DeLonghi TCH8093ER Manuel utilisateur

De’Longhi Appliances via Seitz, 47 31100 Treviso Italia

5711411701/04.14_00

Proudly distributed by

De’Longhi Australia Pty Limited

P.O. BOX 4540

CASULA MALL NSW 2170

Customer Service Ph: 1800 126 659

Fax: 1800 706932

www.delonghi.com.au

e-mail: [email protected]

De’Longhi New Zealand Limited

25 Carbine Road

Mt Wellington

Auckland, New Zealand

P.O. Box 58-056 Botany

MANUKAU 2163

Customer Service Ph: 0508 200 300

Fax: 0508 200 301

www.delonghi.com.nz

e-mail:[email protected]

TCH8093ER

CERAMIC FAN HEATER

Instructions for use

DESCRIPTION

Fig. 1

Fig. A

Fig. D

Fig. C

Fig. B

IMPORTANT WARNINGS

Safety warnings

Danger!

- The appliance must not be placed im-

mediately under a xed power socket.

- Do not use the appliance near show-

ers, bathtubs, sinks, swimming pools,

etc.

- If the power cable is damaged, it must

be replaced by the manufacturer, an

authorised service centre or a qualied

electrician in order to eliminate all risk.

Important!

- This appliance can be used by children

aged from 8 years and above and per-

sons with reduced physical, sensory or

mental capabilities or lack of experien-

ce and knowledge if they have been

given supervision or instruction con-

cerning use of the appliance in a safe

way and understand the hazards in-

volved. Children shall not play with the

appliance. Cleaning and user mainte-

nance shall not be made by children

without supervision.

- Children of less than 3 years should be

kept away unless continuously super-

vised.

- Children aged from 3 years and less

than 8 years shall only switch on/o

the appliance provided that it has been

placed or installed in its intended nor-

mal operating position and they have

been given supervision or instruction

concerning use of the appliance in a

safe way and understand the hazards

involved. Children aged from 3 years

and less than 8 years shall not plug

in, regulate and clean the appliance or

perform user maintenance.

CAUTION — Some parts of this

product can become very hot and

cause burns. Particular attention

has to be given where children

and vulnerable people are pre-

sent.

- ATTENTION: To avoid the safety sy-

stem resetting accidentally, this ap-

pliance must not be powered through

an external on/o device such as a

timer, or connected to a circuit which

is turned o and on regularly by the

energy supplier.

- Do not use the appliance in small

rooms when they are occupied by

persons that are not capable of leaving

the room, unless constant supervision

is provided.

Danger of burns!!

- WARNING: To avoid overhe-

ating, never under any cir-

cumstances cover the appliance

during operation as this would lead to

a dangerous rise in temperature.

Please note:

- Always use the appliance in an upright position.

- The use of extension leads is not recommended.

However if they cannot be avoided, follow the instruc-

tions accompanying the extension lead and never

exceed the power limit marked on the extension.

- The heater must be positioned at least 50 cm from furni-

ture or other objects.

- Do not use the appliance in rooms with a oor area of

less than 4m2.

- Before putting the appliance away, make sure it is com-

pletely o and unplugged from the mains socket. Wrap

the cable around the base.

Do not store in dusty atmospheres.

- Do not rest anything on the appliance.

- Do not use the appliance to dry laundry. Do not obstruct

the air intake and outlet grilles (danger of overheating).

- Do not use the appliance near walls, furniture, curtains,

etc.

INTRODUCTION

Thank you for choosing a De’Longhi product.

Please take a few minutes to read these instructions.

This will avoid all risks and damage to the appliance.

Symbols used in these instructions

Important warnings are identied by the symbols below.

It is important to respect the warnings. Failure to respect

the warnings could lead to electric shock, serious injury,

burns, re or damage to the appliance.

Danger!

Failure to observe the warning may result in life

threatening injury by electric shock.

Important!

Failure to observe the warning could result in injury or

damage to the appliance.

Danger of burns!!

Failure to observe the warning could result in burns or

scalds.

Please note:

This symbol indicates recommendations and important

information for the user.

Safety functions

-Safety device: the appliance is tted with a safety

device which switches it o in the event of accidental

overheating (e.g. obstruction of air intake and outlet

grilles, motor turning slowly or not at all). To reset,

unplug the appliance from the mains socket for a few

minutes, remove the cause of overheating then plug

in again.

-Tip over safety device: a tip over safety device

turns the appliance o if it falls over or is positioned

inappropriately in such a way as to jeopardise safety.

The appliance emits a beep and a dot ashes on the

display. The appliance resumes operation a few se-

conds after being placed in an upright position again.

DESCRIPTION

(see g. 1)

A ON/STAND-BY button

B +/- adjustment buttons

C MODE button (selects the operating mode)

D “ECO plus”button

E Timer button

F Swing button

G Remote control receiver

H Indicator light

I Air intake grille

J Filter

USE

Installation

- The appliance can be used on any horizontal surface.

Do not overload the electrical circuit. Avoid using the

same socket for other appliances.

Electrical connection

-Before plugging the appliance into the mains socket,

check that the mains power supply corresponds to

the value indicated on the rating plate and that the

mains power supply is adequate for the load.

- THIS APPLIANCE COMPLIES WITH DIRECTIVE

2004/108/EEC ON RADIO INTERFERENCE

SUPPRESSION.

Mounting the base

- Fit the two parts of the base together, matching the

guide pins on the front with the recesses on the back

and snapping the two clips into place (g. A and g. B).

- Turn the appliance upside down and position the

assembled base on the appliance in order to couple

the two openings with the two tabs on the appliance,

tilting it as shown in gure C, consequently turn the

base down till the two frontal teeth snaps into position.

Operation and use

1. Plug into the mains socket.

2. The appliance emits a beep. The indicator light (H)

comes on and remains lit while the appliance is

powered.

3. The appliance switches to stand-by. A dot ashing

on the display means the tip over device has been

activated. See paragraph:“Safety functions”.

4. Press the ON/STAND-BY (A) to turn the appliance on.

It begins heating the room according to the current

settings.

5. Press the MODE button (C) to select one of the

following operating modes:

Fan

Freeze prevention

Heating 1

Heating 2

Heating 3

5.1 Fan

In this mode, only the fan operates and the

appliance does not heat the room.

5.2 Freeze prevention

In this mode, the appliance keeps the room at a

temperature of 7°C to avoid freezing.

5.3 Heating 1, 2 and Heating 3

In this mode, the desired temperature can be

selected by pressing the adjustment buttons +

and – ( B ). By pushing the + or - button once,

the temperature (shown on the display) will

increase or decrease by 1°C.

Heating 1

The appliance operates at low power, reducing

noise levels and energy consumption to a

minimum.

Heating 2

The appliance operates at medium power.

Heating 3

The appliance operates at high power to heat

the room rapidly. The setting temperature range

available is from 16°C to 32°C.

6. “ECO plus” function

The “ECO plus” function is available in Heating 1, 2 and 3

modes only. To activate the function, press the “ECO plus”

button (D).

When this function is active the appliance automatically

sets the most appropriate power level to guarantee

optimum comfort while reducing energy consumption.

While the “ECO plus”function is active, the appliance may

switch automatically to a lower heating power than the

one displayed. This may happen a number of times in an

hour.

7. To distribute the air ow over a wider surface, press

the swing button (F). The appliance starts

swinging to the right and left. To stop the appliance

in the desired position, simply press the swing button

(F) again.

8. To turn the appliance o, press the ON/STAND-BY

button (A). The display may visualize a countdown

for about 6 seconds.

Please note: Room temperature can be displayed in

either °C or °F. To change the unit of measurement for the

temperature, press the + button for a few seconds, then

release.

Digital 24 h timer

This function can be activated from any operating mode.

Auto-start: with the appliance in STAND-BY, press

the timer button (E) . The symbol is displayed

together with the time remaining before the appliance

comes on.To adjust the timer, use the adjustment buttons

+ and - (B), then wait a few seconds for the setting to be

memorised. The stand-by light (H) is displayed together

with the symbol, indicating that the timer has been

set.When the programmed time is reached, the appliance

comes on with the settings used during the previous

period of operation.

Auto-o: with the appliance on, press the timer button

(E). The symbol is displayed together with the

time remaining before the appliance goes o. To set the

timer, use the adjustment buttons + and - (B), then

wait a few seconds for the setting to be memorised. The

current settings are displayed again, together with the

symbol indicating that the timer has been set. When

the programmed time is reached, the appliance goes o

automatically. To go back to operation without the timer,

press the timer button (E) twice.

The timer symbol disappears from the display.

Using the remote control

The functions on the remote control are the same as

those on the appliance control panel. For a description of

the functions, see the “Operation and use”section on the

previous page.

Inserting or replacing the batteries

The remote control is powered

by a CR2032 lithium battery.

To operate the remote

control, pull and remove

the plastic strip under the

battery cover. To replace the

batteries, remove the battery

cover by sliding it as shown

in the gure. When replacing

the batteries, make sure you

respect the polarity (see

gure 2).

Fig. 2

Replace the cover as shown in the gure. Old batteries are

harmful to the environment and must be removed and

disposed of in compliance with current legislation.

MAINTENANCE

- Always unplug from the mains socket before

cleaning.

- During the season when the appliance is in use, clean

the air intake and outlet grilles regularly using a

vacuum cleaner.

- To clean the lter, remove the rear grille by pulling

it outwards (g. 1). Remove the dust lter which

retains impurities in the air drawn in from the room,

blow on it lightly then replace in the appliance.

- Never use abrasive powders or solvents to clean the

appliance.

TECHNICAL CHARACTERISTICS

Power supply See rating plate

Absorbed power “

PROBLEM CAUSE SOLUTION

PF display and emits a beep Temperature sensor is not working

properly

The product needs to be serviced, contact

our toll free number for assistance

Product doesn’t turn on Check that the plug is connected to the

outlet

Auto-start is on

Room temperature reaches the set

temperature

Plug in

Wait till time elapsed or press the but-

ton (E) twice to cancel the auto-start

and push the button (A)

Use the “+” button to increase the set

temperature

The appliance goes o unexpectedly Check that the plug is connected to the

outlet

The set temperature has been reached

or the time set on the timer has elapsed

Plug in

A green dot is ashing and unit is o The tip-over switch has been activated Make sure the appliance is standing

upright on a at surface, if the problem

persists contact our toll free number to

assist you

TROUBLESHOOTING

Autres manuels pour TCH8093ER

Table des matières

Autres manuels DeLonghi Chauffage

DeLonghi

DeLonghi DR 18TTW Manuel utilisateur

DeLonghi

DeLonghi MG7307CMM Manuel utilisateur

DeLonghi

DeLonghi HTF 3031 Guide de dépannage

DeLonghi

DeLonghi HFX66V15C Manuel utilisateur

DeLonghi

DeLonghi STRETTO Manuel utilisateur

DeLonghi

DeLonghi 6507L Manuel d'instructions d'installation

DeLonghi

DeLonghi DFH2550TB Manuel utilisateur

DeLonghi

DeLonghi HWB Series Manuel utilisateur

DeLonghi

DeLonghi ELECTRIC HEATING CONVECTOR Manuel utilisateur

DeLonghi

DeLonghi TRD40820 Manuel utilisateur

DeLonghi

DeLonghi TRRS1225C Manuel utilisateur

DeLonghi

DeLonghi CERAMIC FAN HEATER Manuel utilisateur

DeLonghi

DeLonghi Professional FDL3-i SLIM Mode d'emploi

DeLonghi

DeLonghi PALACE 1800/2 Manuel d'installation et d'exploitation

DeLonghi

DeLonghi TRD Series Manuel utilisateur

DeLonghi

DeLonghi OIL FILLED RADIATORS Manuel utilisateur

DeLonghi

DeLonghi HVF3533 Manuel utilisateur

DeLonghi

DeLonghi DCH4120 Manuel utilisateur

DeLonghi

DeLonghi TCH Series Manuel utilisateur

DeLonghi

DeLonghi DCH6031 Manuel utilisateur

DeLonghi

DeLonghi TRD4 Manuel utilisateur

DeLonghi

DeLonghi RADIANT LPG GAS HEATER Guide rapide

DeLonghi

DeLonghi TRD50615E Manuel utilisateur

DeLonghi

DeLonghi DCH6031 Manuel utilisateur

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur