Dacor ACTK27 Manuel utilisateur

PART NAME

DUCT (A)-1

DUCT (A)-2

DUCT (A)-3

DUCT (B)

DUCT (C)

STOPPER

SASH (SIDE)

SASH (U AND L)

CUSHION (A)

CUSHION (B)

SCREW (A)

SCREW (B)

Q'TY

DUCT (A)-1 DUCT (A)-2

DUCT (A)-3 DUCT (B)

STOPPER

DUCT (C)

SASH

(U AND L)

CUSHION (B)

(thick)

CUSHION (A)

(thin)

(FOR ACTK27)

IMPORTANT: This Built-In Kit is designed for use with those Dacor Microwave Ovens specifying ACTK27 or

ACTK30 Built-In Kit on rating label on the front of the oven.

READ THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING

INSTALLATION!

INSTALLATION INSTRUCTIONS

*For walls other than wood, you may need appropriate screws to install the SASH and STOPPER.

*Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing a kit.

Also remove the turntable tray and turntable support from the oven cavity.

*Because these kits are metal, due caution should be used in handling and installation to avoid the

possibility of injury.

*Two wooden supports must be provided, nominal 2"x 2"x 155/8" (actual 19/16"x19/16"). Contact cement is

needed for attaching. These items can be purchased from a building supply store. Check to see that the

actual height of the wood is 19/16" (4.0 cm).

SASH (SIDE) SCREW (A) SCREW (B)

(FOR ACTK30)

ACTK27

BUILT-IN KIT MODELS ACTK30

followed by letter indicating color S=stainless steel, R=arctic white, B=black

Part No. 900930 Rev. C

ACTK27S/R/B 30S/R/B 11.8.12, 0:40 PM1

ACTK27: 25

" (64.1 cm)

ACTK30: 28

" (71.8 cm)

"±

" (46.7 cm)

2"(A)

24" (61.0 cm)

" (39.8 cm)

ACTK30: 11

" (29.2 cm)

ACTK27: 10" (25.4 cm)

191/8"

A: nominal 2" (actual 19/16"/4.0 cm)

91/8"(23.2 cm)

(12.2 cm)

(48.6 cm)

STEP 1: CABINET OR WALL OPENING

Provide an opening in the wall or cabinet as indicated in Sketch 1.

The depth should be 24" (61.0 cm). The floor of the opening should be constructed of plywood

strong enough to support the weight of the oven (about 100 lbs.) and should be level for proper

operation of the oven. See page 6 for cabinet/cutout layout dimensions.

NOTE: While the proper functioning of the oven does not require that the opening be enclosed

(with sides, ceiling and rear partition), this may be required by local code, and it is

suggested that the local code be checked for any such requirement.

ELECTRICAL SUPPLY

At the rear of the opening, provide a 3 pronged, polarized, electrical outlet, 115-120 volt A.C., 15

Amp. or larger. This outlet should not be located in the shaded area of Sketch 1.

OVEN SUPPORTS

Cement two 2" x 2" x 155/8" wooden supports as indicated in Sketch 1. Follow contact cement

instructions carefully.

STEP 2: INSTALLATION OF KIT

(a) Insert the edge of DUCT (B) into the hold lip of DUCT (C). Secure together by using a SCREW (A)

provided in the kit.

Remove the existing screw (#1) at upper right rear of the oven and secure DUCT (C) with the

screw (#1) just removed from the oven. Secure DUCT (B) with SCREW (A) through the duct and

into the original screw hole in the oven. See Sketch 2.

ACTK27S/R/B 30S/R/B 11.8.12, 0:40 PM2

(d) Position DUCT (A)-3 on top of the oven

and insert it into DUCT (A)-2. Secure

DUCT (A)-3 using three SCREWS (A)

provided.

Remove the backing paper from the

CUSHION (A). Attach CUSHION (A) along

the flange of DUCT (A)-3.

See Sketch 5.

and insert it into the hold lip of DUCT

(A)-1. Secure DUCT (A)-2 to DUCT (A)-1

using two SCREWS (A) provided.

See Sketch 4.

CUSHION (A)

(b) Position DUCT (A)-1 on the top of the oven inserting edge of DUCT (BC) into hold lip of DUCT (A)-1.

Then tighten two SCREWS (A), securing DUCT (A)-1 to DUCT (BC). See Sketch 3.

ACTK27S/R/B 30S/R/B 11.8.12, 0:40 PM3

STEP 3: INSTALLATION

(a) Place the oven with the right side on a flat surface. Remove the backing paper from the

CUSHION (B). Attach CUSHION (B) beside the screws which fasten the bottom plate. See Sketch

electrical outlet. Then slide the oven into place. Be sure the oven is placed at the center of the

opening. See Sketch 8.

(b) Return the oven to the original position. Install a STOPPER at each of the right and left lower

front corners of the oven as indicated in Sketch 7. Remove the existing screws (#3 and #4) in

these locations and use them to secure the STOPPERS to the oven making sure to use the lower

hole in each STOPPER.

Bottom plate

CUSHION (B)

Screws

STOPPER

(ACTK30)

STOPPER

(ACTK30)

STOPPER

(ACTK27)

STOPPER

(ACTK27)

ACTK27S/R/B 30S/R/B 11.8.12, 0:41 PM4

STEP 4: (a) Position one of SASH (U AND L) over SASH (SIDE) on both sides and position above the oven

and against the wall (or cabinet). Make sure that the upper and vertical SASHES line up properly,

vertically and horizontally with the oven to present a neat and symmetrical appearance. Then

loosely secure the upper SASH (U AND L) to the wall (or cabinet) through upper hole in SASH

(SIDE) using one of SCREW (B) provided. Repeat on opposite side. See Sketch 9.

(b) Place the lower one of SASH (U AND L) against the wall (or cabinet) and up against the bottom

of the oven. Secure the lower SASH (U AND L) to the wall (or cabinet) through the lower hole

in SASH (SIDE) using a SCREW (B) provided. Repeat on opposite side and tighten all screws.

See Sketch 9.

SCREW (B)

SASH (SIDE)

SASH (U AND L)

SASH (SIDE)

SCREW (B)

ACTK27S/R/B 30S/R/B 11.8.12, 0:41 PM5

1 5/8" Min.

(4.1 cm)

3/4" Min.

(1.9 cm)

Microwave cutout

Wall oven cutout

Distinctive Appliances Corporation

600 Anton Blvd. Suite 1000

Costa Mesa, CA 92626

For warranty service: (877) 377-3226

Customer Service: (800) 793-0093

Fax: (626) 403-3130

http://www.dacor.com

TINSEB127WRRZ-DA12 Printed in Japan

CABINET CUTOUT DIMENSIONS

OVER WALL OVEN INSTALLATION OVER WARMING DRAWER INSTALLATION

1 3/8"

(3.5 cm)

Min.

Microwave cutout

3/4"

(1.9 cm)

Min.

Warming

drawer cutout

Microwave cutout

Wall oven cutout Warming

drawer cutout

ACTK27S/R/B 30S/R/B 11.8.12, 0:41 PM6

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Dacor Four

Dacor

Dacor Renaissance RNO127 Manuel utilisateur

Dacor

Dacor Distinctive DTO127 Manuel utilisateur

Dacor

Dacor Renaissance RO130B Manuel utilisateur

Dacor

Dacor Discovery EO127 Manuel utilisateur

Dacor

Dacor Discovery iQ DYO230B Manuel utilisateur

Dacor

Dacor Renaissance Manuel utilisateur

Dacor

Dacor DOB30 977S Series Manuel utilisateur

Dacor

Dacor DOC30M977D Series Manuel utilisateur

Dacor

Dacor Discovery EO127 Manuel utilisateur

Dacor

Dacor DOB30M977DS Manuel utilisateur

Dacor

Dacor ECS136SCH Manuel utilisateur

Dacor

Dacor ECS130SCH Manuel utilisateur

Dacor

Dacor MCS130B Instructions d'installation

Dacor

Dacor EO Series Manuel utilisateur

Dacor

Dacor Wall Oven Manuel utilisateur

Dacor

Dacor EW Manuel technique

Dacor

Dacor DO130 Manuel utilisateur

Dacor

Dacor ECD230SCH Manuel utilisateur

Dacor

Dacor DOB30M977 Series Manuel utilisateur

Dacor

Dacor Renaissance ROV230B Manuel utilisateur

Dacor

Dacor DOB30M977 Series Manuel utilisateur

Dacor

Dacor DYO230 Manuel utilisateur

Dacor

Dacor Renaissance RNWO230 Manuel utilisateur

Dacor

Dacor EOR series Manuel utilisateur

Manuels Four populaires d'autres marques

Bosch

Bosch HVA531NS0 Manuel utilisateur

Electrolux

Electrolux EOF6P46X Manuel utilisateur

NEFF

NEFF B44S32 5GB Series Manuel utilisateur

Combi

Combi BLODGETT BC142GDS Manuel utilisateur

AEG

AEG COMPETENCE 311704300 Manuel utilisateur

Falcon

Falcon DOMINATOR PLUS G3106 Series Guide de l'utilisateur

Rational

Rational SCC WE 61G Manuel utilisateur

Smeg

Smeg DOSPA38X Manuel d'installation et d'exploitation

Electrolux

Electrolux air-o-convect 20 GN 2/1 Manuel utilisateur

Miele

Miele HR 1954-2 Manuel utilisateur

KHIND

KHIND OT50 Manuel utilisateur

Henny Penny

Henny Penny Smoker Box Manuel utilisateur

Lang

Lang ECOD-AP Manuel utilisateur

AEG

AEG BEK455310M Manuel utilisateur

Frigidaire

Frigidaire FNGE90JGR Manuel utilisateur

Hotpoint

Hotpoint FE9 S831 JSH IX Manuel utilisateur

GE Advantium SCB2000 Manuel utilisateur

AEG

AEG DE401301DM Manuel utilisateur