Datalogic HandScanner MR Manuel utilisateur

HANDSCANNER

QUICKSTART GUIDE

HANDSCANNER

HAND TRIGGER

DATALOGIC CHARGING STATION

HANDSCANNER

DATALOGIC GATEWAY

SCANNER

WEARABLES

S,M,L

Trigger located on the index

nger. Clip left or right.

CONNECTIVITY DEVICE (OPTIONAL) CHARGING STATION

Press the textile trigger. Aim at the barcode and scan.

Use your ngers to press between HandScanner and the

fastening rail of the Hand Trigger. Press the HandScanner up

slightly and push it forward without scratching over the pins.

RELEASE

CONNECT WITH PAIRING BARCODE: 3 OPTIONS

INSERT

SCAN

QUICKSTART GUIDE

ACTIVATE

Insert the HandScanner in the Hand Trigger. Press the textile trigger on the Hand Trigger for about 2

seconds to activate the HandScanner.

Open the app symbol “Insight Mobile” on the mobile

device and scan the Pairing Barcode.

VIA INSIGHT MOBILE

01 02

Scan the BLE HID Pairing Barcode.

VIA BLE HID

The pins face down. Insert the HandScanner in the

Datalogic Charging Station.

CHARGE

HOURS

Scan the Pairing Barcode on the top of the Datalogic

Gateway.

VIA DATALOGIC

GATEWAY

HANDSCANNER IS NOT WORKING

PROBLEM SOLUTION

HandScanner is not reacting /

HandScanner is not scanning

a barcode.

Battery is not charged.

Charge the HandScanner in the Datalogic Charging Station for

at least 20 min.

Hand Trigger is defective.

Change the Hand Trigger.

Battery symbol of the HandScanner

ashes red.

Battery charge is low.

Charge the HandScanner in the Datalogic Charging Station for

at least 20 min.

TROUBLESHOOTING

HANDSCANNER SCANS BADLY

PROBLEM SOLUTION

The crosshairs ( ) /

scan dot ( ) light up, but

the barcodes are hard to scan.

HandScanner glass is dirty.

Clean the HandScanner glass with a cotton swap.

Scanning distance is not optimally used.

Position the HandScanner closer or further away from the

barcode label and scan.

For standard range: 3.9 - 31.5 in (10-80 cm)

For mid range: 11.8 - 59 in (30-150 cm).

The barcode label cannot be read.

Create new barcode label.

NO TRANSMISSION OF BARCODE DATA

PROBLEM SOLUTION

Barcode data is not transferred. HandScanner is not connected to the end device.

1. Scan the Pairing Barcode on the end device /

Datalogic Gateway / in Insight Mobile App.

2. Wait until the HandScanner is connected to the end device and

lights up blue twice briey after a successful connection.

NEED HELP?

datalogic.com/support

Datalogic S.r.l.

Via San Vitalino 13

40012 Lippo

Calderara di Reno BO, Italy

www.datalogic.com

STANDARD SETTINGS:

Barcode Sux: Enter (CR)

DIRECTIVES AND CERTIFICATION:

2014/53/EU Radio Equipment Directive (RED)

2011/65/EU Restriction of Hazardous Substances (RoHS)

PROBLEM COULD NOT BE SOLVED?

Hard Reset:

1. Insert the HandScanner in the Hand Trigger.

2. Hold the trigger pressed for about 15 seconds

3. Release the trigger. Press the trigger again for

about 2 seconds to reactivate the HandScanner.

820118500 Rev. A

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Datalogic Scanner

Datalogic

Datalogic DS1500-1100 Manuel utilisateur

Datalogic

Datalogic MAGELLAN 3410VSi Guide de configuration rapide

Datalogic

Datalogic DLL2020-WO Manuel utilisateur

Datalogic

Datalogic Jade X7 Manuel utilisateur

Datalogic

Datalogic DS2200 SH2348 Mode d’emploi

Datalogic

Datalogic Magellan 9800i Manuel d'installation et d'exploitation

Datalogic

Datalogic Matrix 300N Manuel d'installation et d'exploitation

Datalogic

Datalogic DS8100A Manuel utilisateur

Datalogic

Datalogic MAGELLAN 1000I Manuel utilisateur

Datalogic

Datalogic Laser Sentinel Manuel utilisateur

Datalogic

Datalogic CATCHER D531 Series Manuel utilisateur

Datalogic

Datalogic Magellan 3450VSi Manuel d'installation et d'exploitation

Datalogic

Datalogic DS2100N Manuel utilisateur

Datalogic

Datalogic TC1100 Manuel utilisateur

Datalogic

Datalogic Heron HD3130 Manuel utilisateur

Datalogic

Datalogic Laser Barcode Reader DS4600A-2XX5 Manuel utilisateur

Datalogic

Datalogic Magellan 3500HSi Manuel utilisateur

Datalogic

Datalogic EtherNet/IP DS6 00 Series Manuel utilisateur

Datalogic

Datalogic MAGELLAN 3410VSi Manuel utilisateur

Datalogic

Datalogic BASIC HOLDER Manuel technique

Datalogic

Datalogic DX8200A-3002 Manuel utilisateur

Datalogic

Datalogic HS7500 Manuel utilisateur

Datalogic

Datalogic MAGELLAN 3200VSI Manuel utilisateur

Datalogic

Datalogic PWR-480W Manuel utilisateur

Manuels Scanner populaires d'autres marques

Plustek

Plustek Scanner Manuel utilisateur

Z/I Imaging

Z/I Imaging PhotoScan 2001 Manuel utilisateur

Renkforce

Renkforce DS100-5M Manuel utilisateur

Image Access

Image Access WideTEK A2 Manuel utilisateur

Canon

Canon imageFORMULA CR-120N Manuel utilisateur

Fujitsu

Fujitsu FI-4860C2 Manuel utilisateur

GeoSlam

GeoSlam ZEB Horizon Instructions d'installation

Kodak

Kodak i5800 Scanner Manuel utilisateur

Kodak

Kodak i7300 Manuel utilisateur

Revopoint

Revopoint POP Manuel utilisateur

Fujitsu

Fujitsu fi-4860C Manuel utilisateur

Eddyfi Technologies

Eddyfi Technologies Floormap X Manuel utilisateur

Faselase

Faselase F6 Manuel utilisateur

Fujitsu

Fujitsu CardMinder Manuel utilisateur

Uniden

Uniden BC340CRS Manuel utilisateur

Infinite Peripherals

Infinite Peripherals INFINEA TAB M Manuel utilisateur

Mustek

Mustek PageExpress 4800 Pro Manuel utilisateur

Optex

Optex 750830 Manuel utilisateur