Daikin SM-12-012 Manuel utilisateur

Service Manual SM-Inverter_(i)

Air Conditioners

Service Manual

Split Inverter

012

Service Manual SM-Inverter_(i) 2

Inverter Air conditioning technology is today’s solution for superior comfort, higher efficiency and better energy

saving. This Service Manual will intro Daikin Inverter Residential and Light Commercial product.

INVERTER Y Series Single Split (Residential, Light Commercial)

i) INDOORS

ii) OUTDOORS

1.1 INVERTER SINGLE SPLIT

Residential (ATXN/FTXN-LV/FTXN-LV1B9 & ARXN/RXN-LV/RXN-LV1B9):

- High Quality & Efficiency Daikin DC Inverter compressor

- High Performance Daikin Inverter Controller

- 5-speed Step-less Fan operation

- New Inverter-only Remote Control

Piping Length & Elevation

Model

Max. total

piping

length

(m)

Max. height

difference

(m)

Pre-charge

for up to

piping length

(m)

Additional

charge

(g/m)

ARXN/RXN25LV1B(9) 20 10 7.5 20

ARXN/RXN30LV1B(9) 20 10 7.5 20

ARXN/RXN50LV1B(9) 30 10 7.5 20

ARXN/RXN60LV1B(9) 30 10 7.5 20

Terminal Block for outdoor:

- Equipped with 7-segment display to improve serviceability. (Excluded for ARXN/ RXN25/30LV1B(9))

- To retrieve error code & running parameters.

1.0 Introduction

Service Manual SM-Inverter_(i) 3

Disable Auto Random Restart function:

Series I Series II

To disable the auto random restart function, kindly cut off the jumper J_AUTO as highlighted in attachment.

Please be informed that after disable auto random restart, unit is not able to restart with last state memory after

power resume from failure. Unit will revert to default setting as below:

Default setting

Unit: Off

Temperature: 24°C

Fan speed: High

Mode: Cooling

Service Manual SM-Inverter_(i) 4

INDOOR BASIC FUNCTIONS

Residential and Light Commercial

The system has 5 operating modes. The mode selection is done from indoor using handset.

The operating modes are:

•

Cool

•

Heat

•

Fan

•

Auto

•

Dry

Cool Mode:

When Tr

≥

Ts - 1.5°C

•

Comp, Indoor Fan and Outdoor Fan ON.

When Tr

≤

Ts - 2°C

•

Compressor and Outdoor Fan OFF.

Tr = Room Temperature

Ts = Set Temperature

When cooling load is too small and the room temperature still falling below compressor cut off point,

compressor will stop.

2.0 Algorithm and Control

Service Manual SM-Inverter_(i) 5

Heat Mode:

When Ts > Tr - 1.0°C

•

Comp, ID Fan and OD Fan ON.

When Tr

≥

Ts + 1.5°C

•

Compressor and Outdoor Fan OFF.

•

Indoor Fan off if indoor coil

≤

20°C.

Tr = Room Temperature

Ts = Set Temperature

When heating load is too small, and the room temperature still rising above compressor cut off point, compressor

will stop.

FAN MODE

Only High, Medium and Low fan speeds are allowed.

When changing cool mode to fan mode, the compressor will stop and OD fan stops based on fan OFF

control.

Compressor only ON if the minimum stop time is > 3 minutes and the user change back to cool mode.

Fan speed will maintain same as during fan mode.

AUTO MODE

For heat pump only

Mode switching point:

•

Heating



Cooling



≥

Ts + 2.5

•

Cooling



Heating



≤

Ts – 2.5

During initial operation

•

Cooling operation: Tr > Ts

Service Manual SM-Inverter_(i) 6

•

Heating operation: Tr < Ts

ID-OD COMMUNICATION

Master by outdoor unit.

Indoor controller board will transmit signal to outdoor controller board every 0.5s. Outdoor unit will

response to indoor once the valid data is received.

If the data communication line between indoor and outdoor disrupted for 15s continuously, compressor

will stop, OD fan stop with fan OFF timer. ID LED blinks error.

If the communication resumes within 15s, error code is clear and compressor restarts after 3 minutes.

If the communication does not resume after 15s, unit unable to restart and the error keep blinking.

Service Manual SM-Inverter_(i) 7

THERMISTORS IN ARXN/ RXN-LV1B(9)

FUNCTIONS OF THERMISTOR

Thermistor

Functions

Discharge pipe Used for discharge superheat (SH) & EXV control.

Outdoor coil Used for defrost control. Also used for inverter current protection control in

Series II.

Outdoor air Used for defrost & outdoor fan speed control. Also used for PMV, overall

current protection & preheating operation control.

Heat sink Used for capturing heat sink temperature.

Suction pipe Used for EXV (SH) & suction pipe SH protection control in heating.

Gas pipe Used for gas pipe isothermal control in cooling. EXV opening is controlled so

that accurate cooling capacity is achieved in each room.

Liquid pipe Used for sub-cooling control in heating. Actual sub-cooling will be calculated

with liquid pipe & max. heat exchanger temperature among all rooms. EXV

opening is then adjusted to reach the target sub-cooling.

Service Manual SM-Inverter_(i) 8

MINIMUM RUN CONTROL

To prevent frequent compressor ON/OFF & to allow pressure equalization

•The compressor will be on 3 minutes stand-by after turning OFF before it is allowed to turn ON.

•OD fan OFF delay to improve pressure equalization & to prevent refrigerant from entering into

evaporator.

AUTO RESTART

-Factory pre-set.

-Allow unit to automatically resume the same operating mode it was in before a power failure.

4-WAY VALVE CONTROL

-Change over switching is only carried out during operation.

-OFF delayed is applied when the coil switches from ON to OFF.

Operating mode 4-way valve is

Heat, except for defrost ON

Cool

Dry

Defrost

OFF

DEFROST CYCLE

During defrost RXN-LV(1B/1B9)

Compressor ON

4-way valve OFF

EXV in operation room Fixed opening

EXV in operation stop room -

Outdoor fan OFF

Indoor fan OFF

Service Manual SM-Inverter_(i) 9

ATXN/FTXN-LV and ARXN/RXN-LV(1B/1B9):

DEFROST CONTROL

-Condition for entering defrost

•Compressor minimum run time – 6 minutes OR

•Compressor accumulated run time of 45 minutes if Outdoor coil < 3°C.

-Condition for terminating defrost

•OD coil > 12°C or

•Total defrost timer of 650 seconds.

OUTDOOR FAN CONTROL

-Determine from

•Compressor target rotation: higher fan speed with higher rotation.

•Outdoor air temperature.

-Cool mode: Higher fan speed with higher outdoor air temperature.

-Heat mode: Higher fan speed with lower outdoor air temperature.

-When compressor stops, fan OFF delay 30 seconds is carried out

INDOOR COIL FREEZE PREVENTION

-Only available in cooling mode.

-When the indoor coil temperature < 2°C, the compressor starts to drop the frequency.

-This protection will cut in when:

•Indoor coil temperature < 0°C for more than 180s. Compressor will stop, OD fan stop after 30s

and indoor fan can only run at lowest fan speed.

-The unit can only be restarted after 3 minutes.

-When the indoor coil temperature > 13°C, the compressor frequency will be reset based on the OD

ambient, room and set temperature.

Service Manual SM-Inverter_(i) 10

ROTATION REGULATING FUNCTIONS

* Defrost control for heat pump model only

STARTING ROTATION

STARTING CONTROL

-To avoid excessive oil discharge from compressor or to promote oil lubrication during startup.

-To prevent liquid flood back to the compressor.

-To limit starting current.

-When compressor starts to rotate from OFF to ON, compressor rotation is set to run gradually to each

upper limit at a specific timer setting.

Model Max. f

ARXN/RXN25LV1B(9) 68 Hz

ARXN/RXN35LV1B(9) 74 Hz

ARXN/RXN50LV1B(9) 90 Hz

ARXN/RXN60LV1B(9) 93 Hz

Upper limit rotation

Limit Rotation

Lower limit rotation

Target Rotation

Command Rotation

Starting Rotation

∆

Defrost*

Table des matières

Autres manuels Daikin Climatiseur

Daikin

Daikin RXS71E3V1B Manuel utilisateur

Daikin

Daikin FT50GAVAL Manuel utilisateur

Daikin

Daikin FTXP20L2V1B Manuel utilisateur

Daikin

Daikin RXYCQ8A7Y1B Manuel utilisateur

Daikin

Daikin FTXV20W1VMA Manuel utilisateur

Daikin

Daikin Comfora Manuel utilisateur

Daikin

Daikin FHQ35CAVEB Manuel utilisateur

Daikin

Daikin MXS-FV1B_F2V1B Manuel utilisateur

Daikin

Daikin RP71L7V1 Manuel utilisateur

Daikin

Daikin Super Multi NX FLKS25BAVMB Manuel d'instructions

Daikin

Daikin RXYQ72PYDN Manuel utilisateur

Daikin

Daikin FCQHG71FEVB Manuel d'instructions

Daikin

Daikin FVXS35KV1A Manuel utilisateur

Daikin

Daikin PCRPH1308 Manuel utilisateur

Daikin

Daikin FMDQ50A7V3B Manuel utilisateur

Daikin

Daikin RN50JV1 Manuel utilisateur

Daikin

Daikin FTK25JVE9 Manuel utilisateur

Daikin

Daikin Siesta ATXM35N2V1B Fiche d'information produit

Daikin

Daikin FFQ-C Manuel d'instructions

Daikin

Daikin FTXG-J Manuel d'instructions

Daikin

Daikin FWZ Guide de démarrage rapide

Daikin

Daikin FTX09NMVJUA Manuel utilisateur

Daikin

Daikin RX12NMVJU Manuel utilisateur

Daikin

Daikin FVXS09NVJU Manuel utilisateur

Manuels Climatiseur populaires d'autres marques

Spheros

Spheros CC 355 Manuel utilisateur

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE Manuel utilisateur

Panasonic

Panasonic CS-E12HKEW Manuel utilisateur

nedis

nedis ACMB1WT7 Manuel utilisateur

Samsung

Samsung AR KV Series Mode d’emploi

Fujitsu

Fujitsu Inverter ASBA30JFC Manuel utilisateur

Toshiba

Toshiba RAS-M10SMUV-E Manuel utilisateur

Hitachi

Hitachi RAS-E24CAK Manuel utilisateur

CIAT

CIAT Magister 2 Series Mode d’emploi

Bestron

Bestron AAC6000 Manuel utilisateur

Hisense

Hisense 7K Manuel technique

Frigidaire

Frigidaire FFRE0533S1E0 Manuel utilisateur

Samsung

Samsung AS09HM3N Manuel utilisateur

Frigidaire

Frigidaire CRA073PU11 Manuel du propriétaire

Soleus Air

Soleus Air GB-PAC-08E4 Manuel utilisateur

McQuay

McQuay MCK020A Manuel utilisateur

Webasto

Webasto Frigo Top 25 DS Manuel utilisateur

Frigidaire

Frigidaire FAZ12ES2A Manuel utilisateur