Epson EPL-8000 Manuel utilisateur

For United States Users

This equipment has been tested and found to comply with the limits for a class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and; if not installed and

used in accordance with the instructions, may cause harmful interference to radio or

television reception. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause interference to radio and television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna

•

Increase the separation between the equipment and receiver

•

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected

•

Consult the dealer or an experienced radio/TV technician for help.

WARNING

The connection of a non-shielded equipment interface cable to this equipment will

invalidate the FCC Certification of this device and may cause interference levels which

exceed the limits established by the FCC for this equipment. It is the responsibility of the

user to obtain and use a shielded equipment interface cable with this device. If this

equipment has more than one interface connector, do not leave the cables connected to

unused interfaces.

Changes or modifications not expressly approved by the manufacturer could void the user’s

authority to operate the equipment.

For Canadian Users

This digital apparatus does not exceed the Class B limits for radio noise emissions from

digital apparatus as set out in the radio interference regulations of the Canadian Department

of Communications.

Le present appareil numélique n’émet pas de bruits radioélectriques dépassant les limites

applicables aux appareils numériques de Classe B prescrites dans le réglement sur le

brouillage radioélectrique édicté parle Ministére des Communications du Canada.

retrieval system, or transmitted in any form or by any means, mechanical,

photocopying, recording, or otherwise, without the prior written permission of

Seiko Epson Corporation. No patent liability is assumed with respect to the use of

the information contained herein. Neither is any liability assumed for damages

resulting from the use of the information contained herein.

Neither Seiko Epson Corporation nor its affiliates shall not be liable to the

purchaser of this product or third parties for damages, losses, costs, or expenses

incurred by purchaser or third parties as a result of: accident, misuse, or abuse of

this product or unauthorized modifications, repairs, or alterations to this product,

or (excluding the U.S.) failure to strictly comply with Seiko Epson Corporation’s

operation and maintenance instructions

Seiko Epson Corporation shall not be liable against any damages or problems

arising from the use of any options or any consumable products other than those

designated as Original Epson Products or Epson Approved Products by Seiko

Epson Corporation

Epson and Epson ESC/P are registered trademarks of Seiko Epson Corporation.

IBM and IBM PC are trademarks of International Business Machines Corporation.

HP LaserJet, HP LaserJet+, HP LaserJet 500, HP LaserJet series II, HP LaserJet IIP,

HP LaserJet series III, HP LaserJet IIIP and HP LaserJet IIISi are trademarks, and

Hewlett-Packard and PCL are registered trademarks of Hewlett-Packard

Company.

LocalTalk is a trademark of Apple Computer, Inc.

Centronics is a registered trademark of Centronics Data Computer Corporation.

PostScript is a trademark of Adobe Systems Incorporated.

ITC Zapf Dingbats is a U.S. registered trademark of International Typeface

Corporation.

Bitstream is a registered trademark of Bitstream Inc.

Speedo, Fontware and FaceLift are trademarks of Bitstream Inc.

CG Times is a product of AGFA Compugraphic, a Division of Agfa Corporation

Univers is a U.S. registered trademark of Linotype AG and its subsidiaries.

Nagano, Japan

IMPORTANT SAFETY INSTRUCTIONS

•

Read all of these instructions before you set up your printer.

Follow all warnings and instructions marked on the printer.

Unplug the printer from the wall outlet before you clean it,

and use a damp cloth for cleaning, not liquid or aerosol

cleaners.

Do not use your printer near water or spill any liquid on it.

Do not place the printer on an unstable cart, stand, table or

other surface that may allow the printer to fall.

Do not block any slots or openings in the cabinet. These are

provided for the ventilation necessary to ensure reliable

operation and protection from overheating. Placing the printer

on a bed, sofa, rug, or other similar surface may block the

openings. Also, do not place the printer in a built-in

installation unless proper ventilation is provided.

Never place the printer near or over a radiator or heat register.

Use the type of power source indicated on the label. If you are

not sure of the type of power available, consult your dealer or

local power company,

This printer may be equipped with a plug having a third

(grounding) pin, which fits only into a grounding-type outlet.

This is a safety feature. If you are unable to insert the plug

into the outlet, have an electrician replace your obsolete outlet.

Do not defeat the purpose of the grounding-type plug.

Do not put the printer where the cord will be walked on.

iii

lIf you use an extension cord, make sure that the total of the

ampere ratings on the products plugged into the extension cord

does not exceed the extension cord’s ampere rating. Also, make

sure that the total of all products plugged into the wall outlet

does not exceed 15 amperes.

•Never push objects of any kind into your printer because they

may touch dangerous voltage points or short out parts that

could result in a risk of fire or electric shock.

Except as specifically explained in this user’s guide, do not

attempt to repair the printer yourself. This could expose you to

dangerous voltage points or other risks. Refer all servicing in

those compartments to service personnel.

•Unplug the printer from the wall outlet and have it repaired by

a qualified service person under the following conditions:

When the power cord or plug is damaged or frayed.

If liquid has been spilled into it.

If it has been exposed to rain or water.

If it does not operate normally when the operating

instructions are followed. Adjust only those controls that

are covered by the operating instructions since improper

adjustment of other controls may result in damage and will

often require extensive work by a qualified technician to

restore the printer to normal operation.

If it has been dropped or the cabinet has been damaged.

If it exhibits a distinct change in performance, indicating a

need for service.

Safety Information

Laser Safety

This printer is certified as a Class 1 laser product under the U.S.

Department of Health and Human Services (DHHS) Radiation

Performance Standard according to the Radiation Control for

Health and Safety Act of 1968. This means that the printer does

not produce hazardous laser radiation.

Since radiation emitted by the laser is completely confined within

protective housings and external covers, the laser beam cannot

escape from the machine during any phase of user operation.

CDRH Regulations

The Center for Devices and Radiological Health (CDRH) of the

U.S. Food and Drug Administration implemented regulations for

laser products on August 2, 1976. Compliance is mandatory for

products marketed in the United States. The label shown below

indicates compliance with the CDRH regulations and must be

attached to laser products marketed in the United States.

0955-7321-01

This laser product conforms to the applicable

requirement of 21 CFR Chapter 1. subchapter J.

SEIKO EPSON CORP.

Hirooka,Office

80 Hirooka. Shiojiri-shi, Nagano-ken,JAPAN

MANUFACTURED:

WARNING: Use of controls, adjustments or performance

of procedures other than those specified in this guide

may result in hazardous radiation exposure.

Your printer is a Class 1 laser product as defined in IEC 825

specifications. The label shown below is attached in countries

where required.

Internal Laser Radiation

Max. Radiation Power _................ 5.7x10-4 (W)

Wave Length.......................................

780

This is a Class IIIb Laser Diode Assay that has an invisible

laser beam. The print head unit is NOT A FIELD SERVICE ITEM.

Therefore, the print head unit should not be opened under any

circumstance.

Ozone Emission

During printer operation, a small amount of ozone is released.

This amount is not large enough to affect human beings

adversely.

However, it is best to make sure the room where you a using

the printer has adequate circulation, especially when you are

printing a high volume of materials or using the printer

continuously over a long period of time.

Contents

Introduction

Chapter 1 Setting Up

Finding a Place for the Printer.. ............................................ 1-2

Unpacking................................................................................ 1-5

Assembling .............................................................................. 1-8

Turning On the Printer.......................................................... 1-21

Chapter 2 Testing and Connecting Your Printer

The Control Panel........................................................... 2-2

Testing the Printer ..................................................................... 2-6

Enhancing Print Quality ............................................................. 2-11

Connecting the Printer to Your Computer ............................ 2-16

Selecting the Printer Mode .........................................2-23

Sharing the Printer ...........................................2-25

Switching the Printer Mode ........................................... 2-26

Chapter 3 SelecType

SelecType Overview .................................................... 3-2

Using SelecType.. .................................................................... 3-6

Level

Options.. ..................................................................... 3-13

Level

Options.. ..................................................................... 3-22

Chapter 4 Paper Handling

Choosing Paper ....................................................................... 4-2

Choosing

Paper Size.. .......................................................... 4-5

Paper Feeding and Paper Delivery ....................................... 4-6

Loading Paper Manually.. ...................................................... 4-8

Using the Optional Lower Paper Cassette........................... 4-11

Using the Optional Output Tray.. ........................................ 4-15

Contents

vii

Chapter 5 Maintenance and Transportation

Replacing Consumable Parts ................................................. 5-2

Cleaning the Printer ............................................................... 5-14

Transporting Your Printer ..................................................... 5-22

Chapter 6 Troubleshooting

Status and Error Messages.. ................................................... 6-2

Troubleshooting Directory.. ................................................... 6-9

Paper Jam Problems ................................................................ 6-11

Power Supply .......................................................................... 6-21

Test Prints................................................................................ 6-22

Printing Problems ................................................................... 6-23

Problems with Graphics......................................................... 6-27

SelecType Problems................................................................ 6-29

Paper Handling ....................................................................... 6-31

Decline in Print Quality ........................................................ 6-34

Options .................................................................................... 6-38

Data Dump Mode................................................................... 6-41

Chapter 7 Options

Identity Cards.......................................................................... 7-2

Font Cartridges.. ...................................................................... 7-6

The Lower Paper Cassette Unit ............................................ 7-13

The Face-Up Output Tray..................................................... 7-16

Optional Interface Cards.. ...................................................... 7-18

Memory Options .................................................................... 7-22

Viii

Contents

Autres manuels pour EPL-8000

Table des matières

Autres manuels Epson Imprimante

Epson

Epson MICRO PIEZO 620F Manuel utilisateur

Epson

Epson Stylus Photo 1500W Manuel utilisateur

Epson

Epson WorkForce 1100 Manuel utilisateur

Epson

Epson Stylus NX125 Series Manuel utilisateur

Epson

Epson Stylus Photo T50 Manuel utilisateur

Epson

Epson R300 - Stylus Photo Color Inkjet Printer Manuel utilisateur

Epson

Epson Stylus CX7300 Series Manuel utilisateur

Epson

Epson Stylus Pro 4880 ColorBurst Edition - Stylus Pro 4880... Manuel utilisateur

Epson

Epson TM-C610 Manuel utilisateur

Epson

Epson SureColor F6000 Instructions d'installation

Epson

Epson SureColor F2000 Series Manuel utilisateur

Epson

Epson Іендгі C43 series Mode d’emploi

Epson

Epson R1900 - Stylus Photo Color Inkjet Printer Manuel utilisateur

Epson

Epson WF-2650 Manuel utilisateur

Epson

Epson L3100 Series Manuel utilisateur

Epson

Epson 1400 - Stylus Photo Color Inkjet Printer Manuel utilisateur

Epson

Epson Stylus D68 Mode d’emploi

Epson

Epson Stylus Photo RX600 Manuel utilisateur

Epson

Epson U295 - TM B/W Dot-matrix Printer Manuel utilisateur

Epson

Epson R320 - Stylus Photo Color Inkjet Printer Guide d'installation

Epson

Epson LQ-1070+ Manuel d'installation et d'exploitation

Epson

Epson Stylus 1500 Manuel utilisateur

Epson

Epson Stylus C40UX Manuel utilisateur

Epson

Epson Stylus SX438W Manuel utilisateur

Manuels Imprimante populaires d'autres marques

Lexmark

Lexmark 1400 Series Manuel

Canon

Canon i70 Series Manuel utilisateur

Evolis

Evolis Elypso Manuel utilisateur

Kyocera

Kyocera FS-9530DN Manuel utilisateur

Canon

Canon LASER SHOT LBP-1210 Manuel utilisateur

Samsung

Samsung BIXOLON SRP-350plusF Manuel utilisateur

Canon

Canon PIXMA PRO-1 Series Manuel utilisateur

Canon

Canon PIXMA G3560 Guide de configuration

Dell

Dell Color Laser Printer 2130cn Manuel utilisateur

Tektronix

Tektronix Phaser 840 Manuel utilisateur

Canon

Canon CLBR 460ps Manuel utilisateur

Eltron

Eltron P210 Guide Manuel utilisateur

Ricoh

Ricoh MD-P1 Manuel utilisateur

Canon

Canon imagePASS-A2 Manuel utilisateur

Canon

Canon S820D Manuel utilisateur

IRA3D

IRA3D POETRY4 Manuel utilisateur

Ricoh

Ricoh Aficio AP400 Manuel utilisateur

BIXOLON

BIXOLON SRP-352plusV Manuel utilisateur