilisateur

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur