Enfora GSM1308 Manuel utilisateur

Unitronics

The GSM-41J Modem Kit: Enfora GSM1308/1318

This kit enables your SMS-enabled OPLC to communicate via cellular networks.

The kit contains an Enfora GSM1308/1318 modem and related hardware.

The modem can communicate via GSM, GPRS + TCP/IP at 850/900/1800/1900 MHz.

Note:

Standard Vision controllers only: V120, V230, V260, V280, V530, V290 (V290-19-B20B only)

VisiLogic programs including the GPRS Function Block must use FB V5.04 and later. To learn how to

update FBs, refer to the VisiLogic Help topic FBs Library.

Connection

The figure below shows you how to assemble the different elements of the Enfora GSM1308/1318

modem, and how to connect the modem to an OPLC.

Component Identification

Description

Notes

1 Communication cable,

controller to modem

Vision Series / M90/91 Series:

To connect the modem to the PLC, use the standard programming

cable that is supplied with your controller, or with your controller's

programming kit.

Jazz Series:

Jazz does not comprise an embedded communication port

Add-on ports are available by separate order

Use the communication cable supplied with the Add-on port

GSM antenna connector

Located on modem

3 GSM antenna

SIM card slot

Located on modem. See page 2

LED

Located on modem. See page 2

6 9-pin RS232 port Located on modem

9 pin male adapter

p/n MJ10-22-CS72

Power supply socket

Located on modem

Power supply cable

Cable p/n 211300508

Enfora GSM1308/1318 modem

Modem kit

Unitronics

SIM Card

To insert the SIM card, slide it into the slot until

it clicks into place, and then slide the lock to

the left.

To remove the card, slide the lock to the right

and then press the card; a spring releases and

partially ejects the card.

Modem RS232 port pin-out

D-type 9 pin female connector:

Description

Direction

1 DCD (Data Carrier Detect) O

RxD (Receive Data)

TxD (Transmit Data)

4 DTR (Data Terminal Ready) I

GND (Signal Ground)

DSR (Data Set Ready)

RTS ( Request to Send)

CTS (Clear To Send)

RING (Ring Indicator)

LED: Status Indication

The modem has one green LED on the panel labeled REG (shown above).

REG indicates GSM network registration status.

Flashing, when attempting to register on a GSM network.

Continually lit, when the modem is registered with a GSM network.

Modem kit

Enfora GSM1308/1318 modem

Unitronics

Mounting

Use the screw brackets shown in the following figure to mount the device.

Enfora GSM1308/1318 modem

Modem kit

Unitronics

Technical Specifications

Modem

Power voltage range

6 - 40VDC

Status indication

LED - see page 2

SIM card

3V (with locking mechanism)

GSM frequency 850/900/1800/1900 MHz

Weight

147g (5.19oz)

Dimensions 63.5x63.5x23.9mm (2.5”x2.5”x0.94”)

Operational temperature

-30 to 70°C (-22 to 158°F)

Storage temperature

-40 to 85°C (-40 to 185°F)

Antenna connector type

SMA female

Antenna

Antenna frequency

Quad band GSM:850/900/1800/1900 MHz

Unitronics product sold hereunder can be used with certain products of other manufacturers at the

user’s sole responsibility.

The information provided is subject to change without notice.

The information in this document reflects products at the date of printing. Unitronics reserves the right, subject to all applicable laws, at any time, at its sole

discretion, and without notice, to discontinue or change the features, designs, materials and other specifications of its products, and to either permanently or

temporarily withdraw any of the forgoing from the market.

All information in this document is provided "as is" without warranty of any kind, either expressed or implied, including but not limited to any implied warranties of

merchantability, fitness for a particular purpose, or non-infringement. Unitronics assumes no responsibility for errors or omissions in the information presented in

this document. In no event shall Unitronics be liable for any special, incidental, indirect or consequential damages of any kind, or any damages whatsoever arising

out of or in connection with the use or performance of this information.

The tradenames, trademarks, logos and service marks presented in this document, including their design, are the property of Unitronics (1989) (R"G) Ltd. or other