Eneo AK-26 Manuel utilisateur
AK-26 Quick Installation Guide (EN)
DIMENSION (Unit: mm) SPECIFICATION
PARTS SUPPLIED
PRIOR to USE
Install the mount onto a strong structure such as concrete wall
Use the supplied accessories when installing the mount bracket depends on mounting position
Construction: Aluminum Cast
Environment: Ceiling mount for a Bullet
Dimension (mm): 146.7x62.0mm
Weight: 296g (0.55 lb)
4 x Screws
Junction Box
Stopper For Wire
Screw
QIG
AK-26 Quick Installation Guide (EN)
INSTALLATION
Ceiling Mount
1. Locate at the installation position and drill the wall.
2. Hammer the 4 expansion screws into the wall holes drilled
3. Route the power and BNC cable through the Pipe
4. Tight the pipe to wall through the four screws
5. Screw the box into the Pipe, the Pipe can match with AK23 or AK 25 Box etc
6. Insert the box ring for waterproofing
7. Open the dome cover by loosening screws, The cover should be connected by a Safety Belt
8. Connect the power and BNC cable with the camera cables
9. Fixed the Vandal-Proof Dome base to the Junction box
10. Set the camera’s viewing angle
11. Put the dome cover to the dome unit and tighten screws.
AK-26 Quick Installation Guide (EN)
Wall Mount
Allow the Junction Box match with the Bracket (DOME-WB6) for the Wall Mount. Detailed
operation steps are similar with the Ceiling Mount. Please refer to.
AK-26 Quick Installation Guide (EN)
Pillar Mount
Allow the Junction Box match with the Bracket (DOME-WB6) +Pillar Bracket (PM-21) to mount the
camera on one Pole.
1. Fix the Pillar Bracket on one Pole through two Hoops to control tightness
2. Fix the Bracket (Dome-WB6) to the Pillar bracket
3. Route the power and BNC cable through the bracket
4. Screw the Junction Box to the Bracket shown as below
5. Insert the box ring to the mounting plate for waterproofing
6. Open the dome cover by loosening screws
7. Connect the power and BNC cable with the camera cables
8. Assemble the vandal proof dome base to the mounting plate using the assembly screws
9. Set the camera’s viewing angle
10. Put the dome cover to the dome unit and tighten screws.
AK-26 Quick Installation Guide (EN)
Corner Mount
Allow the Junction Box match with the Bracket (DOME-WB6) + Corner Bracket (CM22) for the
Corner Mount. Detailed operation steps are similar with the Pillar Mount. Please refer to.
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels Eneo Accessoires pour appareils photo
Eneo
Eneo VHM Series Manuel utilisateur
Eneo
Eneo VPT-601 RAL7035 Instructions d'installation
Eneo
Eneo AK-20 Manuel utilisateur
Eneo
Eneo VHM/ECLKA-210-W Manuel utilisateur
Eneo
Eneo AK24 Manuel utilisateur
Eneo
Eneo DOME-WB6 Manuel utilisateur
Eneo
Eneo DOME-WB1 B Manuel utilisateur
Eneo
Eneo AK-5 Callisto dome series Manuel utilisateur
Eneo
Eneo VKC-1356/AK Manuel utilisateur
Eneo
Eneo AK-29 Manuel utilisateur
