Dell PowerEdge FE600W Manuel utilisateur

www.dell.com | support.dell.com

Dell|EMC CX3-series

Fibre Channel Storage Arrays With

Microsoft®Windows Server®

Failover Clusters

Hardware Installation and

Troubleshooting Guide

Notes, Notices, and Cautions

NOTE: A NOTE indicates important information that helps you make better use

of your computer.

NOTICE: A NOTICE indicates either potential damage to hardware or loss of

data and tells you how to avoid the problem.

CAUTION: A CAUTION indicates a potential for property damage, personal

injury, or death.

___________________

Information in this document is subject to change without notice.

ReproductioninanymannerwhatsoeverwithoutthewrittenpermissionofDellInc.isstrictlyforbidden.

Trademarks used in this text: Dell, theDELL logo, PowerEdge, PowerVault, and Dell OpenManage

are trademarks of Dell Inc.; Active Directory, Microsoft,Windows,Windows Server,and

Windows NTareeithertrademarksorregisteredtrademarksofMicrosoftCorporationintheUnited

States and/or other countries.; EMC, EMC ControlCenter, Navisphere,and PowerPath are

registered trademarks and Access Logix, MirrorView, SAN Copy, and SnapView are trademarks of

EMC Corporation.

Other trademarks and trade names may be used in this document to refer to either the entities

claiming the marks and names or their products. Dell Inc. disclaims any proprietary interest in

trademarks and trade names other than its own.

April 2008 Rev A00

Contents 3

Contents

1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . 7

Cluster Solution . . . . . . . . . . . . . . . . . . . . . . 8

Cluster Hardware Requirements . . . . . . . . . . . . . 8

Cluster Nodes. . . . . . . . . . . . . . . . . . . . . 9

Cluster Storage . . . . . . . . . . . . . . . . . . . 10

Supported Cluster Configurations . . . . . . . . . . . . 12

Direct-Attached Cluster . . . . . . . . . . . . . . 12

SAN-Attached Cluster . . . . . . . . . . . . . . . 13

Other Documents You May Need . . . . . . . . . . . . 14

2 Cabling Your Cluster Hardware . . . . . . . . 17

Cabling the Mouse, Keyboard, and Monitor . . . . . . 17

Cabling the Power Supplies. . . . . . . . . . . . . . . 17

Cabling Your Cluster for Public and

Private Networks . . . . . . . . . . . . . . . . . . . . 19

Cabling the Public Network . . . . . . . . . . . . 20

Cabling the Private Network . . . . . . . . . . . . 21

NIC Teaming . . . . . . . . . . . . . . . . . . . . 21

Cabling the Storage Systems . . . . . . . . . . . . . . 22

Cabling Storage for Your

Direct-Attached Cluster . . . . . . . . . . . . . . 22

Cabling Storage for Your

SAN-Attached Cluster . . . . . . . . . . . . . . . 27

4Contents

3 Preparing Your Systems for

Clustering . . . . . . . . . . . . . . . . . . . . . . . . 39

Cluster Configuration Overview . . . . . . . . . . . . . 39

Installation Overview . . . . . . . . . . . . . . . . . . 41

Installing the Fibre Channel HBAs. . . . . . . . . . . . 42

Installing the Fibre Channel HBA Drivers. . . . . . 42

Implementing Zoning on a Fibre Channel

Switched Fabric . . . . . . . . . . . . . . . . . . . . . 42

Using Zoning in SAN Configurations

Containing Multiple Hosts . . . . . . . . . . . . . 43

Using Worldwide Port Name Zoning . . . . . . . . 43

Installing and Configuring the

Shared Storage System . . . . . . . . . . . . . . . . . 45

Access Logix . . . . . . . . . . . . . . . . . . . . 45

Access Control . . . . . . . . . . . . . . . . . . . 47

Storage Groups . . . . . . . . . . . . . . . . . . . 47

Navisphere Manager . . . . . . . . . . . . . . . . 49

Navisphere Agent. . . . . . . . . . . . . . . . . . 49

EMC PowerPath. . . . . . . . . . . . . . . . . . . 49

Enabling Access Logix and Creating

Storage Groups Using Navisphere 6.x . . . . . . . 50

Configuring the Hard Drives on the

Shared Storage System(s) . . . . . . . . . . . . . 51

Optional Storage Features . . . . . . . . . . . . . 55

Updating a Dell|EMC Storage System for

Clustering . . . . . . . . . . . . . . . . . . . . . . . . 56

Installing and Configuring a Failover Cluster . . . . . . 56

Contents 5

A Troubleshooting. . . . . . . . . . . . . . . . . . . . 57

B Cluster Data Form . . . . . . . . . . . . . . . . . . 63

C Zoning Configuration Form . . . . . . . . . . . 65

6Contents

Introduction 7

Introduction

A Dell™ Failover Cluster combines specific hardware and software

components to provide enhanced availability for applications and services

that are run on the cluster. A Failover Cluster is designed to reduce the

possibility of any single point of failure within the system that can cause the

clustered applications or services to become unavailable. It is recommended

that you use redundant components like server and storage power supplies,

connections between the nodes and the storage array(s), and connections to

client systems or other servers in a multi-tier enterprise application

architecture in your cluster.

This document provides information to configure your Dell|EMC CX3-series

fibre channel storage array with one or more Failover Clusters. It provides

specific configuration tasks that enable you to deploy the shared storage for

your cluster.

For more information on deploying your cluster with Windows Server 2003

operating systems, see the Dell Failover Clusters with Microsoft Windows

Server 2003 Installation and Troubleshooting Guide located on the Dell

Support website at support.dell.com. For more information on deploying

your cluster with Windows Server 2008 operating systems, see the

Dell Failover Clusters with Microsoft Windows Server 2008 Installation and

Troubleshooting Guide located on the Dell Support website at

support.dell.com.

For a list of recommended operating systems, hardware components, and

driver or firmware versions for your Dell Failover Cluster, see the Dell Cluster

Configuration Support Matrix on the Dell High Availability website at

www.dell.com/ha.

8Introduction

Cluster Solution

Your cluster implements a minimum of two node clustering to a maximum of

either eight nodes (for Windows Server 2003) or sixteen nodes

(for Windows Server 2008) clustering and provides the following features:

• 8-Gbps, 4-Gbps, and 2-Gbps Fibre Channel technology

• High availability of resources to network clients

• Redundant paths to the shared storage

• Failure recovery for applications and services

• Flexible maintenance capabilities, allowing you to repair, maintain, or

upgrade a node or storage system without taking the entire cluster offline

Implementing Fibre Channel technology in a cluster provides the following

advantages:

•

Flexibility

— Fibre Channel allows a distance of up to 10 km between

switches without degrading the signal.

•

Availability

— Fibre Channel components use redundant connections

providing multiple data paths and greater availability for clients.

•

Connectivity

— Fibre Channel allows more device connections than

Small Computer System Interface (SCSI). Because Fibre Channel devices

are hot-pluggable, you can add or remove devices from the nodes without

taking the entire cluster offline.

Cluster Hardware Requirements

Your cluster requires the following hardware components:

• Servers (cluster nodes)

• Storage Array and storage management software

Introduction 9

Cluster Nodes

Table 1-1 lists the hardware requirements for the cluster nodes.

NOTE: For more information about supported systems, HBAs and operating system

variants, see the Dell Cluster Configuration Support Matrix on the Dell High

Availability website at www.dell.com/ha.

Table 1-1. Cluster Node Requirements

Component Minimum Requirement

Cluster nodes A minimum of two identical PowerEdge servers are required.

The maximum number of nodes that is supported depends

on the variant of the Windows Server operating system used

in your cluster, and on the physical topology in which the

storage system and nodes are interconnected.

RAM The variant of the Windows Server operating system that is

installed on your cluster nodes determines the minimum

required amount of system RAM.

HBA ports Two Fibre Channel HBAs per node, unless the server employs

an integrated or supported dual-port Fibre Channel HBA.

Where possible, place the HBAs on separate PCI buses to

improve availability and performance.

NICs At least two NICs: one NIC for the public network and

another NIC for the private network.

NOTE: It is recommended that the NICs on each public network

are identical, and that the NICs on each private network are

identical.

Internal disk

controller

One controller connected to at least two internal hard drives

for each node. Use any supported RAID controller or disk

controller.

Two hard drives are required for mirroring (RAID 1) and at

least three are required for disk striping with parity (RAID 5).

NOTE: It is strongly recommended that you use

hardware-based RAID or software-based disk-fault tolerance

for the internal drives.

10 Introduction

Cluster Storage

Table 1-2 lists supported storage systems and the configuration requirements

for the cluster nodes and stand-alone systems connected to the storage

systems.

Table 1-3 lists hardware requirements for the storage processor enclosures (SPE),

disk array enclosures (DAE), and standby power supplies (SPS).

Table 1-2. Cluster Storage Requirements

Hardware Components Requirement

Supported storage

systems

One to four supported Dell|EMC storage systems. See

Table 1-3 for specific storage system requirements.

Cluster nodes All nodes must be directly attached to a single storage

system or attached to one or more storage systems

through a SAN.

Multiple clusters and

stand-alone systems

Can share one or more supported storage systems using

optional software that is available for your storage system.

See "Installing and Configuring the Shared Storage

System" on page 45.

Table 1-3. Dell|EMC Storage System Requirements

Processor

Enclosure

Minimum Storage Possible Storage

Expansion

SPS

CX3-10c SPE One DAE3P-OS with

at least five and up to

15 hard drives

Up to three DAE with a

maximum of 15 hard

drives each

Two per SPE and

DAE3P-OS

CX3-20c SPE One DAE3P-OS with

at least five and up to

15 hard drives

Up to seven DAE with a

maximum of 15 hard

drives each

Two per SPE and

DAE3P-OS

CX3-20f SPE One DAE3P-OS with

at least five and up to

15 hard drives

Up to seven DAE with a

maximum of 15 hard

drives each

Two per SPE and

DAE3P-OS

CX3-40c SPE One DAE3P-OS with

at least five and up to

15 hard drives

Up to 15 DAE with a

maximum of 15 hard

drives each

Two per SPE and

DAE3P-OS

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Dell Stockage

Dell

Dell SC5020 Instructions d'utilisation

Dell

Dell PowerVault MD3060e Series Instructions d'utilisation

Dell

Dell EqualLogic PS5000 Manuel du propriétaire

Dell

Dell PS4110 Manuel utilisateur

Dell

Dell PowerVault DL4000 Guide de référence rapide

Dell

Dell EMC PowerStore Manuel utilisateur

Dell

Dell PowerVault DL2200 CommVault Manuel utilisateur

Dell

Dell SC400 Manuel utilisateur

Dell

Dell PowerVault MD3620i Manuel utilisateur

Dell

Dell PowerVault RD1000 Manuel utilisateur

Dell

Dell Inspiron 3700 Manuel utilisateur

Dell

Dell Dell PowerVault MD32X0 Manuel utilisateur

Dell

Dell EMC AX4-5 Manuel utilisateur

Dell

Dell PowerVault 735N Mode d’emploi

Dell

Dell PowerVault NX400 Instructions d'utilisation

Dell

Dell PowerVault DL2000 Manuel

Dell

Dell PowerVault Storage Area Network Mode d’emploi

Dell

Dell DX6000 Manuel utilisateur

Dell

Dell PowerVault TL2000 Manuel utilisateur

Dell

Dell PowerVault NX400 Manuel utilisateur

Dell

Dell PowerVault 110T LTO3 Manuel utilisateur

Dell

Dell PowerVault NX300 Manuel utilisateur

Dell

Dell Storage NX3330 Manuel utilisateur

Dell

Dell PowerVault ML6000 Manuel utilisateur

Manuels Stockage populaires d'autres marques

QNAP

QNAP TS 32PXU Series Manuel utilisateur

LaCie

LaCie RUGGED RAID Manuel utilisateur

Freecom

Freecom CLS DOCK Manuel utilisateur

PNY

PNY Attache P-FD64MBATT3 Manuel utilisateur

HP StorageWorks MSL2024 Manuel utilisateur

OLT

OLT 6x6 Maximizer Manuel utilisateur

Transcend

Transcend JetFlash 160 Manuel utilisateur

LaCie

LaCie RUGGED MINI Manuel utilisateur

Thunderbolt

Thunderbolt 600 Manuel utilisateur

Panasonic

Panasonic LB-DH8 series Manuel

Intel

Intel RAID High Availability Manuel utilisateur

LaCie

LaCie 12big Thunderbolt 3 Manuel utilisateur

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuel utilisateur

Panasonic

Panasonic LKM-F931-1 Manuel utilisateur

Tabernus

Tabernus Enterprise Erase E2400 Manuel utilisateur

Rocstor

Rocstor COMMANDER 3F series Manuel utilisateur

HP P9000 Manuel utilisateur

Western Digital

Western Digital Ultrastar Data60 Manuel utilisateur