Dancover PE Series Manuel utilisateur
22-08-2013
3m PE Series
Party tent
Manual for
Safety Advice
Attention
In some countries approval is needed to set up a marquee/tent larger than 75 m2. It
is your responsibility to comply with local rules and regulations and to ensure that
the marquee/tent is assembled correctly.
In case of bad weather conditions, it is your responsibility to ensure the
marquee/tent is safely secured and that the marquee/tent does not cause damage
to others.
close to the tent.
The marquee/tent must be safely secured. We recommend you secure your
marquee/tent with straps and pegs as soon as it is assembled.
Make sure to check if the marquee/tent is covered by your home contents insurance.
Marquees/tents must be evacuated under extreme weather conditions.
In the event of snow always remove snow from the roof of the marquee/tent
regularly to prevent snow from building on the roof as heavy snow can cause the
marquee/tent to collapse.
In the event of rain there is a risk of rain puddles building up on top of the roof of the
marquee/tent. Heavy rain puddles can cause the roof to collapse. It is your responsi-
bility to ensure rain puddles do not build up. As a precaution, make sure theroof of
the marquee/tent is stretched out properly and adequately over the side frames of
the marquee/tent and remove rain water regularly.
Please always check our website for the latest safety advice and manuall.
Note: Marquees are intended for events and other arrangements and are as such only
meant for short term temporary assembly and the following disassembly. Dancover
warranty applies only to the normal use of the Product, normal wear and tear excepted,
in accordance with written use instructions or manual. The warranty does not apply to
3m PE instruction
Part
no.
3x4m 3x6m 3x8m 3x10m
1Frame pole 6 8 10 12
2Frame pole 6 9 12 15
3Leg 6 8 10 12
43-way
Connector 6 6 6 6
54-way
Connector 3 6 9 12
6Big peg 4 4 4 4
7Middle peg 6 8 10 12
8Small peg 23 27 31 35
9Bungeeball long 52 60 68 76
10 Bungeeball short 14 14 14 14
11 Rope 4 4 4 4
12 O-Screw 30 42 54 66
13 Roof 1 1 1 1
1 1 1 1
1 1 1
22-08-2013
1
14 Sidewall 2 2 2 2
15 Endwall with
large door
Endwall with
small door
16
Assemble instruction
Step 1
Select a flat ground for the tent, unpack the carton
and check all the parts including tubes, tent and
accessories… etc. are present same as list.
Assemble the framework of rooftop by joining the
portion (4.5) together with poles (1.2). To ensure the
screw fixed to every pole tightly.
Step 2
Attach one end of the Leg (3) to the joints (4,5)
Step 3
Cover the roof on the frame and attach it with the
bungee balls properly, take care of the tension of the
bungee balls, for if you use too many on one side of
the tent, it may become too tight to tie the other side
of it.
Step 4
Attach the remaining Legs (3) to the joints (4,5),
to built-up the framework, use the long pegs
to fix each pole into the ground.
12
2
2
2
2
2
2
2
1
1
1
1
Assemble manual
Step 5
Fold out the sidewalls and the endwalls, attach to
framework by using the bungeeballs locking the
through the eyelets that are placed on top of the
sidewalls and endwalls to ensure stability. Connect
leg cover with sidewall by Velcro. Also use the short
pegs to fix the doors to the ground.
Step 6
Tie the rope to each corner of the tent. Tie the other
end of the rope to a peg. Stick peg in ground.
Warning:
1. In order to avoid rusting pipes, oil is covering the surface of the pipes, before erecting the
tent, please remove the oil carefully first to keep the cover clean.
2. Take note that the tent needs to be handled carefullyto avoid damage.
3. Do not force the frame as they may be damage in the process.
4. Tents are meant as temporary shelter and must be evacuated under extreme weather
conditions.
5. The windows maybe a little bit sticky to each other, when you unfold the windows, please
do this as softly as you can. Or the windows might crack during the process.
Please select a suitable site for the tent to avoid the damage from underground sprinkler
systems, water, gas or electrical lines.
Contact information
Head office:
Dancover A/S
Nordre Strandvej 119 G
3150 Hellebæk
Denmark
For more information
please visit:
www.dancovershop.com
National contact
Denmark:
denmark@dancover.com
UK:
uk@dancover.com
Spain:
espana@dancover.com
Italy:
italia@dancover.com
Germany:
germany@dancover.com
Switzerland:
schweiz@dancover.com
France:
france@dancover.com
Austria:
austria@dancover.com
Sweden:
sverige@dancover.com
Finland:
suomi@dancover.com
Nederland:
nederland@dancover.com
Poland:
polska@dancover.com
Ireland:
ireland@dancover.com
Luxembourg:
luxembourg@dancover.com
Belgium:
belgique@dancover.com
Norway:
norge@dancover.com
Table des matières
Autres manuels Dancover Tente
Dancover
Dancover TentZing CT168200 Manuel utilisateur
Dancover
Dancover ProShed MS572012 Manuel utilisateur
Dancover
Dancover 5.4m Series Manuel utilisateur
Dancover
Dancover 5m PE Series Manuel utilisateur
Dancover
Dancover CA119011 Manuel utilisateur
Dancover
Dancover Garage tent 3,77x7,3x3,24m PVC Manuel utilisateur
Dancover
Dancover Semi PRO 4x8m Manuel utilisateur
Dancover
Dancover AC153200 Manuel utilisateur
Dancover
Dancover PARTY TENT SEMI PRO CombiTent 8m Series Manuel utilisateur
Dancover
Dancover Pagoda Manuel utilisateur
Dancover
Dancover 3m storage pro Manuel utilisateur
Dancover
Dancover Titanium Tent Manuel utilisateur
Dancover
Dancover CombiTent SEMI PRO AC18026 Manuel utilisateur
Dancover
Dancover GH18001 Manuel utilisateur
Dancover
Dancover 2m Series Manuel utilisateur
Dancover
Dancover Semi PRO 5x10m Manuel utilisateur
Dancover
Dancover 2m Series Manuel utilisateur
Dancover
Dancover PRO EventZone 9m Series Manuel utilisateur
Dancover
Dancover Semi PRO 9x12m Manuel utilisateur
Dancover
Dancover Basic-1339H Manuel utilisateur
