DFI G5M300-P Manuel utilisateur

G5M300-P

Rev. A+

System Board

User’s Manual

935-G5M301-000

A83300438

This publication contains information that is protected by copyright.

No part of it may be reproduced in any form or by any means or

used to make any transformation/adaptation without the prior

written permission from the copyright holders.

This publication is provided for informational purposes only. The

manufacturer makes no representations or warranties with respect to

the contents or use of this manual and specifically disclaims any

express or implied warranties of merchantability or fitness for any

particular purpose. The user will assume the entire risk of the use or

the results of the use of this document. Further, the manufacturer

reserves the right to revise this publication and make changes to its

contents at any time, without obligation to notify any person or

entity of such revisions or changes.

Trademarks

Windows®98, Windows®98 SE, Windows®ME, Windows®2000,

Windows NT®4.0 and Windows®XP are registered trademarks of

Microsoft Corporation. Intel®, Pentium®M and Celeron®M are

registered trademarks of Intel Corporation. Award is a registered

trademark of Award Software, Inc. Other trademarks and registered

trademarks of products appearing in this manual are the properties

of their respective holders.

Caution

To avoid damage to the system:

• Use the correct AC input voltage range.....

To reduce the risk of electric shock:

• Unplug the power cord before removing the system chassis

cover for installation or servicing. After installation or servicing,

cover the system chassis before plugging the power cord.

Battery:

• Danger of explosion if battery incorrectly replaced.

• Replace only with the same or equivalent type recommend

the manufacturer.

• Dispose of used batteries according to the battery manufactur-

er’s

instructions.

FCC and DOC Statement on Class B

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC rules.

These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a residential

installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio

communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio TV technician for

help.

Notice:

1. The changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority

to operate the equipment.

2. Shielded interface cables must be used in order to comply with

the emission limits.

Notice

An electronic file of this manual is included in the CD. To view the

user’s manual in the CD, insert the CD into a CD-ROM drive. The

autorun screen (Main Board Utility CD) will appear. Click “User’s

Manual” on the main menu.

Table of Contents

Chapter 1 - Introduction

1.1 Features.................................................................................................................................

1.2 Special Features of the System Board.....................................................

1.3 Package Checklist.........................................................................................................

Chapter 2 - Hardware Installation

2.1 System Board Layout ...........................................................................................

2.2 System Memory...........................................................................................................

2.3 CPU........................................................................................................................................

2.4 Jumper Settings.............................................................................................................

2.5 Rear Panel I/O Ports..............................................................................................

2.6 I/O Connectors...........................................................................................................

Chapter 3 - BIOS Setup

3.1 Award BIOS Setup Utility....................................................................................

3.2 Intel RAID BIOS Setting Utility........................................................................

3.3 Updating the BIOS.....................................................................................................

Chapter 4 - Supported Softwares

4.1 Drivers, Utilities and Software Applications.........................................

4.2 Installation Notes..........................................................................................................

100

101

103

114

Introduction

116

118

Appendix A - Watchdog Timer

A.1 Watchdog Timer.........................................................................................................

Appendix B - System Error Messages

B.1 POST Beep.....................................................................................................................

B.2 Error Messages............................................................................................................

Appendix C - Troubleshooting

C.1 Troubleshooting Checklist.................................................................................

115

Introduction

Chapter 1 - Introduction

1.1 Features

Processor

• Intel®Pentium®M / Celeron®M processor

- 400MHz system bus

- Supports 64-bit host data bus and 32-bit addressing

• Processor socket: mPGA479M

Chipset

• Intel®855GME chipset

- Intel®855GME Graphics Memory Controller Hub (GMCH)

- Intel®6300ESB I/O Controller Hub

System Memory

• Two 184-pin DDR SDRAM DIMM sockets

• 2.5V unbuffered PC1600 (DDR200), PC2100 (DDR266) or

PC2700 (DDR333) DDR SDRAM DIMM with ECC support

• Supports 128Mbit, 256Mbit and 512Mbit technologies providing

maximum capacity of 1GB with x16 devices and up to 2GB with

high density 512Mbit technology

BIOS

• Award BIOS

• Supports SCSI sequential boot-up

• Supports DMI 2.0 function

• 4Mbit flash memory

Energy Efficient Design

• Supports ACPI specification and OS Directed Power

Management

• Supports ACPI STR (Suspend to RAM) function

• Wake-On-Events include:

- Wake-On-PS/2 Keyboard/Mouse

- Wake-On-USB Keyboard

- Wake-On-LAN

- Wake-On-Ring

- RTC timer to power-on the system

• System power management supported

Introduction

• CPU stopped clock control

• Hardware supports SMI green mode

• Microsoft®/Intel®APM 1.2 compliant

• Soft Power supported - ACPI v1.0a specification

• AC power failure recovery

Damage Free Intelligence

• Monitors CPU/system temperature and overheat alarm

• Monitors 5VSB(V)/VBAT(V)/1.5V/3.3V/5V/12V/CPU(V) voltages

and failure alarm

• Monitors CPU/chassis/2nd fan speed and failure alarm

• Read back capability that displays temperature, voltage and fan

speed

• Watchdog timer function

Onboard Graphics Features

• Up to 64MB of dynamic video memory allocation

• Display core frequency at 250MHz (default)

• Render core frequency at 250MHz (default)

• Intel®Dual-Frequency Graphics Technology

• 2D graphics engine

- Optimized 128-bit BLT engine

- 32-bit Alpha Blended cursor

- 8-bit, 16-bit and 32-bit color

• 3D graphics engine

- Enhanced Hardware Binning Instruction Set

- Bi-Cubic Filtering

- Linear Gamma Blending for Video Mixer Rendering (VMR)

- Video Mixer Rendering (VMR)

- 3D setup and render engine

- DirectX and OpenGL pixelization rules

- 266-MegaTexel/s peak performance

- 16- and 24-bit Z-buffering; 16- and 24-bit W-buffering

- Optimal 3D resolution

- Double and triple render buffer

• Graphics Power Management

- Dynamic Frequency Switching

- Memory Self-Refresh During C3

- Intel®Display Power Saving Technology

Introduction

Display

• Dedicated LFP (Local Flat Panel) interface

- Supports data format up to 24-bpp

• Analog display

- 350MHz integrated 24-bit RAMDAC

- Pixel resolution up to 1600x1200 at 85Hz and up to

2048x1536 at 75Hz

LFP (Local Flat Panel) LVDS Interface

• Single- or dual-channel LVDS panel supports up to UXGA panel

resolution with frequency range from 25MHz to 112MHz (single/

dual channel)

• Integrated PWM interface for LCD backlight inverter control

Onboard Audio Features

• Realtek ALC202A 2-channel audio

• 18-bit stereo full-duplex codec with independent variable

sampling rate

• DirectSound 3DTM compatible

• S/PDIF-out interface

Onboard LAN Features

• RTL8110S Gigabit ethernet controller

• Supports 10Mbps, 100Mbps and 1Gbps data transmission

• IEEE 802.3 (10/100Mbps) and IEEE 802.3ab (1Gbps) compliant

Serial ATA Interface with RAID

• Supports two SATA (Serial ATA) interfaces which are compliant

with SATA 1.0 specification (1.5Gbps interface)

• Supports RAID 0 and RAID 1

IDE Interface

• Supports up to UltraDMA 100Mbps hard drives

• PIO Mode 4 Enhanced IDE (data transfer rate up to 14MB/sec.)

IEEE 1394 Interface

• VIA VT6307

• Supports two 100/200/400 Mb/sec ports

Introduction

Accelerated Graphics Port (A.G.P.)

• Supports 1.5V AGP 4x data transfers and 2x/4x fast write

protocol (3.3V AGP card is not supported)

• AGP 2.0 compliant

Rear Panel I/O Ports

• 1 mini-DIN-6 PS/2 mouse port

• 1 mini-DIN-6 PS/2 keyboard port

• 1 DB-25 parallel port

• 1 DB-9 serial port

• 1 DB-15 VGA port

• 1 IEEE 1394 port

• 1 RJ45 LAN port

• 4 USB 2.0/1.1 ports

• Mic-in, line-in and line-out

I/O Connectors

• 3 connectors for 3 external serial ports

• 1 connector for 1 external IEEE 1394 port

• 1 LCD brightness control connector

• 1 LVDS LCD panel connector

• 1 LCD power connector

• 1 front audio connector for line-out and mic-in jacks

• 1 CD-in internal audio connector

• 1 S/PDIF-out connector

• 1 connector for IrDA interface

• 2 Serial ATA connectors

• 2 40-pin IDE connectors

• 1 floppy connector

• 1 ATX power supply connector

• 1 front panel connector

• 3 fan connectors

Expansion Slots

• 1 AGP 4x slot

• 1 PCI-X slot

• 2 PCI slots

Table des matières

Autres manuels DFI Carte mère

Manuels Carte mère populaires d'autres marques

ASROCK

ASROCK ROMED8-2T Manuel utilisateur

Asus

Asus P2L97A Manuel utilisateur

Winmate

Winmate IC70 Manuel utilisateur

Asus

Asus MES-B Manuel utilisateur

Grantech

Grantech SYS8F377VGGA-3OMN Manuel utilisateur

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manuel utilisateur

Gigabyte

Gigabyte GA-9IVDT Manuel utilisateur

Texas Instruments

Texas Instruments ADS8372EVM Manuel utilisateur

Commell

Commell MS-C73 Manuel utilisateur

IBT Technologies

IBT Technologies MB860 Manuel utilisateur

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manuel utilisateur

Biostar

Biostar M7VIT Bravo Instructions d'utilisation et d'installation

Intel

Intel D33217CK Manuel utilisateur

Asus

Asus F1A55-M LX PLUS R2.0 Manuel utilisateur

EPC

EPC EPC9147C Manuel utilisateur

Asus

Asus EX-B760M-V5 D4 Manuel utilisateur

EPOX

EPOX MU-8KHA0010 Manuel utilisateur

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Manuel utilisateur