Emerson Liebert GXT2-10KIPPCBL Manuel utilisateur

Liebert GXT2-10KIPPCBL

Quick-Start Guide

Warnings

& Cautions

This input power cable

must be installed only

by properly trained and

qualified personnel.

Opening or removing

the cover of the UPS

may expose you to lethal

voltages within this unit

even when it is appar-

ently not operating and

the input wiring is dis-

connected from the elec-

trical source. Observe all

cautions and warnings

in this quick-start guide

and in the user manual

for the UPS, available

at the Liebert Web site,

www.liebert.com

Failure to do so may re-

sult in serious injury or

death.

Disconnect the Liebert GXT2-10000RT208™ from all electri-1.

cal inputs.

Remove the top cover from the terminal block cover on the2.

rear of the UPS. Set all screws aside for reinstallation.

Use a screwdriver or similar tool to remove the knockout.3.

Slip the locknut onto the input power cable.4.

Thread the input power cable through the knockout hole.5.

Slip the fixed ring onto the input power cable.6.

Connect the wires of the input power cable to the input7.

power terminal block of the UPS according to the labels on

the wires (see Connect cable wires, below).

Each wire must be connected to the corresponding location8.

on the input side of the terminal block.

Reattach the terminal block cover to the Liebert GXT2-9.

10000RT208 using screws removed in Step 2.

Leave a small amount of slack in the input power cable10.

inside the terminal block and secure the cable to the

terminal block with the fixed ring and locknut (see Secure

cable to back cover, below).

Reattach the top cover to the terminal block using screws11.

removed in Step 2.

Check the voltage of the input power supply to ensure that12.

it matches the power requirements of the Liebert GXT2-

10000RT208.

If the input power is correct, shut off power to the supply13.

socket and mate the UPS to the socket.

L 1

OUTP UT INPUT

60 A mp Max B r anch

Over cur r ent P r ot ect i on

L2 L1N L2 L 1N

L2 L1

Wires are labeled

Connect cable wires Secure cable to back cover

Reattach terminal

block cover

®™

Proper Input Power Connection

The GXT2-10KIPPCBL is an IEC 309-60A, L1-L2-N-G configuration, input power cable and plug

designed to work with the Liebert GXT2-10000RT208. This input plug should be connected to a

power outlet with an IEC 309-60A, L1-L2-N-G configuration.

Miswiring power to the input terminal block or connecting to single-phase voltages (L-N-G only)

may damage the UPS.

NOTE

For startup instructions, refer to the user manual for the Liebert GXT2-10000RT208,

SL-23444, available at the Liebert Web site, www.liebert.com

Emerson Network Power

Emerson Network Power, the global leader in enabling business-critical continuity, ensures network resiliency and adaptability

through a family of technologies—including Liebert power and cooling technologies—that protect and support business-critical

systems.

Liebert solutions employ an adaptive architecture that responds to changes in criticality, density and capacity. Enterprises benefit

from greater IT system availability, operational flexibility and reduced capital equipment and operating costs.

Emerson Network Power.

The global leader in enabling Business-Critical Continuity.

Business-Critical Continuity, Emerson Network Power and the Emerson Network Power logo are trademarks and service marks of Emerson

Electric Co. EmersonNetworkPower.com

While every precaution has been taken to ensure accuracy and completeness in this literature, Liebert Corporation assumes no responsibility, and disclaims all

liability for damages resulting from use of this information or for any errors or omissions.

All names referred to are trademarks or registered trademarks of their respective owners.

® Liebert is a registered trademark of the Liebert Corporation.

SL-23458_REV0_08-08

Web Site

www.liebert.com

Monitoring

800-222-5877

Liebertmonitoring@emerson.com

Outside the US: 614-841-6755

Single-Phase UPS

800-222-5877

upstech@emersonnetworkpower.com

Outside the US: 614-841-6755

Three-Phase UPS

800-543-2378

powertech@emersonnetworkpower.com

Environmental Systems

800-543-2778

Outside the United States

614-888-0246

Locations

United States

1050 Dearborn Drive

P.O. Box 29186

Columbus, OH 43229

Europe

Via Leonardo Da Vinci 8

Zona Industriale Tognana

35028 Piove Di Sacco (PD) Italy

+39 049 9719 111

Fax: +39 049 5841 257

Asia

7/F, Dah Sing Financial Centre

108 Gloucester Road, Wanchai

Hong Kong

852 2572220

Fax: 852 28029250

Technical Support / Service

Autres manuels Emerson UPS

Emerson

Emerson SolaHD SDU DC UPS B Series Manuel utilisateur

Emerson

Emerson Liebert GXT3-3000RT120 Manuel utilisateur

Emerson

Emerson SolaHD SPS Series Manuel utilisateur

Emerson

Emerson Liebert NX Manuel utilisateur

Emerson

Emerson Liebert FPC Manuel utilisateur

Emerson

Emerson Liebert PSA Manuel utilisateur

Emerson

Emerson Liebert GXT2-10000RT208 Manuel utilisateur

Emerson

Emerson Liebert GXT4-5000RT230 Manuel utilisateur

Emerson

Emerson Liebert NXL 250 kVA Manuel utilisateur

Emerson

Emerson Liebert GXT3 208V 5000-10000V Manuel utilisateur

Emerson

Emerson Liebert itON 1500VA Manuel utilisateur

Emerson

Emerson LIEBERT NX 40-120KVA Manuel utilisateur

Emerson

Emerson NXr Manuel utilisateur

Emerson

Emerson Liebert GXT MT+LB 10KL Manuel utilisateur

Emerson

Emerson Liebert PowerSure PST Manuel utilisateur

Emerson

Emerson Liebert NX 10-30kVA Manuel utilisateur

Emerson

Emerson SOLAHD S4KC Series Manuel utilisateur

Emerson

Emerson 1000VA Manuel utilisateur

Emerson

Emerson 7400M Series Manuel utilisateur

Emerson

Emerson Liebert GXT4 Manuel utilisateur

Emerson

Emerson Liebert itON BX Manuel utilisateur

Emerson

Emerson Liebert UPStation GXT2U Manuel utilisateur

Emerson

Emerson Liebert ITA Manuel utilisateur

Emerson

Emerson Liebert NXL series Manuel utilisateur

Manuels UPS populaires d'autres marques

Pylontech

Pylontech Victron & Pylontech US5000 Manuel utilisateur

Tecnoware

Tecnoware EVO DSP PLUS MM 6.8 Manuel utilisateur

Mecer

Mecer ME-1000-WTU Manuel utilisateur

Mustek

Mustek PowerMust 530(B) Plus Manuel d'installation et d'exploitation

MAKELSAN

MAKELSAN BOXER SERIES Manuel utilisateur

Block

Block PC-0524-400-0 Manuel utilisateur

CyberPower

CyberPower CP585LCD Manuel utilisateur

Eaton

Eaton 3S Instructions de montage

CyberPower

CyberPower Office Tower Series UPS 1000 Manuel utilisateur

CyberPower

CyberPower BM100 Manuel utilisateur

Best Power

Best Power 610 Manuel utilisateur

Best Power

Best Power Unity/I UT3K Manuel utilisateur

Mustek

Mustek PowerMust 400 Offline Manuel utilisateur

Xantrex

Xantrex Trace 512 UR-UPS Manuel utilisateur

Forza

Forza SL-1501UL Manuel utilisateur

LEGRAND

LEGRAND keor 310081 Manuel utilisateur

ABB

ABB Conceptpower DPA 500 Manuel utilisateur

ZincFive

ZincFive BC Series Manuel utilisateur