DFI P5BTX/L Manuel utilisateur
P5BTX/L
Rev. A+
System Board
User’s Manual
34371013
Copyright
Thispublicationcontainstheinformationthatisprotectedbycopyright.
Nopartofitmaybereproducedinanyformorbyanymeansorused
to make any transformation/adaptation without the prior written
permissionfromthecopyrightholders.
Thispublication is providedfor informational purposesonly. The
manufacturermakesnorepresentationsorwarrantieswithrespectto
thecontentsoruseofthismanualandspecificallydisclaimsanyexpress
orimpliedwarrantiesofmerchantabilityorfitnessforanyparticularpurpose.
Theuserwillassumetheentireriskoftheuseortheresultsoftheuseof
thisdocument.Further,themanufacturerreservestherighttorevisethis
publicationandmakechangestoitscontentsatanytime,withoutobligation
tonotifyanypersonorentityofsuchrevisionsorchanges.
AllRightsReserved.
Trademarks
Microsoft®MS-DOS®,WindowsTM andWindows®95areregistered
trademarksofMicrosoftCorporation.IntelandPentiumareregistered
trademarksofIntelCorporation.Cyrix,6x86,6x86Land6x86MXare
registeredtrademarksof Cyrix Corporation.AMD,K5and K6 are
registeredtrademarksofAdvancedMicroDevices,Inc. IBMisaregistered
trademarkofInternationalBusinessMachineCorporation.Awardisa
registeredtrademarkofAwardSoftware,Inc.Othertrademarksand
registeredtrademarksofproductsappearinginthismanualarethe
propertiesoftheirrespectiveholders.
Caution:
Danger of explosion if battery incorrectly replaced.
Replace only with the same or equivalent type recommended by the
manufacturer.
Dispose of used batteries according to the battery manufacturer’s
instructions.
FCC and DOC Statement on Class B
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and the receiver.
•Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
•Consult the dealer or an experienced radio TV technician for
help.
Notice:
1.The changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.
2.Shielded interface cables must be used in order to comply with
the emission limits.
TableofContents
Chapter 1 - Introduction
1.1Features and Specifications...................................................................
1.2Package Checklist.......................................................................................7
10
Chapter 3 - Award BIOS Setup Utility
3.1The Basic Input/Output System........................................................
3.1.1Standard CMOS Setup.......................................................
3.1.2BIOS Features Setup.............................................................
3.1.3Chipset Features Setup.......................................................
3.1.4Power Management Setup................................................
3.1.5PNP/PCI Configuration.......................................................
3.1.6Load Fail-Safe Settings..........................................................
3.1.7Load Optimal Settings..........................................................
3.1.8Integrated Peripherals...........................................................
3.1.9Supervisor Password............................................................
3.1.10User Password.........................................................................
3.1.11IDE HDDAuto Detection................................................
3.1.12Save & Exit Setup...................................................................
3.1.13Exit Without Saving................................................................
35
35
39
43
44
47
49
49
50
53
54
54
55
55
Chapter 2 - Hardware Installation
2.1System Board Layout .............................................................................
2.2Installation Steps..........................................................................................
2.2.1Installing System Memory........................................................
2.2.2Installing a Processor..................................................................
2.2.3Setting the Jumpers on the System Board..................
2.2.4Installing Expansion Cards......................................................
2.2.5Connecting the Ribbon Cables and Wires of the
Ports and Connectors..............................................................
2.2.6Installing the System Board....................................................
12
13
13
18
22
23
25
33
Appendix A - Identifying Processors
A.1Intel Processors...........................................................................................
A.2Cyrix Processors........................................................................................
A.3AMD Processors........................................................................................
62
62
63
Appendix B - System Error Report
B.1POST Beep...................................................................................................
B.2Error Messages............................................................................................65
65
Appendix C - Troubleshooting
C.1 Troubleshooting Checklist.....................................................................68
Chapter 4 - Supported Softwares
4.1Desktop Management Interface........................................................
4.2IDE Drivers...................................................................................................57
60
P5BTX/L System Board User’s Manual
1
6
Introduction
CHAPTER
1
Introduction
7
1.1 Features and Specifications
1.1.1 Features
Chipset
•Intel82430TX PCIset chipset
Processor
The system board is equipped with a 321-pin ZIF socket (Intel
Socket 7). This socket is designed for easy removal of an old
processor and easy insertion of an upgrade processor. The system
board is also equipped with a switching voltage regulator that
supports 2.8V to 3.5V core voltage for various processors.
•Intel Pentiumprocessor with MMXTM technology-166/200/
233MHz
•Intel Pentium90/100/120/133/150/166/200MHz
•Cyrix6x86L PR150+/PR166+ and 6x86MX-PR166/PR200
•AMDK5 PR90/PR100/PR120/PR133/PR166
•AMDK6-166, K6-200, K6-233 and future K6 processors
System Memory
The system board supports 8MB to 256MB of memory. It is
equipped with two DIMM and four SIMM sockets. The 168-pin
DIMM sockets use x64 EDO (60/70ns), fast page mode (60/70ns),
or SDRAM (10/12/13ns), 3.3V. The 72-pin SIMM sockets use EDO
or fast page mode, 60/70ns, x32 DRAM, 5V.
Level 2 Cache Memory
•512KB pipeline burst, direct map write-back cache installed on
the system board.
Expansion Slots
The system board is equipped with 4 dedicated PCI slots and 3
dedicated 16-bit ISA slots. All PCI and ISA slots are bus masters.
P5BTX/L System Board User’s Manual
1
8
Desktop Management Interface (DMI)
The system board comes with DMI 2.0 built into the BIOS. The
DMI utility in the BIOS automatically records various information
about your system configuration and stores these information in
the DMI pool, which is a part of the system board's Plug and Play
BIOS. DMI, along with the appropriately networked software, is
designed to make inventory, maintenance and troubleshooting of
computer systems easier.
Onboard I/O
•Two NS16C550A-compatible serial ports
•One SPP/ECP/EPP parallel port
•One floppy drive interface supports up to 2.88MB floppy
drives.
•One PS/2 mouse port
•One PS/2 or AT keyboard port
•One 12-pin standard AT power supply connector
PCI Bus Master IDE Controller
•Two PCI IDE interfaces support up to four IDE devices
•Ultra DMA/33 supported (Synchronous DMA mode - data
transfer rate up to 33MB/sec.)
•PIO Mode 3 and Mode 4 Enhanced IDE (data transfer rate up
to 16.6MB/sec.)
•Bus mastering reduces CPU utilization during disk transfer
•ATAPI CD-ROM supported
•LS-120 and ZIP supported
IrDA Interface
The system board is equipped with an IrDA connector for
wireless connectivity between your computer and peripheral
devices.
USB Ports
The system board is equipped with a header for external USB
ports. USB allows data exchange between your computer and a
wide range of simultaneously accessible external Plug and Play
peripherals.
1
Introduction
9
BIOS
•Award BIOS, Windows95 Plug and Play compatible
•Flash EPROM for easy BIOS upgrades
Power Supply Connector
The system board is equipped with an AT power supply connector
for connecting an AT power supply.
1.1.2 Technology
SDRAM
Synchronous Dynamic Random Access Memory (SDRAM) is a
DRAM technology that uses the clock on the chip to synchronize
with the CPU clock so that the timing of the memory chips and
the timing of the CPU are synchronized. This saves time during
transmission of data, subsequently increasing system performance.
Ultra DMA/33 Bus Master IDE
The system board supports Synchronous Ultra DMA mode that
provides data transfer rate at 33MB/sec, which is double the data
transfer rate of Enhanced IDE or ATA-2. This enables the CPU to
operate more efficiently when handling simultaneous events.
1.1.3 Intelligence
RTC Timer to Power On the System
The RTC installed on the system board allows your system to
automatically wake up on the set day and time. Set the day and
time you would like your system to power on in the “Resume By
Alarm” field (Power Management Setup) of the Award BIOS.
P5BTX/L System Board User’s Manual
1
10
Virus Protection
Most viruses today destroy data stored in hard drives. The system
board is designed to protect the boot sector and partition table
of your hard disk drive. If an attempt is made to write to the
boot sector or partition table of the hard disk drive, the BIOS will
halt the system and an error message will appear. Refer to the
“Virus Warning” field in the BIOS Features Setup section of this
manual (Chapter 3).
1.2 Package Checklist
The system board package contains the following items:
þThesystemboard
þA user’s manual
þSerial, mouse and printer port cables
Option 1:
-One card-edge bracket with a 9-pin and 25-pin serial port
cables
-One card-edge bracket with a 25-pin printer port cable
and a PS/2 mouse port cable
Option 2:
-One card-edge bracket with two 9-pin serial port cables
and a PS/2 mouse port cable
-One 25-pin printer port cable for chassis mounting
þOne 40-pin IDE hard disk cable
þOne 34-pin floppy disk drive cable
þOne utility diskette
þFive spare jumpers
¨Onecard-edge bracketwithtwoUSBports(optional)
If any of these items are missing or damaged, please contact your
dealer or sales representative for assistance.
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels DFI Carte mère
DFI
DFI AL9A2 Manuel utilisateur
DFI
DFI LR100-N16 Series Manuel utilisateur
DFI
DFI CMS630-Q470ECRM Manuel utilisateur
DFI
DFI P2XBL DE+ Manuel utilisateur
DFI
DFI NB32-SL Manuel utilisateur
DFI
DFI SB300-C Manuel utilisateur
DFI
DFI SU256-SCM Manuel utilisateur
DFI
DFI 586ITXD Manuel utilisateur
DFI
DFI KU553 Manuel utilisateur
DFI
DFI COM630-B Manuel utilisateur
DFI
DFI BE170 Manuel utilisateur
DFI
DFI BT101 Manuel utilisateur
DFI
DFI LanParty DK 790GX-M2RS Manuel utilisateur
DFI
DFI PW65-L Manuel utilisateur
DFI
DFI G586IPBS Manuel utilisateur
DFI
DFI G7V600-B Manuel utilisateur
DFI
DFI 915GL-TML Manuel utilisateur
DFI
DFI CA33-SC Manuel utilisateur
DFI
DFI DL310-C226 Manuel utilisateur
DFI
DFI SB336-Ni Manuel utilisateur
Manuels Carte mère populaires d'autres marques
Gigabyte
Gigabyte GA-9IVDT Manuel utilisateur
Texas Instruments
Texas Instruments ADS8372EVM Manuel utilisateur
Commell
Commell MS-C73 Manuel utilisateur
IBT Technologies
IBT Technologies MB860 Manuel utilisateur
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manuel utilisateur
Biostar
Biostar M7VIT Bravo Instructions d'utilisation et d'installation
