www.deico.com.tr rev.0 6 / 7
3.3 XJ3 Connector Pinout (Rear)
XJ3 Connector Pin Assignments
4 CONFIGURATION
DE9005 control is based on NI-SLSC API. Before installing the device, NI-SLSC 19.5 or later
must be installed. After installing software & the device, the device appears in the <LabVIEW
Folder>\examples\ SLSC\Configuration.vi front panel under the related SLSC Chassis when the
VI is executed. If the device does not appear in Configuration VI, use the following
troubleshooting guidelines:
• Verify that the related SLSC Chassis is present on NI MAX and Configuration VI.
• Use ‘Refresh’ button on the Configuration VI for the SLSC Chassis.
• Use ‘Restart’ button on the Configuration VI to restart the SLSC Chassis.
• Power off and unplug the chassis, and install the device in a different slot.
5 PROGRAMMING THE DEVICE IN SOFTWARE
To use DE9005 in software, DE9005 LabVIEW Driver must also be installed on the system.
After the driver is installed, device control VIs can be found on Instrument I/O>Instr
Drivers>DE9005 palette in LabVIEW. Driver also provides programming examples. For more
information on the subject, refer to the User Manual of DE9005.
6 SAFETY GUIDELINES
Caution Do not operate the DE9005 in a manner not specified in this document. Product
misuse can result in a hazard. You can compromise the safety protection built into the
product if the product is damaged in any way. If the product is damaged, return it for repair.
7 ELECTROMAGNETIC COMPATIBILITY GUIDELINES
This product was tested and complies with the regulatory requirements and limits for
electromagnetic compatibility (EMC). These requirements and limits provide reasonable
protection against harmful interference when the product is operated in the intended
operational electromagnetic environment.
