II
cybox GW-P installation manual
DISCLAIMER
Copyright
© 2017 ELTEC Elektronik AG. The information, data, and figures in this document including respective
references have been verified and found to be legitimate. In particular in the event of error they may,
therefore, be changed at any time without prior notice. The complete risk inherent in the utilization of
this document or in the results of its utilization shall be with the user; to this end, ELTEC Elektronik AG
shall not accept any liability. Regardless of the applicability of respective copyrights, no portion of this
document shall be copied, forwarded or stored in a data reception system or entered into such systems
without the express prior written consent of ELTEC Elektronik AG, regardless of how such acts are
performed and what system is used (electronic, mechanic, photocopying, recording, etc.). All product and
company names are registered trademarks of the respective companies.
Our General Business, Delivery, Offer, and Payment Terms and Conditions shall otherwise apply.
Federal communications commission statement
aThis device complies with FCC Rules Part 15. Operation is subject to the following two conditions:
aThis device may not cause harmful interference, and
aThis device must accept any interference received including interference that may cause
undesired operation.
aThis equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with
manufacturer’s instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try correct the
interference by one or more of the following measures:
aReorient or relocate the receiving antenna.
aIncrease the separation between the equipment and receiver.
aConnect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
aConsult the dealer or an experienced radio/TV technician for help.
aThe use of shielded cables for connection of the monitor to the graphics card is required to
assure compliance with FCC regulations. Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the user’s authority to operate this
equipment.
