Emerson Smart Wireless Gateway 1420 Manuel utilisateur

¢00825-0100-4420[¤

Quick Installation Guide

00825-0100-4420, Rev CA

June 2007 1420 Wireless Gateway

Step 1: Initial Connection for Configuration

Step 2: Basic Security and Time Configuration

Step 3: Basic Ethernet or Serial Configuration

Step 4: Mount and Connect the 1420

Start

End

1420 Wireless Gateway

1420_QIG_Rev_CA.fm Page 1 Thursday, June 7, 2007 1:18 PM

Quick Installation Guide

00825-0100-4420, Rev CA

June 2007

1420 Wireless Gateway

Physical Device Revision 1.0

Web Server Revision 3.0.8

Network Revision 1.0

IMPORTANT NOTICE

This installation guide provides basic guidelines for the 1420 Wireless Gateway. It does

not provide instructions for detailed configuration, diagnostics, maintenance, service,

troubleshooting, or installations. Refer to the 1420 Wireless Gateway reference manual

(document number 00809-0100-4420) for more instruction. The manual and this QIG are

also available electronically on www.rosemount.com.

WARNING

Explosions could result in death or serious injury:

Installation of this device in an explosive environment must be in accordance with the

appropriate local, national, and international standards, codes, and practices. Please

review the Hazardous Locations Certifications for any restrictions associated with a safe

installation.

Electrical shock can result in death or serious injury

• Avoid contact with the leads and terminals. High voltage that may be present on leads

can cause electrical shock.

WARNING

Explosion Hazard

Do not disconnect equipment when a flammable or combustible atmosphere is present.

IMPORTANT NOTICE

The 1420 Wireless Gateway should be installed before installing any other wireless

devices. This will result in a simpler and faster network installation.

Emerson Process Management

Rosemount Division

8200 Market Boulevard

Chanhassen, MN USA 55317

T (US) (800) 999-9307

T (Intnl) (952) 906-8888

F (952) 949-7001

Rosemount Temperature GmbH

Frankenstrasse 21

63791 Karlstein

Germany

T 49 (6188) 992 0

F 49 (6188) 992 112

Emerson Process Management

Asia Pacific Private Limited

1 Pandan Crescent

Singapore 128461

T (65) 6777 8211

F (65) 6777 0947 / (65) 6777 0743

Enquiries@AP.EmersonProcess.com

1420_QIG_Rev_CA.fm Page 2 Thursday, June 7, 2007 1:18 PM

Quick Installation Guide

00825-0100-4420, Rev CA

June 2007 1420 Wireless Gateway

STEP 1: INITIAL CONNECTION FOR CONFIGURATION

To configure the 1420 Wireless Gateway, a local connection between a PC/laptop and the

1420 Wireless Gateway must be established.

NOTE:

If a PC/laptop from another network is used, carefully record the current IP address

and other settings so the PC/laptop can be returned to its original network when

configuration of the 1420 is finished.

Perform the following steps to establish a local connection with the 1420 Wireless Gateway:

1. On the PC/laptop, install the Java Plug-in found on the CD provided with the 1420. The

Plug-in can also be found at http://java.com/

2. Under Network Connections:

a. Select Local Area Connection

b. Right click to select Properties.

1420_QIG_Rev_CA.fm Page 3 Thursday, June 7, 2007 1:18 PM

Quick Installation Guide

00825-0100-4420, Rev CA

June 2007

1420 Wireless Gateway

c. Select Internet Protocol (TCP/IP), then click the Properties button

d. Select the Use the following IP address button and set the IP address to

192.168.1.12

e. Set the Subnet Mask to 255.255.255.0

f. Select OK for each of the settings windows that have opened.

3. Using the supplied crossover Ethernet cable, attach your PC/laptop to the 1420’s

P1 Ethernet Receptacle (far right Ethernet receptacle).

WARNING

Do not connect to the P3 Power Over Ethernet (POE) port. This port supplies power

and could potentially damage the PC/laptop.

+ +

-A B S S

24V DC24V DC

PowerInputPowerInput ModbusModbus NotUsedNot Used Not UsedNotUsed

Not UsedNotUsed Not UsedNot Used

CaseCase

(Covered)(Covered)

POEPOE P2P2 P1P1

P1 Ethernet

Receptacle

Crossover Cable

PC/Laptop

1420_QIG_Rev_CA.fm Page 4 Thursday, June 7, 2007 1:18 PM

Quick Installation Guide

00825-0100-4420, Rev CA

June 2007 1420 Wireless Gateway

4. Open a standard web browser (Internet Explorer, Mozilla Firefox or similar).

5. Uncheck proxies (Tools>Internet Options>Connections>LAN Settings)

6. Access the 1420’s default web page at https://192.168.1.10

a. Log on as User: admin

b. Password: default

1420_QIG_Rev_CA.fm Page 5 Thursday, June 7, 2007 1:18 PM

Quick Installation Guide

00825-0100-4420, Rev CA

June 2007

1420 Wireless Gateway

c. Click Yes to proceed through the Security Alert

The 1420 Home Page will appear as shown below

1420_QIG_Rev_CA.fm Page 6 Thursday, June 7, 2007 1:18 PM

Quick Installation Guide

00825-0100-4420, Rev CA

June 2007 1420 Wireless Gateway

STEP 2: BASIC SECURITY AND TIME CONFIGURATION

To configure the basic security of the 1420 Wireless Gateway, perform the following steps.

1. Navigate to Setup>Security>User Accounts

2. Set and confirm new passwords for each of the access levels

3. Click Submit

4. Navigate to Setup>Time

5. Select method and click Submit

1420_QIG_Rev_CA.fm Page 7 Thursday, June 7, 2007 1:18 PM

Quick Installation Guide

00825-0100-4420, Rev CA

June 2007

1420 Wireless Gateway

STEP 3: BASIC ETHERNET OR SERIAL CONFIGURATION

To configure the 1420 for an Ethernet Network:

Table 2: Ethernet Communication Settings on page 15 is available to assist in recording the

necessary information.

1. Determine 1420 Ethernet Port for connecting to Ethernet Network

If using a wired connection, use Port 1 (P1)

IT/Process Control Network Administrator or Technician can provide the following:

a. 1420 fixed IP Address or DHCP Host Name

b. Netmask (Subnet Mask)

c. Gateway

BEST PRACTICE:

Keep these values in a secure location not accessible by unauthorized personnel.

2. Configure 1420 Ethernet IP settings

a. Access the 1420 with Administrator access

b. Navigate to Setup>Internet Protocol>Address

c. Enter configuration information determined above

3. To complete configuration without a firewall, click Submit and proceed with 1420 Restart

when prompted.

1420_QIG_Rev_CA.fm Page 8 Thursday, June 7, 2007 1:18 PM

Quick Installation Guide

00825-0100-4420, Rev CA

June 2007 1420 Wireless Gateway

STEP 3 CONTINUED...

To configure the 1420 for a Serial connection:

Table 4: Serial Communication Settings on page 15 is available to assist in recording the

necessary information.

1. Configure 1420 Serial Communication Settings

a. Access the 1420 Web Interface with Administrator access

b. Navigate to Setup>Modbus>Communication

c. Click Enable Modbus

d. Configure the 1420 Modbus Communication settings to match the Host Modbus

settings

NOTE:

Modbus communications will fail if they are not configured identically on the Host

and the 1420.

e. Click Submit and proceed with restart

2. When configuration is completed, disconnect the PC/laptop from the 1420 and return the

PC/laptop to its previous network settings.

1420_QIG_Rev_CA.fm Page 9 Thursday, June 7, 2007 1:18 PM

Quick Installation Guide

00825-0100-4420, Rev CA

June 2007

1420 Wireless Gateway

STEP 4: MOUNT AND CONNECT THE 1420

Integral Antenna with the 1420 on a Mast

The optimal installation of the 1420 Wireless Gateway is

on a pole approximately 1.8 meters above the top of the

exterior wall of a building. The following hardware and

tools are needed:

• Pipe mount with holes spaced 3.06 inches (78 mm)

apart horizontally and 11.15 inches (283 mm) apart

vertically.

• Two 3.06 inch (78 mm) by 5/16 inch U-bolts

•1/2inch wrench

Mount the gateway by doing the following:

1. Insert one U-bolt around the pipe and through the

top mounting holes of the pipe mount and the 1420,

and another U-bolt through the bottom mounting

holes of the pipe mount and the 1420.

2. Using a 1/2inch socket-head wrench, fasten the nuts

to the U-bolts and tighten.

BEST PRACTICE

When mounting outside, best practice is to run the

Serial or primary Ethernet cable (P1) directly to the

Information System. Use conduit and/or strain relief

as necessary.

BEST PRACTICE

When installing cable/conduit, run an ethernet

connection from 1420 port P2 to a convenient

location indoors (if the 1420 was ordered with

Output Code 2). This will simplify future

configuration changes.

1.8 m (6 ft.)

Strain

Relief

1420_QIG_Rev_CA.fm Page 10 Thursday, June 7, 2007 1:18 PM

Autres manuels pour Smart Wireless Gateway 1420

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Emerson Porte

Emerson

Emerson 1410 A/B Manuel utilisateur

Emerson

Emerson Smart Wireless Gateway 1420 Manuel utilisateur

Emerson

Emerson 1410S Manuel utilisateur

Emerson

Emerson Smart Wireless Gateway Manuel utilisateur

Emerson

Emerson 1410S Manuel utilisateur

Emerson

Emerson Smart Wireless Gateway 1420 Manuel utilisateur

Emerson

Emerson Smart Wireless Gateway 1420 Manuel utilisateur

Emerson

Emerson Smart Wireless Gateway Manuel utilisateur

Emerson

Emerson Smart Wireless Gateway 1420 Manuel utilisateur

Emerson

Emerson 1410S Manuel utilisateur

Emerson

Emerson 814-3550 Manuel utilisateur

Emerson

Emerson Smart Wireless Gateway 1410 Manuel utilisateur

Emerson

Emerson Smart Wireless Gateway 1420 Manuel utilisateur

Emerson

Emerson Smart Wireless Gateway 1420 Manuel utilisateur

Emerson

Emerson Smart Wireless Gateway 1410 Manuel utilisateur

Emerson

Emerson ATCA-8310 Manuel utilisateur

Emerson

Emerson Smart Wireless Gateway 1410 Manuel utilisateur

Emerson

Emerson 1410S Manuel utilisateur

Emerson

Emerson 1410 D Manuel utilisateur

Emerson

Emerson 1552WU Manuel utilisateur

Emerson

Emerson CH Breaker Gateway Manuel utilisateur

Emerson

Emerson Smart Wireless Gateway 1420 Mode d’emploi

Emerson

Emerson PACSystems RX3i Manuel utilisateur

Emerson

Emerson 1410S Manuel utilisateur

Manuels Porte populaires d'autres marques

LST

LST M500RFE-AS Manuel utilisateur

Kinnex

Kinnex Media Gateway Manuel utilisateur

2N Telekomunikace

2N Telekomunikace 2N StarGate Manuel utilisateur

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manuel utilisateur

Telsey

Telsey CPVA 500 - SIP Manuel utilisateur

RTA

RTA 460A-NNA4 Fiche technique

Shaw

Shaw Gateway HDPVR Manuel utilisateur

ABB

ABB VSN900 Guide de démarrage rapide

Commander

Commander Pulse Manuel utilisateur

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manuel utilisateur

NETGEAR

NETGEAR C6300BD Manuel utilisateur

Amit

Amit CDW531AM Manuel utilisateur

HMS

HMS Netbiter EasyConnect EC150 Manuel utilisateur

Huawei

Huawei EchoLife HG620 Manuel utilisateur

AT&T

AT&T U-verse 3801 Manuel d'utilisation et d'entretien

Logic IO

Logic IO RTCU MX2 turbo Manuel utilisateur

Suttle

Suttle MediaMAX MXM-521 Manuel utilisateur