DFI K8M800 INFINITY Manuel utilisateur
K8M800 INFINITY
System Board
User’s Manual
81810436
Copyright
This publication contains information that is protected by copyright.
No part of it may be reproduced in any form or by any means or
used to make any transformation/adaptation without the prior writ-
ten permission from the copyright holders.
This publication is provided for informational purposes only. The
manufacturer makes no representations or warranties with respect to
the contents or use of this manual and specifically disclaims any
express or implied warranties of merchantability or fitness for any
particular purpose.The user will assume the entire risk of the use or
the results of the use of this document. Further, the manufacturer
reserves the right to revise this publication and make changes to its
contents at any time, without obligation to notify any person or
entity of such revisions or changes.
© 2004. All Rights Reserved.
Trademarks
Windows®98, Windows®98 SE, Windows®ME, Windows®2000,
Windows NT®4.0 and Windows®XP are registered trademarks of
Microsoft Corporation. AMD and AthlonTM are registered trademarks
of Advanced Micro Devices, Inc. VIA®is a registered trademark of
VIA Technologies, Inc. Award is a registered trademark of Award
Software, Inc. Other trademarks and registered trademarks of prod-
ucts appearing in this manual are the properties of their respective
holders.
Caution
To avoid damage to the system:
• Use the correct AC input voltage range.....
To reduce the risk of electric shock:
• Unplug the power cord before removing the system chassis
cover for installation or servicing. After installation or servicing,
cover the system chassis before plugging the power cord.
Battery:
• Danger of explosion if battery incorrectly replaced.
• Replace only with the same or equivalent type recommend
by
the manufacturer.
• Dispose of used batteries according to the battery manufactur-
er’s
instructions.
FCC and DOC Statement on Class B
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio TV technician for
help.
Notice:
1. The changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.
2. Shielded interface cables must be used in order to comply with
the emission limits.
About this Manual
This user’s manual contains detailed information about the system
board. If, in some cases, some information doesn’t match those
shown in the multilingual manual, the multilingual manual should al-
ways be regarded as the most updated version. The multilingual
manual is included in the system board package.
To view the user’s manual, insert the CD into a CD-ROM drive.The
autorun screen (Mainboard Utility CD) will appear. Click the
“TOOLS” icon then click “Manual” on the main menu.
Notice
The system board and accessories you receive in the package may
not come similar to the information stated in this manual. This may
differ in accordance to the sales region or models in which it was
sold. For more information about the standard package in your
region, please contact your dealer or sales representative.
Table of Contents
Chapter 1 - Introduction
1.1 Features and Specifications..................................................................................
1.2 Package Checklist.........................................................................................................
Chapter 2 - Hardware Installation
2.1 System Board Layout .............................................................................................
2.2 System Memory.............................................................................................................
2.3 CPU..........................................................................................................................................
2.4 Jumper Settings...............................................................................................................
2.5 Rear Panel I/O Ports................................................................................................
2.6 I/O Connectors.............................................................................................................
Chapter 3 - BIOS Setup
3.1 Award BIOS Setup Utility....................................................................................
3.2 VIA RAID BIOS............................................................................................................
3.3 Updating the BIOS.....................................................................................................
Chapter 4 - Supported Softwares
4.1 Desktop Management Interface.....................................................................
4.2 Drivers, Utilities and Software Applications.........................................
4.3 3D Audio Configuration........................................................................................
4.4 Installation Notes..........................................................................................................
7
15
51
97
98
16
17
19
25
28
40
100
103
114
115
Introduction
1
6
Appendix A - System Error Messages
A.1 POST Beep........................................................................................................................
A.2 Error Messages...............................................................................................................
Appendix B - Troubleshooting
B.1 Troubleshooting Checklist.....................................................................................
116
116
118
1
Introduction
7
1.1 Features and Specifications
1.1.1 Features
Processor
• AMD AthlonTM 64 (3400+)
• Socket 754
Chipset
• VIA®chipset
North bridge:VIA®K8M800
- 1600MTps HyperTransport interface
- Integrated UniChrome2 3D/2D graphics controller
South bridge:VIA® VT8237
- 16-bit "Ultra V-Link" host controller
- 533MB/sec.V-Link interface
Memory
• Supports single channel (64-bit wide) memory interface
• Two 184-pin DDR DIMM sockets
• Supports up to 2GB using PC2100 (DDR266), PC2700
(DDR333) or PC3200 (DDR400) unbuffered single/double-sided
DDR SDRAM DIMM
BIOS
• Award BIOS, Windows®98/2000/ME/XP Plug and Play
compatible
• Genie BIOS provides:
- CPU/DRAM overclocking
- AGP/DRAM overvoltage
• 4Mbit flash memory
• AMD Cool‘n’QuietTM technology
• Supports CMOS Reloaded which allows storing multiple user-
defined configurations to save, load and name the configurations
Chapter 1 - Introduction
Introduction
1
8
Energy Efficient Design
• Supports ACPI specification and OS Directed Power
Management
• Wake-On-Events include:
- Wake-On-PS/2 Keyboard/Mouse
- Wake-On-USB Keyboard/Mouse
- Wake-On-Ring (external modem)
- Wake-On-LAN
- RTC timer to power-on the system
• System power management supported
• CPU stopped clock control
• Hardware supports SMI green mode
• Microsoft®/Intel®APM 1.2 compliant
• Soft Power supported - ACPI v1.06 specification
• AC power failure recovery
• CPU Overheat Protection function monitors CPU temperature
and fan during system boot-up
Onboard Graphics Features
• Integrated UniChrome2 3D/2D graphics controller
• Integrated S3 Graphics with 2D/3D acceleration
- Optimized Unified Memory Architecture (UMA)
- Supports 16/32/64MB Frame Buffers size
- 200MHz Graphics Engine Clock
- 128-bit data buses between north bridge and graphics core
• Supports 2D acceleration features
• Supports 3D acceleration features
Audio Features
• AC'97 2.2 extension compliant codec
• Supports Microsoft®DirectSound/DirectSound 3D
• AC’97 supported with full duplex, independent sample rate
converter for audio recording and playback
• S/PDIF-in/out compressed digital output
• 6-channel audio output via software
1
Introduction
9
Onboard LAN Features
• Gigabit ethernet controller supports 10/100/1000Mbps
• Fully compliant to IEEE 802.3 (10BASE-T), 802.3u (100BASE-TX)
and 802.3ab (1000BASE-T) standards
• Integrated power management functions
• Supports wire for management
Serial ATA Interface with RAID
• Supports two SATA (Serial ATA) interfaces which are compliant
with SATA 1.0 specification (1.5Gbps interface)
• Supports RAID 0, RAID 1 and JBOD
IEEE 1394 Interface
• VIA VT6307 PCI 1394 integrated host controller
• Supports two 100/200/400 Mb/sec ports
IDE Interface
• Supports ATA/33, ATA/66, ATA/100 and ATA/133 hard drives
Accelerated Graphics Port (A.G.P.)
• Supports AGP 8x up to 2133MB/sec. and AGP 4x up to
1066MB/sec. bandwidth for 3D graphics applications
Rear Panel I/O Ports
• 1 mini-DIN-6 PS/2 mouse port
• 1 mini-DIN-6 PS/2 keyboard port
• 1 DB-9 serial port
• 1 DB-25 parallel port
• 1 DB-15 VGA port
• 4 USB 2.0/1.1 ports
• 1 RJ45 LAN port
• 1 IEEE 1394 port
• 3 audio jacks: line-in, line-out and mic-in
Introduction
1
10
I/O Connectors
• 2 connectors for 4 additional external USB 2.0/1.1 ports
• 1 connector for 1 external IEEE 1394 port
• 1 connector for 1 external serial port (optional)
• 1 front audio connector for external line-out and mic-in jacks
• 1 CD-in internal audio connector
• 1 S/PDIF-in/out connector
• 1 IrDA connector
• 2 Serial ATA connectors
• 2 IDE connectors
• 1 floppy connector
• 2 ATX power supply connectors
• 2 fan connectors
Expansion Slots
• 1 AGP slot
• 3 PCI slots
PCB
• 4 layers, microATX form factor
• 24.5cm (9.65") x 23cm (9.06")
1.2 Special Features of the System Board
AMD AthlonTM 64
The system board supports the AMD AthlonTM 64 processor. AMD
AthlonTM 64 provides superior computing for many software
applications by allowing both 32-bit and 64-bit applications to run
simultaneously on the same platform. The operating system and
software are able to process more data and access a tremendous
amount of memory which improves the overall system performance.
2T timing which provides better system stability is supported in CG
or later revisions of the AMD AthlonTM 64 processor. You can select
the memory timing in the “1T/2T Memory Timing” field of the BIOS.
Refer to the Advanced Chipset Features section (“DRAM
Configuration” section) in chapter 3 for more information.
Table des matières
Autres manuels DFI Carte mère
DFI
DFI 915GM-MIGF Manuel utilisateur
DFI
DFI CW35-TC Manuel utilisateur
DFI
DFI 661FX-MLV Manuel utilisateur
DFI
DFI G586VPM Manuel utilisateur
DFI
DFI P5BVP Manuel utilisateur
DFI
DFI HR100-CRM Manuel utilisateur
DFI
DFI PT630-NRM Manuel utilisateur
DFI
DFI KD171 Manuel utilisateur
DFI
DFI CS551-C246 Manuel utilisateur
DFI
DFI CA64-TC Manuel utilisateur
DFI
DFI PT332-DRM Manuel utilisateur
DFI
DFI P2MEX/A Manuel utilisateur
DFI
DFI LanParty UT NF4 SLI EXPERT Venus Manuel utilisateur
DFI
DFI MB630-CRM Manuel utilisateur
DFI
DFI CA64-SC Manuel utilisateur
DFI
DFI SD631-C236 Manuel utilisateur
DFI
DFI 845GV-MLV Manuel utilisateur
DFI
DFI G586VPS Pro Manuel utilisateur
DFI
DFI AR100-DR Manuel utilisateur
DFI
DFI P2XBL/D Manuel utilisateur
Manuels Carte mère populaires d'autres marques
Gigabyte
Gigabyte GA-9IVDT Manuel utilisateur
Texas Instruments
Texas Instruments ADS8372EVM Manuel utilisateur
Commell
Commell MS-C73 Manuel utilisateur
IBT Technologies
IBT Technologies MB860 Manuel utilisateur
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manuel utilisateur
Biostar
Biostar M7VIT Bravo Instructions d'utilisation et d'installation
