Delta Electronics Pulse Generator Card EME-PG01 Manuel utilisateur

2007-07-09

5011659701-TPG1

EME-PG01 Pulse Generator Card for VFD-E Series Instruction Sheet

Please thoroughly read this instruction sheet before installing option cards and putting them into use.

The content of this instruction sheet may be revised without prior notice. Please consult our distributors or download the

most updated version at http://www.delta.com.tw/industrialautomation.

XLayout

PG Card (EME-PG01)

Pulse Fe ed ba ck Pulse O utp ut

YInstallation

 Make sure that the AC Motor Drive is powered off before operation.

DO NOT insert or remove the card when the AC Motor Drive is

powered on.

 Please mount the extension card as shown and fix it with the screw

packed with the card.

Screw torque:

Maximum 2kgf-cm

 Terminals Screw Torque: Maximum 2kgf-cm

 Wire Length

Types of Encoder Output Maximum Length Wire Gauge

Voltage 50m

Open Collector 50m

Line Driver 300m

Complementary 70m

14 ~ 24 AWG

(2.1 ~ 0.2 mm2 )

NOTE

 EME-PG01 needs additional power source DC 5 ~ 24V, as to

details please refer to table of terminals descriptions.

 Only when the extension card is correctly installed on the AC

Motor Drive, the extension card will be automatically detected.

The parameters can be set in Group 13. If extension card is not

installed, only parameters Group 0 ~ Group 10 can be set.

Refer to Chapter 5: Parameters in the user manual for further

details.

ZNotes

 Please use a shielded cable to prevent interference. Do not run

control wires parallel to any high voltage AC power line (200 V and

above).

 The wire length and signal frequency are in inverse proportion.

 Always use this product in a clean indoor location free from dust,

corrosive gas and liquid.

 When the relays are used to switch inductive loads (relays,

contactors, motors, etc), connect an RC network or Varistor parallel

to the load to suppress voltage spikes.

 For safety, it is recommended to use fuses for the circuitry that is

switched by the relays. The fuse specification must be within the

specified contact limits.

 The ends of wires must be tinned or crimped.

 To avoid interference, route the extension card wires separately and

as far away (at least 15cm) as possible from other control wires,

motor wires and power wires, etc. Where these wires must cross

each other, please make sure they are at a 90o angle.

 Always use and operate this product within the limit of its

specifications.

[Specification

 Environmental

Operating Temperature -10oC to 50oC (non-condensing and not frozen)

Storage Temperature -20oC to + 60oC

Ambient Humidity Less than 90%RH (non-condensing)

Installation Altitude Below 1000m

Vibration Below 20 Hz: Maximum 9.81 m/s2(1G);

20 ~ 50Hz: Maximum 5.88 m/s2(0.6G)

 Terminals Descriptions

Terminal S

mbols Descri

tions

Vcc

Input Voltage: DC 5 ~ 24V

When the encoder output type is voltage output,

input voltage is DC 12 ~ 24V

0V Power source and input signal common

Input signal from the encoder. Input type is selected

by SW2. It can be 1-phase or 2-phase input.

Maximum 300KP/sec

A/O, B/O Output signal from the encoder.

Open collector: max. output DC24V 50mA

Grounding

\Types of Encoder Output

Types of Encoder

Out

ut SW2 Wiring Diagram

Voltage

O/P

VCC

Line driver

Complementary

O/P

VCC

R(L1)

S(L2)

T(L3)

NFB

U(T1)

V(T2)

W(T3)

otor

FD-E

Vcc

B/O

RPM Meter

*The power source of RPM meter

is supplied by the customers.

EME-PG01

5~24V

GND

Vin

O/P

VCC

R(L1)

S(L2)

T(L3)

NFB

U(T1)

V(T2)

W(T3)

otor

FD-E

Vcc

B/O

RPM Meter

*The power source of RPM meter

is supplied by the customers.

EME-PG01

5~24V

GND

Vin

Open

collector

Note: Based on the design, the input signal terminals from

the encoder should be connected to the terminals

and

on EME-PG01 card, not the terminals of

A and B, so as to avoid damage to the encoder.

EME-PG01 VFD-E 系列之 PG 速度回授卡說明書

請詳細閱讀下列說明後才使用本產品，以確保使用安全。

由於產品精益求精，當內容規格有所修正時，請洽詢代理商或至台達網站(http://www.delta.com.tw/industrialautomation/)下載最新版本。

X外觀

PG 卡(EME-PG01)

脈波回授脈波輸出

Y安裝方式

 安裝前請確認驅動器在斷電狀態下。

 請以下圖方式安裝擴充卡並使用包裝內的螺絲固定以避免擴充卡鬆

脫。

螺絲扭力

Maximum 2kgf-cm

 端子螺絲扭力︰Maximum 2kgf-cm

 線徑線長

編碼器輸出型式最大長度線徑

電壓輸出型 Voltage 50m

開集極型 Open Collector 50m

差動型 Line Driver 300m

互補型 Complementary 70m

AWG14 ~ 24

(2.1 ~ 0.2mm2)

NOTE

 EME-PG01 需外加電源 DC 5 ~ 24V，詳細規格請參考端子規格表。

 若擴充卡正確安裝至變頻器上，變頻器將會自動偵測擴充卡且可使用

參數群 13(Group 13)設定。如沒有安裝擴充卡的話，參數只有 Group

0 ~ Group 10 可設定。詳細參數設定請參考使用手冊第五章參數說明。

Z注意事項

 為防止干擾請務必使用有被覆的隔離線，且不可與 AC200V 以上的回

路並排。

 配線的長度 (與訊號頻率成反比關係)。

 請使用此產品於無腐蝕性氣體、液體及無塵垢的室內。

 連接電感性負載（繼電器，電磁接觸器，馬達等）時，請加裝火花消

除器(RC network or Varistor)於線圈側。

 基於安全考量，請於迴路內加裝保險絲（規格不可大於接點限制）。

 線頭請吃錫或打端子。

 基於安規上的考量，配線請保持獨立且與其它控制線，馬達線，電源

線等保持 15cm 以上距離，如有交錯的必要請保持垂直配線。

 任何時刻的操作皆不可超過規格上的限制。

[規格

 環境

操作溫度 -10oC to 50oC（無結露且無結凍）

儲存溫度 -20oC to + 60oC

環境溼度 90%RH 以下（無結露）

安裝高度低於 1000m

震動 20 Hz 以下: Maximum 9.81 m/s2 (1G);

20 ~ 50Hz: Maximum 5.88 m/s2(0.6G)

 端子規格

端子說明

Vcc 輸入電壓範圍：DC 5 ~ 24V

編碼器形式為電壓輸出型Voltage output 時電壓輸入範圍需

為DC 12 ~ 24V

0V 電源及信號共同點

編碼器回授信號輸入端子（可由 SW2 選擇編碼器型式）

可單相輸入或二相輸入，最高可接受 300KP/Sec

A/O, B/O 編碼器信號輸出

開極集輸出最大 DC24V 50mA

接地端子

\可搭配編碼器輸出的型式

編碼器輸出型式

SW2

開關

位置配線圖

電

壓

輸

出

O/P

VCC

差

動

型

互

補

型

O/P

VCC

R(L1)

S(L2)

T(L3)

無熔絲斷路器

NFB

U(T1)

V(T2)

W(T3)

馬達

FD-E

Vcc

B/O

RPM

錶

*RPM

錶的電源

由客戶自行提供

EME-PG01

5~24V

GND

Vin

O/P

VCC

R(L1)

S(L2)

T(L3)

無熔絲斷路器

NFB

U(T1)

V(T2)

W(T3)

馬達

FD-E

Vcc

B/O

RPM

錶

*RPM

錶的電源

由客戶自行提供

EME-PG01

5~24V

GND

Vin

開

集

極

輸

出

注意：因設計問題，編碼器輸入需接在 EME-PG01 卡的

及

端子，

不可接在 A,B 端子，以免編碼器燒毀。

Autres manuels Delta Electronics Matériel informatique

Delta Electronics

Delta Electronics TDHCB Manuel utilisateur

Delta Electronics

Delta Electronics Ignition Coil IGT002 Manuel utilisateur

Delta Electronics

Delta Electronics PFC Chokes PFC4818V Series Manuel utilisateur

Delta Electronics

Delta Electronics SMT Power Inductor 13100 Manuel utilisateur

Delta Electronics

Delta Electronics Series Temperature Controller DTD Series Manuel utilisateur

Delta Electronics

Delta Electronics SMT Power Inductor MPL13X Manuel utilisateur

Delta Electronics

Delta Electronics Communication Module RTU-485 Manuel utilisateur

Delta Electronics

Delta Electronics Suppression Inductors LFU09V Manuel utilisateur

Delta Electronics

Delta Electronics Terminal Panels Series TP04G-AS2 Manuel utilisateur

Delta Electronics

Delta Electronics AC Motor Drive VFD-M Manuel utilisateur

Delta Electronics

Delta Electronics PFC Chokes PFC3515V Series Manuel utilisateur

Delta Electronics

Delta Electronics Power Output Module DVPPS01 Manuel utilisateur

Delta Electronics

Delta Electronics DVPAETB-ID32A/OR16A Manuel utilisateur

Delta Electronics

Delta Electronics PFC Chokes PFC4120V Series Manuel utilisateur

Delta Electronics

Delta Electronics Through Hole Power Inductors 1411 Instructions d'installation

Delta Electronics

Delta Electronics Igniter IGT006 Manuel utilisateur

Delta Electronics

Delta Electronics Ignition Coil IGT004 Manuel utilisateur

Delta Electronics

Delta Electronics IPM- C Series Manuel utilisateur

Delta Electronics

Delta Electronics TDHCB Manuel utilisateur

Delta Electronics

Delta Electronics PFC Chokes PFC2811V Series Manuel utilisateur

Delta Electronics

Delta Electronics SMT Power Inductor STQ127 Instructions d'installation

Delta Electronics

Delta Electronics Network Device TDV Manuel utilisateur

Delta Electronics

Delta Electronics SIW75 Series SIW75 Instructions d'installation

Delta Electronics

Delta Electronics Suppression Inductors LFZ24H Manuel utilisateur

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

Intel

Intel NUC 12 Pro Manuel utilisateur

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Intel

Intel AXXRMFBU4 Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur