Emerson Copeland 3290262 Manuel

TI_Unit_CO2_Stream_04_EN_Rev00 Ident number 3293976 (P/N 900-0010-00/Rev00) 1/3

Date of last update: Aug-22

Ref: TI_Unit_CO2_Stream_04_EN_Rev00

Application Engineering Europe

COPELAND™ CO2 REFRIGERATION UNITS

CHANGEOVER VALVE SERVICE KIT

This technical information provides instructions for the replacement of the changeover valve on Copeland CO2

refrigeration units. These instructions are valid only for Copeland CO2refrigeration units with M24x1.5 thread on the

PRV’s connected to the liquid receiver through the changeover valve. If the pressure relief valves (PRV’s) cannot be

disassembled from the changeover valve, it is necessary to replace the complete assembly (changeover valve +

PRV’s). The PRV version with metric thread M24x1.5 cannot be used anymore. The PRV on the high-pressure side

is not affected by this change.

The service kit N°3290262 includes the components shown in the table below.

Components

Description

Quantity

Ident & Part

number

Valve-Change-Over 1/2"NPT

Changeover valve

3290262

510-1018-00

Valve-Safety assm 90 bar

Pressure relief valve (PRV)

3288776

(510-0902-01)

User manual - CV Kit

Instruction

3293976

(900-0010-00)

Table 1: BOM of changeover valve service kit

When replacing the changeover valve including PRV’s, the instructions in this technical information must be carefully

followed. Use the recommended torque at each step.

Only qualified and authorized HVAC or refrigeration personnel are permitted to conduct the changes described in

this technical information. All appropriate safety measures must be considered.

Replacement of changeover valve:

▪Release all the pressure/refrigerant from the unit (Figure 1).

▪Disassemble the changeover valve from the liquid receiver (Figure 2).

▪Connect a nitrogen hose to the liquid receiver so that no thread debris can fall into it (Figure 3).

▪Clean the liquid receiver thread (Figure 3).

Figure 1 Figure 2 Figure 3

TI_Unit_CO2_Stream_04_EN_Rev00 Ident number 3293976 (P/N 900-0010-00/Rev00) 2/3

▪Apply teflon sealing tape (0.1x12 mm) to the changeover valve by 5 to 6 turns clockwise (Figure 4).

▪Mount the changeover valve onto the liquid receiver; torque to 50 Nm (Figure 5).

▪Apply teflon sealing tape (0.1x12 mm) to both NPT PRV‘s by 5 to 6 turns clockwise (Figure 6).

Figure 4 Figure 5 Figure 6

▪Mount both PRV‘s into the changeover valve; torque to 40 Nm (Figure 7).

▪Turn the spindle into middle position so that both PRV ports are open (Figure 8).

▪Close the shut-off valves on the compressor (discharge port) and on the liquid receiver (Figure 9).

▪Open the high-pressure valve and perform a bubble leak test on all connections between liquid receiver,

changeover valve and PRV’s (Figure 10).

▪Pressurize the liquid receiver with nitrogen (5 bar) and perform a preliminary leak test.

▪Perform the final leak test at 80 bar.

Figure 7 Figure 8 Figure 9

Figure 10

TI_Unit_CO2_Stream_04_EN_Rev00 Ident number 3293976 (P/N 900-0010-00/Rev00) 3/3

▪Mount the deflector and tighten it manually to 1-5 Nm (Figures 11 & 12).

▪The changeover valve must be fully open during unit operation (spindle out Figures 13 & 15).

▪Mount the spindle cap and check the presence of the copper gasket (Figure 14).

Figure 11 Figure 12 Figure 13 Figure 14

Figure 15

Spindle protective cap

Spindle "open" / "closed"

Seal gland

40 Nm

25 Nm

15 Nm

Table 2: Torques on the changeover valve in Nm

NOTE: For information on the maintenance and lifetime of the PRV, please refer to the unit application

guidelines.

- The contents of this publication are presented for informational purposes only and are not to be construed as warranties or guarantees, express or implied, regarding

the products or services described herein or their use or applicability.

- Emerson Climate Technologies GmbH and/or its affiliates (collectively "Emerson"), as applicable, reserve the right to modify the design or specifications of such

products at any time without notice.

- Emerson does not assume responsibility for the selection, use or maintenance of any product. Responsibility for proper selection, use and maintenance of any

Emerson product remains solely with the purchaser or end user.

- Emerson does not assume responsibility for possible typographic errors contained in this publication.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Emerson Unité de contrôle

Emerson

Emerson Fisher 98LD Manuel utilisateur

Emerson

Emerson SEMPELL Guide rapide

Emerson

Emerson Bettis Q series Manuel utilisateur

Emerson

Emerson Sempell PSRV VS99 Manuel utilisateur

Emerson

Emerson ALCO Thermo TX6 Manuel utilisateur

Emerson

Emerson EXD-U01 Manuel utilisateur

Emerson

Emerson Keystone Figure 969 Hopper Manuel utilisateur

Emerson

Emerson CASH VALVE FRM Manuel utilisateur

Emerson

Emerson Neotecha Sapro Guide de configuration

Emerson

Emerson Asco PV-MXX-272/374 Series Manuel utilisateur

Emerson

Emerson KTM Hindle Mode d’emploi

Emerson

Emerson Bettis XTE3000 Manuel utilisateur

Emerson

Emerson Fisher MR98LD Manuel utilisateur

Emerson

Emerson 8323G0 Series Instructions d'installation et d'utilisation

Emerson

Emerson CROSBY STYLE HC ISOFLEX Mode d’emploi

Emerson

Emerson PACSystems RX3i Manuel utilisateur

Emerson

Emerson SAPAG CLASAR Series Manuel de la liste des pièces

Emerson

Emerson EX4-6-...FLR Series Manuel utilisateur

Emerson

Emerson 850 Manuel utilisateur

Emerson

Emerson Keystone Figure 320 Manuel utilisateur

Emerson

Emerson NEOTECHA SNB Series Manuel utilisateur

Emerson

Emerson unidrive m Manuel utilisateur

Emerson

Emerson Fisher GX Manuel utilisateur

Emerson

Emerson Sempell series Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur