iNode Care GSM – user manual ELSAT s.c.
2.3 Cleaning
•Before cleaning, always unplug the machine y unplugging the power cord
or adapter from the power outlet.
•Do not use liquid cleaners or aerosol cleaners.
•For cleaning only use a dry, soft, lint-free cloth.
2.4 Ventilation
•All openings and slots in the housing of the device or power supply are for
ventilation. They must not e covered or covered, as it may overheat the
internal components.
•Protect the device and power supply against access of small children a le to
throw small things into the ventilation holes
2.5 Service
•If necessary, take the device to a specialized service center. There are no
user servicea le controls or useful components inside.
2.6 Before commissioning
•Before starting the installation, check the compliance of your mains voltage
with the information on the device or power supply.
•Switching the power on and o@ from the power socket is always carried out
y holding the plug or the power supply housing, not the power cord.
•If only the power cord plug or adapter is in the wall socket, the device is still
powered. The DC power plug is the only element that disconnects power
from the device.
•If anything falls or falls inside the machine or the power supply, immediately
remove the plug from the wall socket. The device or power supply unit may
not e used until an expert inspection has een performed.
•Do not disassem le the device or power supply. There may e dangerous
voltage inside, threatening health and even life. Any repairs and adjustments
inside should only e performed y qualied service personnel.
2.7 Location
•Place the device and power supply in a place with good ventilation - free air
?ow. This will prevent internal components from overheating.
•Never place the device or the power supply near heating devices or in sunny
places.
•Never place heavy o jects on it.
2.8 Steam condensation
Under certain circumstances (e.g. sudden change of location from a cold
to a warm room) the device and / or the power supply may ecome covered with
steam, preventing the device from eing used temporarily. In this case, wait
a out 1 hour for the temperature of the device to sta ilize and the moisture to
evaporate.
Page 4
