Epson PT-6000 Manuel utilisateur

Ce manuel convient aux modèles suivants

2

Table des matières

Autres manuels Epson Imprimante

Epson

Epson EPL-8000 Dimensions

Epson

Epson LQ-2080 Manuel utilisateur

Epson

Epson U220B - TM Two-color Dot-matrix Printer Manuel utilisateur

Epson

Epson Stylus Pro 4800 Portrait Edition Manuel utilisateur

Epson

Epson 2000P - Stylus Photo Color Inkjet Printer Manuel utilisateur

Epson

Epson EB-1840W Manuel utilisateur

Epson

Epson Stylus Color 670 Manuel utilisateur

Epson

Epson XP-231 Mode d’emploi

Epson

Epson 875DC - Stylus Photo Color Inkjet Printer Guide d'installation

Epson

Epson Stylus Pro 7000 Series Guide de l'utilisateur

Epson

Epson Aculaser CX28DN Series Manuel utilisateur

Epson

Epson Pro XL Manuel utilisateur

Epson

Epson Stylus Photo 1270 Manuel utilisateur

Epson

Epson WorkForce ST-C8000 Manuel utilisateur

Epson

Epson WF-R5690 Manuel utilisateur

Epson

Epson ColorWorks C3500 Manuel utilisateur

Epson

Epson Perfection 1200PHOTO Manuel utilisateur

Epson

Epson ProofPlus TM-H6000III Manuel utilisateur

Epson

Epson Stylus Color 980 Manuel utilisateur

Epson

Epson TM-C3400BK Manuel utilisateur

Epson

Epson SecurColor TM-C3400 Manuel utilisateur

Epson

Epson TM-T88V-DT Guide de démarrage rapide

Epson

Epson WP-4011 Manuel utilisateur

Epson

Epson Stylus DX5000 Series Manuel utilisateur

Manuels Imprimante populaires d'autres marques

Lexmark

Lexmark 1400 Series Manuel

Canon

Canon i70 Series Manuel utilisateur

Evolis

Evolis Elypso Manuel utilisateur

Kyocera

Kyocera FS-9530DN Manuel utilisateur

Canon

Canon LASER SHOT LBP-1210 Manuel utilisateur

Samsung

Samsung BIXOLON SRP-350plusF Manuel utilisateur

Canon

Canon PIXMA PRO-1 Series Manuel utilisateur

Canon

Canon PIXMA G3560 Guide de configuration

Dell

Dell Color Laser Printer 2130cn Manuel utilisateur

Tektronix

Tektronix Phaser 840 Manuel utilisateur

Canon

Canon CLBR 460ps Manuel utilisateur

Eltron

Eltron P210 Guide Manuel utilisateur

Ricoh

Ricoh MD-P1 Manuel utilisateur

Canon

Canon imagePASS-A2 Manuel utilisateur

Canon

Canon S820D Manuel utilisateur

IRA3D

IRA3D POETRY4 Manuel utilisateur

Ricoh

Ricoh Aficio AP400 Manuel utilisateur

BIXOLON

BIXOLON SRP-352plusV Manuel utilisateur

PT-6000/DPR-6000/TA-6000 Installation Manual

Installing the PT-6000

The PT-6000 is an optional tray to hold a TM-H6000/H6000II/H6000III printer, especially

when it is used with an IBM®host computer. Because this tray can hold the printer at an angle,

it does not require much space behind it. Therefore, the tray is a valuable space-saving device

for small countertops. The package includes the PT-6000 and 2 sets of affixing tape.

Note:

Before installing the PT-6000, clean any dirt, oil, or other foreign matter off of the countertop or other

surface where the printer will be installed.

Follow the steps below to install the PT-6000. If you are installing the printer on an IBM 469X

series computer with a projection around the host computer, see the other side of this sheet.

1. With 2 pieces of the affixing tape combined, peel off the stickers on one side of the 2 sets of

combined tape, and paste them to the bottom of the PT-6000.

2. Peel off the stickers on the other sides of the affixing tapes, and press the PT-6000 onto the

countertop; it will be held firmly in place by the affixing tapes.

3. Connect the cable and install the printer on the PT-6000, aligning the 4 rubber feet of the

printer with the 4 projections on the PT-6000 shown above.

IBM is a registered trademark of International Business Machines Corporation.

PT-6000

Affixing

tape

Projections

© 2000 Seiko Epson Corporation. All rights reserved.

Printed in China

Using the PT-6000 with an IBM 469X computer with a projection

1. Install the PT-6000 onto the IBM 469X series so that the slot in the PT-6000 fits over the

projection on the host computer. It is not necessary to use the affixing tape.

2. Connect the cable and install the printer, aligning the rubber feet of the printer with the

proper locations on the PT-6000.

Installing the DPR-6000

Set the display module on the DPR-6000, which is also an option for the TM-H6000/H6000II/

H6000III printer and is in a separate package. The package includes the DPR -6000 and 2 bolts

with nuts. Remove the nuts from the bolts, insert the 2 bolts in the places shown below, and

replace the nuts and tighten them. Then attach the DPR-6000 to the host computer.

Installing the TA-6000

If you want to cover the space beside the printer, use the TA-6000, which is provided in a

separate package.

Slot

Projection

Bolt

DPR-6000

Nut

Space TA-6000