Escape MARS MULTI-ACTIVITY Manuel utilisateur
MARS MULTI-ACTIVITY
RESOURCE STATION.
USER MANUAL.
ESCAPE FITNESS MARS USER MANUAL | MAY 2022
ESCAPE FITNESS MARS USER MANUAL | MAY 2022
CONTENTS.
04 SAFETY.
05 MOUNTING.
07 INTRODUCTION.
08 BASIC OPERATION.
10 MARS SCREEN OPERATION.
14 SPECIFICATIONS.
16 TROUBLESHOOTING.
APPENDIX 1 WALL MOUNTING INSTRUCTIONS.
APPENDIX 2 RACK5 MOUNTING INSTRUCTIONS.
APPENDIX 3 OCTAGON MOUNTING INSTRUCTIONS.
ESCAPE FITNESS MARS USER MANUAL | MAY 2022
SAFETY.
For your safety, please read the following instruction before you use the product. Serious injury or property loss may be caused by improper operations. Do not try to
repair or modify the product.
WARNING.
Ensure that the mains electricity supply includes an earth connection.
Ensure that, if the MARS screen is mounted on a RACK5 or Octagon that it is done so in line with the installation instructions for the particular mount used.
Disconnect the product from power supply immediately if major failures occurs such as Smoke, peculiar smell or abnormal sound is discharged from the product or in
the unlikely event that you experience an electric shock from the equipment.
If you are unable to get the system started and it is unable to display any activity on the screen then please ensure that the Mars screen has been attached to mains
power. Please follow the quick start guide instructions at escapetness.com/user-guides/mars-screen or follow the link in the QR code attached to the front of the screen..
Do not drop liquid, conductive or any foreign material into the product. Power off immediately if this occurs and contact qualied staff for solutions.
Do not cover up any ventilation holes. Overheated components can cause re, damage the product or shorten the service life.
Do not damage, change, wind, bend heat or drag the power cable forcibly. Do not put weights (such as the product itself) on the power cable. Do not drag the cable forcibly
when you pull out the power plug. If the power cable is damaged, please contact your local distributor to repair or replace it. The power cable should be attached so that it
is not pulled tight against the mains cable cover under any circumstances. Do not touch the power cable with wet hands this might cause an electric shock.
Make sure that the MARS screen is mounted securely, either using a 3rd party wall mount on a wall known to be substantial enough for the weight of the screen or on a
RACK5 or Octagon using the approved mounts.
Do not open the cover or change the product. High voltage components are installed in the product that can be dangerous even when the screen is turned off. It is
dangerous to open the cover and electric shock or other dangerous situations may occur. The product is not serviceable by the user and if a fault develops the screen
should be returned to the supplier.
If you need to move the screen it should be unmounted and move carefully before re-mounting. All connections should be removed before attempting to move
the screen.
ESCAPE FITNESS MARS USER MANUAL | MAY 2022
SAFETY.
Treat the screen with care. Do not put items on top of the product. Specically avoid containers with liquid, Do not tread on the product or hang any products on the
screen. If exercising in from of the product, make sure that the screen cannot be damaged by either hitting it with a part of the body or with any exercise equipment.
Do not install the screen in an unsuitable location. Do not install the product in humid places such as a bathroom, shower room or indoor areas susceptible to moisture
and damp. Do not use the product outside when it might experience rain, snow or other harsh weather. The preceding environments may cause faults or electric shock
under extreme conditions. Do not put as source of re such as an ignited candle on the product.
Ensure that the product is disconnected from the mains power and network during thunderstorms. This is to avoid possible electric shock or damage to internal
components.
Do not install the product in high temperature areas. Do not install next to a radiator or other heating devices. Do not expose the product to sunlight that might
cause high temperature.
For transport, pack the product in the cartons and cushioning material provided with the product.
Transport the product securely but vertically. The screen or other components are easily broken if the product is moved in an improper way.
The product design to prevent radio interference complies with the international EMI standard. However, the interference still exists and causes noise in the radio.
• If noise occurs in the radio, try the following solutions.
• Adjust the direction of the radio antenna to avoid the interference from the product
• Keep the radio away from the product.
Advice for watching:
When you are watching, the optimum distance is between 3 to 7 times the height of the screen. Ensure that you observe the exercises on the screen and then move to a
safe distance to do them.
ESCAPE FITNESS MARS USER MANUAL | MAY 2022
MOUNTING.
There are four recommended ways to mount the MARS screen. These are:-
• Wall mounted using a 3rd party wall bracket suitable for screens of 12kg or more with VESA mount holes of 100x100 or 200x200mm
• Mounted on an Escape Fitness RACK5
• Mounted on an Escape Fitness Octagon Frame leg
• Mounted on an Escape Fitness Octagon Frame beam
If mounting using any of these options it is important to follow the specic installation instructions. Of particular importance is:-
• For mounting on a wall, ensure that the preceding safety section is followed and, ensure that the wall is tested to ensure that there are no cables or pipes located
in the wall that may become damaged when drilling and tting the wall plugs and screws. Follow the manufacturer of the screen mount’s guidelines.
• When mounting onto Escape Fitness equipment, it is important to follow the appropriate installation guides. Particular attention needs to be paid to how the nylon
insulated spacers are installed between the MARS screen and RACK5 or Octagon so that they are electrically insulated from each other.
ESCAPE FITNESS MARS USER MANUAL | MAY 2022
MOUNTING.
When wall mounting, it is important that the MARS screen is well ventilated. It should, for example, not be installed inside a un-vented cupboard.
06
|
ESCAPE FITNESS MARS USER MANUAL | MAY 2019 V10
MOUNTING.
When wall mounting, it is important that the MARS screen is well ventilated. It should, for example, not be installed inside a un-vented cupboard.
When the MARS screen is installed on a wall, the screws and wall plugs supplied should be used.
Self-adhesive clips are provided as part of the mounting kits so that cables can be routed so to avoid causing a trip hazard. Please see the diagram below noting
that the cable is routed at the rear of the RACK5.
Ventilation distance to the front and back
surface should be over 20cm
Ventilation distance to the right, left, top
and bottom surface should be over 10cm
When the MARS screen is installed on a wall, the screws and wall plugs supplied should be used.
Self-adhesive clips are provided as part of the mounting kits so that cables can be routed so to avoid causing a trip hazard.
Ventilation distance to the front and
back surface should be over 20cm/8"
Ventilation distance to the right, left, top and
bottom surface should be over 10cm/4"
ESCAPE FITNESS MARS USER MANUAL | MAY 2022
INTRODUCTION.
SCREEN SPECIFICATIONS.
• 32” 10 point capacitive swipeable multi touch screen
• Resolution 1920x1080
• Android operating system
• VESA 100 (100mm x 100mm) and VESA 200 (200mm x 200mm)
M6 mounting holes
• Device processor is Quad Core Cortex-A72 up to 1.8Ghz A53
up to 1.4Ghz, 4GB RAM DDR3
• Storage – Internal 32GB eMMC, External 64GB
• Bluetooth EDR 5.0
• Camera 5MP xed focus front facing and microphone
• Speakers 5W
POWER REQUIREMENTS.
• 100-240v AC 50/60Hz 2A Max
• Consumption 50W
• 5m / 16.4ft power cable provided with screen
INTERNET REQUIREMENTS.
• WiFi 802.11 b/g/n/ac 2.4Ghz and 5Ghz
• 5m / 16.4ft Ethernet cable provided with screen
DIMENSIONS.
MARS – 76cm / 30” (h) x 46cm / 18” (w) x 50mm / 2” (d).
RACK5 – 1856mm / 73” (h) x 1850mm / 73” (w) x 700mm / 27.5” (d).
Frame bracket – Speak to your sales representative.
WEIGHT.
Screen – 12kg / 26.5lbs
RACK5
• Total weight unloaded – 75kg / 165lbs
• Maximum loaded weight – 250kg / 550lbs
• Maximum load weight per shelf – 50kg / 110lbs
VIDEOS.
• Over 650 exercises and workouts
• 3 levels of difficulty (beginner, Intermediate and advanced)
• Exercises and workouts updated regularly via the Internet
WARRANTY.
Screen – 3 years.
RACK5 – metalwork 5 years, plastic attachments 1 year.
The MARS (MULTI-ACTIVITY RESOURCE STATION) consists of a 32” 10 point capacitative swipeable multi touch screen display enclosed with a personal computer. It
runs the Android operating system, remote support software and the MARS application itself. All of the software is run under “Software as a Service” licenses so that they
are, in effect, rented for a period of 3 years from the activation date. This subscription is included in the initial purchase price.
The MARS screen provides the user with video instruction on how to use Escape Fitness equipment and also describes workouts that the user can view and then replicate.
ESCAPE FITNESS MARS USER MANUAL | MAY 2022
BASIC OPERATION.
INITIAL POWER ON.
1.
STEP. 1
CONNECT THE POWER CABLE.
When unpacked you will see that the power socket is protected by a safety cover at the rear of the screen at the bottom (Figure 1). This cover
ensures that the power is less likely to be accidentally disconnected and that the power cable is secure. To attach the power cable, rst remove
the two screws holding the safety cover in place (Figure 1). Once removed, insert the power cable into socket shown below (Figures 2 and 3).
After the power cable is in place, re-t the safety cover (Figure 4).
Before you plug into a power source, ensure that the power cable is not pulled or put under strain. The screen can then be connected to the
power source.
2.
STEP. 2
POWER UP.
Turn on the screen using the on/o power rocker switch on the
left hand side of the unit as shown below. The rocker switch
has a “I” and a “0”. When “I” is pressed down, the power is on
and the unit will start when plugged in and power is present.
Figure 1. Figure 2. Figure 3. Figure 4.
ESCAPE FITNESS MARS USER MANUAL | MAY 2022
BASIC OPERATION.
3.
STEP. 3
CONNECT TO THE INTERNET.
For connection using a wired ethernet connection, insert one end of the ethernet cable into the port indicated in
red below and the other end into the wall socket or internet router.
The network should provide an IP address and should
provide access to the internet content server. If your
network does not supply an address automatically and you
want to connect using a wired connection then the address
must be set manually. To do this press and hold the Escape
logo at the bottom of the screen and then release. When
doing this you will be asked to enter a passcode which is
2222.
ESCAPE FITNESS MARS USER MANUAL | MAY 2022
BASIC OPERATION.
After doing this you will be presented with a screen from the operating system where you will be able to manually switch from
an automatically provided IP address to a static one instead.
FIRST SELECT “Ethernet”.
Then you will need to switch “ethernet IP mode” from “dhcp” to “static”
Table des matières
Autres manuels Escape Équipement de fitness
