ECopy AS-Y5091 Manuel utilisateur

eCopy Hub Card ASY5091

User Manual

Part # 76-4014

Rev # 012304

Information contained in this document is subject to change without notice. eCopy assumes no

responsibility for errors or omissions in this document. Contact eCopy Technical Support for current

product information.

form without the express written permission of eCopy, Inc.

eCopy, the eCopy logo, eCopyFax, the Simplify logo, the MailRoom logo, eCopy ShareScan, eCopy

ShareScan OP, eCopy ScanStation, eCopy Desktop, eCopy Quick Connect, eCopy Xpert Compression,

UniDoc, SpeedFax, and SpeedPrint are trademarks of eCopy, Inc. Simplify and MailRoom are registered

trademarks of eCopy, Inc. Touchstone Technology is a registered trademark of Touchstone Technology,

Inc.

All other terms and products are trademarks or registered trademarks of their respective owners and are

hereby acknowledged.

Table of Contents

Introduction....................................................................................................1

Features .................................................................................................................................................. 1

System requirements ............................................................................................................................. 1

Hardware setup..............................................................................................2

Safety instructions and warnings.......................................................................................................... 2

Network switch removal........................................................................................................................ 2

Connecting the network cables ............................................................................................................. 3

Obtaining technical support..........................................................................4

eCopy Hub Card ASY5091 User Manual 1

Introduction

The Touchstone Technology 3-Port Network Switch is distributed as an integrated component of eCopy

ScanStations. It is a self contained three port switch that fits into a standard, full height, PCI slot. The

board is self configuring and receives power from the host computer’s PCI Bus. The board is compliant

with FCC Class-B, VCCI, and UL standards.

Features

>3 port 10/100 Integrated Switch with

Physical Layer Transceivers based on

Kendin S8993 chip

>64K Byte of SRAM on chip for frame

buffering

>1.0Gbps high performance memory

bandwidth

>10BaseT, 100BaseTX modes of

operation

>Support for UTP

>Superior analog technology for

reduced power and die size

>Supports port based VLAN

>QoS Feature. Supports 802.1p based priority or port based priority

>Indicators for link activity, full/half duplex

>Unmanaged operation

>Hardware based 10/100, full/half, flow control and auto negotiation

>Wire speed reception and transmission

>On chip integrated address Look-Up Engine, supports 1k absolute MAC addresses

>Automatic address learning, address aging and address migration

>Full duplex IEEE 802.3x flow control (Pause) with force mode option

>Half duplex back pressure flow control

System requirements

>One full height PCI slot

>Category 5 Ethernet cables

eCopy Hub Card ASY5091 User Manual 2

Hardware setup

Safety instructions and warnings

Caution! Expansion cards contain delicate integrated circuits. To protect them against damage from static

electricity, take the following precautions:

>Always switch off and disconnect the computer and any attached devices from their electrical outlets

before attempting to work inside the computer.

>Wear a grounding strap or touch an unpainted metal surface on the computer’s chassis before

touching anything inside the computer.

>Place components on a grounded antistatic pad or on the bag that came with the components

whenever the components are separated from the system.

Network switch removal

The Touchstone Technologies 3-port network switch is installed inside the eCopy ScanStation PC before

the system ships. To remove the switch, follow the procedure below.

1. Turn off the computer and unplug the power supply.

2. Determine the location of the 3-port switch in your PC. The location may vary according to the PC

model.

3. Open the case and remove the integrated 3-port switch card from the slot. Note that on some PCs

you may need to remove a riser card to gain access to the PCI slot.

3-port network switch

eCopy Hub Card ASY5091 User Manual 3

Connecting the network cables

The 3-port network switch enables you to connect the eCopy ScanStation and the imageRUNNER to a

single network jack. If there is a second wall jack available, you do not need to use the internal 3-port

switch (this method is the preferred configuration).

To connect the network cables:

>If there is a second network jack near the eCopy ScanStation:

>Connect the supplied long Ethernet cable from the network wall jack to the PC’s integrated

network port, as shown below. The internal 3-port switch is not required in this configuration.

ScanStation

PC rear panel

To wall jack

imageRUNNER

connections

Network port on

printer board

Uplink port

To wall jack

Integrated network port

Internal

3-port switch

>If there is only one network jack:

1. Remove the copier’s network cable from the wall jack and connect it to the left port on the

internal 3-port switch.

2. Connect the supplied long Ethernet cable from the network wall jack to the uplink port on the

right of the internal 3-port switch.

3. Connect the supplied short Ethernet cable from the middle port of the internal 3-port switch to

the PC’s integrated network port.

ScanStation

PC rear panel

To wall jack

imageRUNNER

connections

Network port on

printer board

Uplink port

Integrated network port

Internal

3-port switch

eCopy Hub Card ASY5091 User Manual 4

Obtaining technical support

Technical support is available to registered users from eCopy during the warranty period or for the

duration of your software support and maintenance agreement (contact your supplier for details).

When calling eCopy Technical Support, please be at your computer with your system powered on and be

prepared to provide the technical support representative with the following information:

What to have What it is

eCopy serial number This number is used for eCopy ScanStations, eCopy ShareScan, and eCopy

Desktop. It is 10 alpha-numeric digits long. The serial number is printed on

stickers located in the following areas: on the eCopy ScanStation PC, on the

shipping box, on the inside packaging box, and on the inside cover of the user

manuals.

eCopy software version The version and release of the eCopy software currently being used. You can

find the version and release number of your installed eCopy software in the

‘About…’ selection in the application Help menu

Operating System The operating system version that the eCopy software is running on along with

any network information that can be provided

3rd Party Products A list of 3rd party applications that are used in conjunction with eCopy products,

such as Microsoft Exchange/Outlook, Lotus Notes, Captaris RightFax, iManage,

Domino.Doc, etc

Problem Description A detailed description of the problem, steps to reproduce it and exact wording

of any error messages

Contact Information Dealer contact information as well as your contact information for follow up

including name, e-mail address, and telephone number

US/North America:

Technical Support hours are Monday through Friday, 8:30AM to 5:30PM EST.

E-mail Support: [email protected]

Phone Support: +1 (603) 881-4450

Outside North America:

Please contact your local dealer or Canon National Sales Organization.

Table des matières

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

Intel

Intel NUC 12 Pro Manuel utilisateur

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Intel

Intel AXXRMFBU4 Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur

eCopy AS-Y5091 Manuel utilisateur

Manuels Matériel informatique populaires d'autres marques