Danfoss ST-S2 Manuel utilisateur

Installation Guide

Safety thermostats ST-S2

Danfoss Heating VI.IA.N1.02 DH-SMT/SI

ENGLISH Safety thermostats ST-S2 www.danfoss.com Page 3

①

❶❷

❸➍

ST-S2

①

+−

❺❻

①

②

①

329

49 7

101~18

G⁄" B ISO 228/1

PG 11

Ø8 Cu

100

ST-S2

Installation Guide Safety thermostats ST-S2

DH-SMT/SI VI.IA.N1.02 Danfoss Heating

Installation Guide Safety thermostats ST-S2

Danfoss Heating VI.IA.N1.02 DH-SMT/SI

ENGLISH

Safety Note

To avoid injury and damage to persons

and devices, it is absolutely necessary

these instructions are carefully read

and observed prior to assembly and

commissioning.

Necessary assembly, start-up, and

maintenance work must be performed

only by qualied, trained and authorised

personnel.

Prior to assembly and maintenance work

on the controller, the system must be:

- depressurized

- cooled down

- emptied

- cleaned

Please comply with the instructions of the

system manufacturer or system operator.

This installation procedure describes as

follow must be performed exclusively

by qualied personnel in respect to the

security norms and dispositions of the

current standards.

Disposal instruction

This product should be

dismantled and its

components sorted, if

possible, in various groups

before recycling or disposal.

Always follow the local disposal

regulations.

Installation

Disconnect the mains before performing

any operation!

Verify the thermostat technical data

(power supply, contact rating, etc...) are

suitable to the installation conditions.

❶ Unscrew the three xing screws and the

cap ①, then remove the cover.

❷ Wire the thermostat according to

wiring diagram.

Terminals:

1 Opens the circuit when temperature

increases

2 Closes the circuit when temperature

increases

C Common

Ground

❸ Adjust the temperature set-point

thermostat by rotating the cam ①

❶ Put the cover back in place adjusting

the knob so that it slides on the control

thermostat adjustment pin. Then tighten

the cap ① and the three screws.

➍ Place of installation of immersion

pocket must be chosen in a way that the

temperature of the medium is directly

taken without any delay.

❺ Immerse the temperature sensor into

the immersion pocket in its full length.

When using immersion pockets longer

then 100 mm rst carefully pull enough

capillary tube out of the housing. Capillary

tube may not be twisted or buckled! After

inserting temperature sensors lock the

housing tightening the screw①

❻ In order to reset the thermostat,

unscrew the cap ① and push the reset

button ②.

Note:

Reset allowed for temperature values from 15

to 25 °C below Tsetpoint

Installation Guide Safety thermostats ST-S2

VI.IA.N1.02 Produced by Danfoss A/S © 07/2010

Autres manuels Danfoss Thermostat

Danfoss

Danfoss DEVIreg Touch Manuel utilisateur

Danfoss

Danfoss TPOne-M Manuel utilisateur

Danfoss

Danfoss RAS-D2 Combi Manuel utilisateur

Danfoss

Danfoss Living Eco Manuel utilisateur

Danfoss

Danfoss ORT-01 Manuel utilisateur

Danfoss

Danfoss TS715 Si Manuel utilisateur

Danfoss

Danfoss DEVIreg Room 140F1161 Manuel utilisateur

Danfoss

Danfoss TP75H Manuel d'utilisation

Danfoss

Danfoss LX205T Manuel utilisateur

Danfoss

Danfoss GET B-RF Mode d’emploi

Danfoss

Danfoss ECL Comfort 310, P318 Manuel utilisateur

Danfoss

Danfoss RT 115 Manuel utilisateur

Danfoss

Danfoss RET B-LS Manuel utilisateur

Danfoss

Danfoss ECtemp Smart Manuel utilisateur

Danfoss

Danfoss RET2000 B Manuel utilisateur

Danfoss

Danfoss HC75A-1 Manuel d'utilisation

Danfoss

Danfoss ECL Comfort 210 Manuel utilisateur

Danfoss

Danfoss ECL Comfort 310, P330 Manuel utilisateur

Danfoss

Danfoss FP715Si Manuel utilisateur

Danfoss

Danfoss living connect Z Manuel utilisateur

Danfoss

Danfoss TP7000M Manuel utilisateur

Danfoss

Danfoss TP4000 Range Manuel utilisateur

Danfoss

Danfoss DEVIreg 530 Manuel utilisateur

Danfoss

Danfoss Icon Wireless Dial Manuel utilisateur

Manuels Thermostat populaires d'autres marques

EWELLY

EWELLY EW-181 Manuel utilisateur

Prolon

Prolon T1100 Instructions d'installation

Computherm

Computherm Q20 Manuel utilisateur

Heatmiser

Heatmiser neoStat Manuel utilisateur

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manuel utilisateur

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manuel utilisateur

Saswell

Saswell SAS920XWHB-7-S-RF Mode d’emploi

Aircalo

Aircalo TFP1-ET85P2 Manuel utilisateur

Honeywell

Honeywell CM721 Manuel utilisateur

Carrier

Carrier DEBONAIR 33CS Manuel utilisateur

Lennox

Lennox iHarmony Zone Thermostat Instructions de montage

Gemtech

Gemtech GT7000 Mode d’emploi

Rollei

Rollei Smartes 45000 Manuel utilisateur

Sinope

Sinope TH1300RF Manuel utilisateur

Honeywell

Honeywell RLV4305 Manuel utilisateur

Honeywell

Honeywell Prestige 2.0 THX9421 Manuel utilisateur

NuTone

NuTone NTBZ48 Instructions d'utilisation d'origine

Stelpro

Stelpro MAESTRO ASMT402AD Manuel utilisateur