Deye BOS-G Series Manuel du propriétaire
Installation and Operation Instructions
LITHIUM STORAGE SYSTEM
BOS-G
Version：V1.3
1
CONTENT
1. Important information in the manual ............................................................................................ 3
1.1 Scope................................................................................................................................... 3
1.2 Description of BOS-G...........................................................................................................3
1.3 Meaning of symbols............................................................................................................ 4
1.4 General safety information................................................................................................. 6
1.5 Disclaimer ............................................................................................................................ 6
1.6 Installation environment.....................................................................................................7
1.7 Quality Certificate................................................................................................................8
1.8 Requirements for Installation Personnel........................................................................... .8
2. Safety.............................................................................................................................................. 9
2.1 Safety rules.......................................................................................................................... 9
2.2 Safety information...............................................................................................................9
3. Transport to the end customers..................................................................................................10
3.1 Provisions on Shipping of Battery Modules……………………………………………………………....…10
3.2 Permissible and Impermissible Storage Positions of a Packaged Battery module…………12
4. Description and Installation of BOS-G battery…………………………………....………………………………....12
4.1 Installation precautions.....................................................................................................12
4.2 BOS-G product description……………………………………………………………………………………………13
4.3 Technical data....................................................................................................................13
4.4 Preparation........................................................................................................................14
4.4.1 Tools required............................................................................................................ 14
4.4.2 Auxiliary Tools and Matenials Required.................................................................... 14
4.5 Description of rack............................................................................................................ 15
4.5.1 3U-HRack Parts description.......................................................................................15
4.5.2 Installation of Rack ..................................................................................................16
4.6 Description of battery module..........................................................................................21
4.7 Description of high-voltage control box............................................................................21
4.8 Description of battery module in rack.............................................................................. 22
4.9 Installation of the battery module to the rack……………….………………………………………..…..24
4.9.1 Cable connection....................................................................................................... 26
4.9.2 Battery installation cable Description....................................................................... 27
4.10 Battery cluster connected tu inverter.............................................................................28
4.11 System startup and shutdown ..........................................................................................32
4.12 Procedure for configuring bettery packs........................................................................ 33
4.13 External 12V power supply of high-voltage control box ............................................... 35
5. BOS-G's user interface..................................................................................................................35
5.1 Main interface................................................................................................................... 35
5.2 Description of user interface.............................................................................................36
5.3 Fault viewing interface...................................................................................................... 37
5.4 Maintenance interface...................................................................................................... 38
6. BOS-G's fault description ..............................................................................................................39
7. Summary of fault types in BOS-G's screen and HVESS-Monitor..................................................42
8. Maintenance and upgrade........................................................................................................... 44
2
8.1 Maintenance of BOS-G......................................................................................................44
8.2 USB's upgrade step............................................................................................................45
9. Battery module storage................................................................................................................45
10. Disposal.......................................................................................................................................46
11. Appendix .....................................................................................................................................47
11.1 Circuit diagram for on grid system with 12V supply.......................................................47
11.2 System circuit diagram……………………………………………………….………………..…...................48
12 Legal notice………………………………………………………………………………………………………….……………….49
3
1.Important information in the manual
1.1 Scope
The installation and operation manual applies to the modular battery energy storage system.
Please carefully read this installation and operation manual to ensure the safe installation,
preliminary debugging, and maintenance of BOS-G. Installation, preliminary debugging, and
maintenance must be carried out by qualified and authorized personnel. Please keep this
installation and operation manual and other applicable documents near the battery energy
storage system, so that all personnel involved in installation or maintenance can access this
installation and operation manual at any time.
This installation and operation manual only applies to countries meeting the certification
requirements. Please observe the applicable local laws, regulations, and standards. Standards
and legal provisions of other countries may be inconsistent with the provisions and specifications
in this manual. In this case, please contact our after-sales service personnel, hotline: +86 0574
1.2 Description of BOS-G
Model
System
energy
(kWh)
Rated DC power
（kW）
Discharge depth
Composition
BOS-G15
15.36
15.36
90%
BOS-GM5.1*3+HVB750V/100A*1
BOS-G20
20.48
20.48
90%
BOS-GM5.1*4+HVB750V/100A*1
BOS-G25
25.6
25.6
90%
BOS-GM5.1*5+HVB750V/100A*1
BOS-G30
30.72
30.72
90%
BOS-GM5.1*6+HVB750V/100A*1
BOS-G35
35.84
35.84
90%
BOS-GM5.1*7+HVB750V/100A*1
BOS-G40
40.96
40.96
90%
BOS-GM5.1*8+HVB750V/100A*1
BOS-G45
46.08
46.08
90%
BOS-GM5.1*9+HVB750V/100A*1
BOS-G50
51.2
51.2
90%
BOS-GM5.1*10+HVB750V/100A*1
BOS-G55
56.32
56.32
90%
BOS-GM5.1*11+HVB750V/100A*1
BOS-G60
61.44
61.44
90%
BOS-GM5.1*12+HVB750V/100A*1
4
1.3 Meaning of Symbols
This manual contains the following types of warnings:
Danger! It may cause an electric shock.
Even when the equipment is disconnected from the power grid, the voltage-free
state will have a time lag.
Danger! If the instructions are not observed, death or severe injury may
occur.
Warning! If the instructions are not observed, a loss may occur.
Attention! This symbol represents information on the device use.
Symbols on equipment:
The following types of warning, prohibition, and mandatory symbols are also used on
the equipment.
Attention! The risk of chemical burns
If the battery is damaged or fails, it may lead to electrolyte leakage, which in turn causes the
formation of a small amount of hydrofluoric acid, among other effects. Contact with these liquids
can cause chemical burns.
• Do not subject the battery module to severe impact.
• Do not open, disassemble or mechanically change the battery module.
• In case of contact with an electrolyte, wash the affected area with clean water immediately and
seek medical advice promptly.
Attention! The risk of explosion
Incorrect operation or fire may cause the lithium-ion battery unit to ignite or explode, leading to
serious injury.
• Do not install or operate the battery module in explosive or high-humidity areas.
5
• Store the battery module in a dry place within the temperature range specified in the data
sheet.
• Do not open, drill through or drop the battery cell or module.
• Do not expose the battery cell or module to high temperatures.
• Do not throw the battery cell or module into the fire.
• If there is a fire from the battery, please use the CO2 extinguisher. If there is a fire near the
battery, please use a dry powder extinguisher.
• Do not use defective or damaged battery modules.
Caution! Hot surface
• If a malfunction occurs, the parts will become very hot, and touching them may cause serious
injury.
• If the energy storage system is defective, please shut it down immediately.
• If the fault or defect becomes obvious, special care should be taken when handling the
equipment.
No open fire! It is prohibited to handle open flames and ignition sources near the
energy storage system.
Do not insert any objects into the opening in the housing of the energy storage system!
No objects, such as screwdrivers, may be inserted through openings in the casing of the storage
system.
Wear safety goggles! Wear safety goggles when working on the equipment.
Follow the manual! When working and operating the equipment, the installation
and operation manual provisions must be observed.
6
1.4 General Safety Information
Danger! Failure to comply with the safety information can lead to
life-threatening situations.
1. Improper use can cause death. Operators of BOS-G must read this manual and observe all
safety information.
2. Operators of BOS-G must comply with the specifications in this manual.
3. This manual cannot describe all conceivable situations. For this reason, applicable standards
and relevant occupational health and safety regulations are always given priority.
4. In addition, the installation may involve residual hazards in the following circumstances:
• Incorrect installation.
• The installation is carried out by personnel who did not receive relevant training or guidance.
• Failure to observe the warnings and safety information in this manual.
If there are any questions, please contact Deye after service.
1.5 Disclaimer
DEYE ESS TECHNOLOGY CO., LTD shall not be liable for personal injury, property loss, product
damage and subsequent losses under the following circumstances.
• Failure to comply with the provisions of this manual.
• Incorrect use of this product.
• Unauthorized or unqualified personnel repair the product, disassembly the rack and perform
other operations.
• Use of unapproved spare parts.
• Unauthorized modifications or technical changes to the product.
7
1.6 Installation environment
• The battery energy storage system can only be installed and operated in an enclosed space. The
working environment temperature range of BOS-G is -20℃~ 55℃, and the maximum humidity is
85%. The battery module shall not be exposed to the sun or placed directly beside the heat
source.
• The battery module shall not be exposed to a corrosive environment.
• When installing the battery energy storage system, ensure that it stands on a sufficiently dry
and flat surface with sufficient bearing capacity. Without the manufacturer’s written approval,
the installation site’s altitude shall not be higher than 2,000 meters. The output power of the
battery decreases with the altitude.
• In areas where flooding may occur, care must be taken to ensure that the battery module is
installed at a suitable height and to prevent its contact with water.
• The battery energy storage system must be installed in a fireproof room. This room must have
no fire source and must be equipped with an independent fire alarm device, which complies with
local applicable regulations and standards. According to local applicable regulations and
standards, the room must be separated by the T60 fire door. Similar fire-proof requirements
apply to other openings in the room (such as windows).
Minimum product installation distance
The minimum distance to the surrounding building when the battery is installed is
600mm, and the minimum distance between the two products is 100mm.
8
Compliance with the specifications in this manual is also part of proper use.
The use of the BOS-G system is prohibited in the following circumstances:
• Mobile use on land or in the air (use on water only with the manufacturer's consent and with
the manufacturer's written consent).
• Used in medical devices.
• Used as a UPS system.
1.7 Quality Certificate
The quality certificate can be downloaded from www.deyeess.com.
1.8 Requirements for Installation Personnel
All work shall comply with local applicable regulations and standards.
The installation of BOS-G can only be completed by electricians with the following qualifications:
9
• Trained in dealing with hazards and risks associated with the installation and operation of
electrical equipment, systems, and batteries.
• Trained on installation and debugging of electrical equipment.
• Understanding and complying with the technical connection conditions, standards, guidelines,
regulations, and laws applicable.
• Knowledge of handling lithium-ion batteries (transportation, storage, disposal, hazard source).
• Understanding and complying with this document and other applicable documents.
2. Safety
2.1 Safety rules
To avoid property damage and personal injury, the following rules shall be followed when
working on the hazardous live parts of the battery energy storage system:
• It is available for use.
• Ensure that it will not restart.
• Make sure there is no voltage.
• Grounding protection and short circuit protection
• Cover or shield adjacent live parts.
2.2 Safety information
Part damage or short circuit may cause electric shock and death. A short circuit can be caused by
connecting battery terminals, resulting in current flow. This type of short circuit shall be avoided
under any circumstances. For this reason, follow these instructions:
• Use insulated tools and gloves.
• Do not put any tools or metal parts on the battery module or high-voltage control box.
• When operating the battery, be sure to remove watches, rings, and other metal objects.
Ce manuel convient aux modèles suivants
10
Table des matières
Autres manuels Deye Stockage
Manuels Stockage populaires d'autres marques
Spectra Logic
Spectra Logic T-Series Spectra T50e Manuel utilisateur
Panasonic
Panasonic LKM-F931-1 Manuel utilisateur
Tabernus
Tabernus Enterprise Erase E2400 Manuel utilisateur
Rocstor
Rocstor COMMANDER 3F series Manuel utilisateur
HP
HP P9000 Manuel utilisateur
Western Digital
Western Digital Ultrastar Data60 Manuel utilisateur