ESI AA330 Manuel utilisateur
INSTALLATION AND USE
AA330
ARTICULATING KEYBOARD ARM
AA330 Rev A 4/17
Model AA330
AA330 ARTICULATING KEYBOARD ARM
PLEASE REVIEW these instructions before beginning the installation. Check that
all parts needed were provided with your order. Contact your supplier if any
operates to your satisfaction.
PARTS PROVIDED
Articulating Arm (1)
Front Stopper (1) 5
/8" Wood Screws (9) 1" Wood Screws (9)
Track (1)
STEP 1: Adhere Track
•
Peel the backing from the adhesive
strips on top of the track.
•
Adhere the track to the
underside
of the work
—
Position the front edge
of the track 1
/4" from the
front edge of the work
surface. The front of the
track is the end with
three holes.
•
Rear
Stop
Peel Off
Backing
Press
Firmly
1
/4"
surface.
2
CAUTION: This install requires a power drill. This is not a hand tool install.
ADDITIONAL TOOLS REQUIRED
• #2 Phillips Screw Driver Bit
• " Drill Bit
• Drill (For Track Installation Only)
1
/8
AA330 ARTICULATING KEYBOARD ARM
STEP 2: Attach Track
• Drill 1
/8" pilot holes through all
nine holes in the track.
— Drill the holes 5/8" deep or 1"
deep, depending on which
wood screws will be used. (A
minimum work surface thickness
of 11
/2" is recommended for the
1" screws.)
CAUTION: Be careful not to drill through the
work surface.
• Attach the track with screws through the six rear
holes only, as shown.
STEP 3: Install Articulating Arm
• Slide the articulating arm onto
the track. Position it back far
enough so that you have access
to the front three holes on the
track.
STEP 4: Attach Front Stop
• Position the front stop onto the
front of the track and secure it
Attach Through Rear
Six Holes Only
Slide Back
Front
Stop
3
© 2017 ESI Ergonomic Solutions. All rights reserved. AA330 Rev A 4/17
AA330 ARTICULATING KEYBOARD ARM
800.833.3746 esiergo.com
OPERATION
To Raise or Lower:
• Tip the platform up to unlock.
• Move the arm to the desired height.
• Release the platform to lock it in place.
To Set Tilt Angle:
• Unlock the quick release handle on the right side of the arm.
• Adjust the tilt angle to the desired position.
• Lock the quick release knob.
Table des matières
Autres manuels ESI Support et étagère
ESI
ESI AA780DAT Manuel utilisateur
ESI
ESI AA100 Guide de démarrage rapide
ESI
ESI Kata2-MS Series Manuel utilisateur
ESI
ESI EPPA2-KIT Manuel utilisateur
ESI
ESI AA355DS Manuel utilisateur
ESI
ESI E-AMT Manuel utilisateur
ESI
ESI LIFT ERGORISE Manuel utilisateur
ESI
ESI EVOLVE Series Manuel utilisateur
ESI
ESI EVOLVE Series Instructions d'installation
ESI
ESI Kata EX2-MS Series Manuel utilisateur
Manuels Support et étagère populaires d'autres marques
Salamander
Salamander Acadia AC/W/L400/WH Manuel utilisateur
Fohhn
Fohhn VAT-09 Guide de l'utilisateur
ricoo
ricoo FS0522 Manuel utilisateur
AMSOIL
AMSOIL BMK-22 Guide rapide
Kargo Master
Kargo Master 48220 Manuel utilisateur
Milestone AV Technologies
Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur
