Dodge Journey 2018 Manuel utilisateur
2018
JOURNEY
QUICK
REFERENCE
GUIDE
Stadium Tip ’n Slide (7 Passenger
Models)
This feature allows passengers to easily enter or
exit the third-row passenger seats from either side
of the vehicle.
To Move The Second-Row Passenger Seat For-
ward
NOTE:
Raise the 40% seatback/armrest before moving
the 60% seat, to allow for full seat travel.
Move the control lever on the upper outboard side
of the seatback forward. Then, in one fluid motion,
the seat cushion flips upward and the seat moves
forward on its tracks. To Unfold And Move The Second-Row Passenger
Seat Rearward
1. Move the seatback rearward until it locks in
place and then continue sliding the seat rear-
ward on its tracks until it locks in place.
2. Push the seat cushion downward to lock it in
place.
3. Adjust the seat track position as desired.
Rear Seat Lever Locations
1 — Forward/Rearward Adjustment Lever
2 — Recliner/Seatback Release Lever
3 — Tip ’n Slide Control Lever
Seat In Tip ‘n Slide Position
SEATS
For further information, and applicable warnings and
cautions, please refer to the Owner’s Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Cana-
dian Residents).
Comfort Features
Heated Seats
The front heated seats controls are located within
the climate or controls menu screen of the
Uconnect system.
Heated Steering Wheel
The steering wheel contains a heating element
that heats the steering wheel to one temperature
setting. The heated steering wheel control is lo-
cated within the Uconnect system. You can gain
access to the control buttons through the climate
screen or the controls screen.
For further information, and applicable warnings and
cautions, please refer to the Owner’s Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Cana-
dian Residents).
In-Floor Storage Bin With
Removable Liner
An in-floor storage bin is located behind each front
seat.
To Access The Storage Bin
1. Position the front seat to at least a mid-track
position to provide easier access to the storage
bin.
2. Move the floor mat aside (if equipped).
3. Pull the door latch release-loop upward to re-
lease the latch, and then forward to open the
storage bin door.
For further information, and applicable warnings and
cautions, please refer to the Owner’s Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Cana-
dian Residents).
In Floor Storage
CARGO FEATURES
Speed Control
When engaged, the Speed Control takes over
accelerator operations at speeds greater than
25 mph (40 km/h).
The Speed Control buttons are located on the right
side of the steering wheel.
NOTE:
In order to ensure proper operation, the Speed
Control system has been designed to shut down if
multiple Speed Control functions are operated at
the same time. If this occurs, the Speed Control
system can be reactivated by pushing the Speed
Control ON/OFF button and resetting the desired
vehicle set speed.
To Activate
Push the ON/OFF button. The Cruise Control Set
Indicator Light in the instrument cluster display
will illuminate. To turn the system off, push the
ON/OFF button a second time. The Cruise Control
Set Indicator Light will turn off. The system should
be turned off when not in use.
To Set A Desired Speed
Turn the Speed Control on. When the vehicle has
reached the desired speed, push the SET (-) but-
ton and release. Release the accelerator and the
vehicle will operate at the selected speed.
Speed Control Switches
1 — CANCEL
2 — ON/OFF
3 — RES (+)/Resume/Accel
4 — SET (-)/Decel
SPEED CONTROL
To Deactivate
A soft tap on the brake pedal, pushing the CAN-
CEL button, or normal brake pressure while slow-
ing the vehicle will deactivate Speed Control with-
out erasing the set speed memory. Pushing the
ON/OFF button or turning the ignition switch OFF
erases the set speed in memory.
To Resume Speed
To resume a previously set speed, push the
RES (+) button and release. Resume can be used
at any speed above 25 mph (40 km/h).
To Increase Speed
When the Speed Control is set, you can increase
speed by pushing the RES (+) button.
To Decrease Speed
When the Speed Control is set, you can decrease
speed by pushing the SET (-) button.
To Accelerate For Passing
Press the accelerator as you would normally. When
the pedal is released, the vehicle will return to the
set speed.
For further information, and applicable warnings and
cautions, please refer to the Owner’s Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Cana-
dian Residents).
Keyless Enter-N-Go — Passive
Entry
The Keyless Enter-N-Go Passive Entry system is
an enhancement to the vehicle’s Remote Keyless
Entry feature. This feature allows you to lock and
unlock the vehicle's door(s) and liftgate without
having to push the key fob lock or unlock buttons,
as well as starting and stopping the vehicle with
the push of a button.
PASSIVE ENTRY
To Unlock From The Driver Or
Passenger Side
With a valid Keyless Enter-N-Go key fob located
outside the vehicle and within 5 ft (1.5 m) of the
driver or passenger side door handle, grab either
front door handle to unlock the door automatically.
To Lock The Vehicle
Both front door handles have buttons located on
the outside of the handle. With one of the vehicle’s
Keyless Enter-N-Go key fobs located outside the
vehicle and within 5 ft (1.5 m) of the driver's or
passenger front door handle, push the door handle
button to lock all four doors and liftgate.
Do NOT grab the door handle when pushing the
door handle lock button. This could unlock the
door(s).
Preventing Inadvertent Locking Of Passive Entry
Key Fob In Vehicle (FOBIK-Safe)
To minimize the possibility of unintentionally lock-
ing a passive entry key fob inside your vehicle, the
passive entry system is equipped with an auto-
matic door unlock feature which will function if
the ignition switch is in the OFF position.
FOBIK-Safe only executes in vehicles with passive
entry. There are three situations that trigger a
FOBIK-Safe search in any passive entry vehicle:
• A lock request is made by a valid passive entry
key fob while a door is open.
• A lock request is made by the passive entry
door handle while a door is open.
• A lock request is made by the door panel switch
while the door is open
When any of these situations occur, after all open
doors are shut, the FOBIK-Safe search will be
executed. If it finds a passive entry key fob inside
the car, the car will unlock and alert the customer.
NOTE:
The vehicle will only unlock the doors when a valid
passive entry key fob is detected inside the ve-
hicle. The vehicle will not unlock the doors when
any of the following conditions are true:
• The doors are manually locked using the door
lock knobs.
• Three attempts are made to lock the doors
using the door panel switch and then close the
doors.
Grab The Door Handle To Unlock
NOTE:
• After pushing the door handle button, you must
wait two seconds before you can lock or unlock
the doors, using either passive entry door
handle. This is done to allow you to check if the
vehicle is locked by pulling the door handle
without the vehicle reacting and unlocking.
• If passive entry is disabled using Uconnect
System, the key protection described in "Pre-
venting Inadvertent Locking of Passive Entry
Key Fob in Vehicle" remains active/functional.
• The Passive Entry system will not operate if the
key fob battery is dead.
Push The Door Handle Button To Lock Do NOT Grab The Handle When Locking
Lock Or Unlock The Liftgate
With a valid Keyless Enter-N-Go key fob within
5 feet (1.5 meters) of the liftgate, push the elec-
tronic liftgate lock/unlock pad located to the left of
the liftgate handle to unlock the liftgate. Push the
button a second time to lock the liftgate.
For further information, and applicable warnings and
cautions, please refer to the Owner’s Manual at
https://www.mopar.com/en-us/care/
owners-manual.html (U.S. Residents) or
www.owners.mopar.ca (Canadian Residents).
Remote Start — If Equipped
Push the remote start button on the key fob
twice within five seconds. Pushing the remote
start button a third time shuts the engine off.
With Remote Start, the engine will only run for
15 minutes (timeout) unless the keyless ignition is
placed in the ON/RUN position.
Before the end of 15-minute cycle, push and
release the unlock button on the key fob to unlock
the doors and disarm the vehicle security alarm (if
equipped). Then, prior to the end of the 15-
minute cycle, push and release the ignition
START/STOP button.
The vehicle must be started with the key fob after
two consecutive timeouts.
For further information, and applicable
warnings and cautions, please refer
to the Owner’s Manual at
https://www.mopar.com/en-us/care/
owners-manual.html (U.S. Residents) or
www.owners.mopar.ca (Canadian Residents).
Electronic Liftgate Lock/Unlock Pad
REMOTE START
Parkview Rear Back-Up Camera
You can see an on-screen image of the rear of your
vehicle whenever the gear selector is put into
REVERSE. The ParkView Rear Back-Up Camera
image appears on the display screen located on
the center stack of the instrument panel.
NOTE:
If the display screen appears foggy, clean the
camera lens located on the rear of the vehicle
above the license plate.
For further information, and applicable warnings and
cautions, please refer to the Owner’s Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Cana-
dian Residents).
Instrument Cluster Display
The instrument cluster display features a driver
interactive display that is located in the instru-
ment cluster. Pushing the controls on the left side
of the steering wheel allows the driver to select
vehicle information and Personal Settings.
• Push the up arrow button to scroll upward
through the main menus (Fuel Economy, Ve-
hicle Speed, Trip Info, Vehicle Info, Messages,
Units, System Set-Up, Turn Menu Off) and sub
menus.
• Push the down arrow button to scroll downward
through the main menus and sub menus.
• Push the right arrow button for access to main
menus, sub menus or to select a personal
setting in the setup menu.
• Push the BACK button to scroll back to a previ-
ous menu or sub menu.
Instrument Cluster Display Controls
SAFETY FEATURES INSTRUMENT CLUSTER
DISPLAY
Selectable Menu Items
The instrument cluster features a driver interac-
tive display that is located in the of the center of
the instrument cluster. Pushing the controls on
the left side of the steering wheel allows the driver
to select vehicle information and Personal Set-
tings. Push the up or down arrow buttons to scroll
through the main menu feature items. To enter the
submenu’s of a feature menu item, push the right
arrow button then push the right arrow button to
select or reset the submenu feature items:
Radio Info Tire Pressure
Vehicle Info Messages
Fuel Economy Vehicle Speed
Trip Info Turn Menu Off
For further information, and applicable warnings and
cautions, please refer to the Owner’s Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Cana-
dian Residents).
AUTO Button
• Push the AUTO button on the Integrated Center
Stack (ICS) Climate Controls, OR on the radio
touchscreen when viewing the Climate Controls
Main Screen.
• Select the desired temperature by pushing the
up or down temperature buttons for the driver
or passenger.
• The system will maintain the set temperature
automatically.
Uconnect 3/3 NAV With 8.4–inch Display
Automatic Climate Controls
AUTOMATIC CLIMATE
CONTROLS
Autres manuels pour Journey 2018
2
Table des matières
Autres manuels Dodge Automobile
Dodge
Dodge DODGE CHALLENGER Manuel utilisateur
Dodge
Dodge Neon 2001 Manuel utilisateur
Dodge
Dodge 2015 GRAND CARAVAN Manuel utilisateur
Dodge
Dodge 2013 Dart Manuel utilisateur
Dodge
Dodge avenger 2013 Manuel utilisateur
Dodge
Dodge 2016 Challenger Manuel utilisateur
Dodge
Dodge 2010 Viper SRT10 Manuel utilisateur
Dodge
Dodge 2016 GRAND CARAVAN Manuel utilisateur
Dodge
Dodge CHALLENGER SRT 2017 Manuel utilisateur
Dodge
Dodge 2013 VIPER SRT Manuel utilisateur
Dodge
Dodge 2016 Dart Manuel utilisateur
Dodge
Dodge Challenger SRT8 2012 Manuel utilisateur
Dodge
Dodge HORNET 2024 Manuel utilisateur
Dodge
Dodge Durango 2012 Manuel utilisateur
Dodge
Dodge Challenger 2015 Manuel utilisateur
Dodge
Dodge 2010 Journey Manuel utilisateur
Dodge
Dodge Challenger SRT8 2013 Manuel utilisateur
Dodge
Dodge 2005 Dakota Manuel utilisateur
Dodge
Dodge 2014 dodge charger Manuel utilisateur
Dodge
Dodge 2007 DR Ram Manuel utilisateur
