D-Link AirPlus G DWL-G710 Mode d'emploi

Troubleshooting - Can not access DWL-G710 on 192.168.0.30

Please note that when accessing the device's Web interface via http://192.168.0.30 you are not

accessing some web site on the Internet. The device's configuration pages are built into the

device. You do not have to be online to get to those pages, you just need to be connected to the

DWL-G710. Please also make sure all the Anti-virus/firewall software on your computer,

especially Norton, is disabled before you access http://192.168.0.30

Step 1. Connect your computer's network port to your repeater's LAN ports (Ethernet ports)

using a network cable.

Verify physical connectivity by checking for solid link lights on the LAN ports of the device. If

you do not get a solid link light, try using a different cable or connect to a different port on the

device if possible. If the computer is turned off, the link light may not be on.

Step 2. Under Control Panel > Network Connections... make sure that your Local Area

Connection is enabled and not bridged with any other connection. If you see any icon there

which is called "Bridge" - delete it. If you see your Local Area Connection marked as "Bridged" -

right-click and select "Remove from Bridge".

to your computers

DWL-G710 troubleshooting Page 1 of 5

DWL-G710 troubleshooting Page 2of 5

Step 3. Check your IP address. Your computer must have an IP address in the same range of

the DWL-G710

Set your computer with static IP address:

Go to Control Panel > Network Connections > Local Area Connection > Properties:

Select Internet protocol TCP/IP and click on Properties:

DWL-G710 troubleshooting Page 3of 5

Select the "Use the following IP address" and "Use the following DNS" options. Specify the

TCP/IP settings you want to use:

IP address: 192.168.0.5

Subnet mask: 255.255.255.0

Default Gateway: 192.168.0.1

Preferred/Alternate DNS: 202.129.64.198 / 4.2.2.3 (or whichever your provider is using).

Click on OK and then OK again.

Try to access the DWL-G710. Open Internet Explorer and type 192.168.0.30

DWL-G710 troubleshooting Page 4of 5

Step 4. If unsuccessful in accessing the device's configuration pages, please reset the DWL-G710.

Here is how to reset it: while the device is powered on, press and hold the Reset button for 10

sec. Release the button and wait until the device boots up (1 min). Try to log into it again.

Step 5. Check your Internet settings. Go to Control Panel > Internet Options. From the

Security tab, click the button to restore the settings to their defaults.

Go to the Advancedtab and click the button to restore these settings to their defaults.

Click to the Connections tab and set the dial-up option to "Never dial a connection". Click the

LAN Settings button. None of the options should be selected. Click OK. Click OK out to the

desktop and close any open windows.

Restart Internet Explorer and try to access the device.

DWL-G710 troubleshooting Page 5of 5

Step 6. Disable any Internet security software running on the computer. Software firewalls like

Zone Alarm, Black Ice, Sygate, Norton Personal Firewall, etc. might block access to the device's

configuration pages. Check the help files included with your firewall software for more information

on disabling or configuring it.

Step 7. If you still cannot log into the DWL-G710:

- Recycle the power on the device. Switch the power off. Wait 20 to 30 seconds. Switch the power

on and wait for the lights to stabilize.

- Restart the computer.

- Go to: Start > Run> type "cmd" (without quotes) > OK. In the DOS window type:

ping 192.168.0.30

and press Enter. You should see "Reply from..." messages.

If your ping was successful, attempt again to access the device's configuration page.

Try these options in the address window.

192.168.0.30

http://192.168.0.30

http://192.168.0.30:88

If you cannot ping the device check your IP settings. In the DOS window type "ipconfig" (without

quotes) and press Enter. The IP address on your network adapter should be in the 192.168.0.x

range. Type "arp -d" (without quotes) and press Enter. Repeat this command several times until

you get "The specified entry was not found" message. Try to access the device again.

Reset the device. Try using another computer.

Autres manuels pour AirPlus G DWL-G710

4

Table des matières

Autres manuels D-Link Routeur réseau

D-Link

D-Link DSL-2750U Manuel utilisateur

D-Link

D-Link DWM-312 Manuel utilisateur

D-Link

D-Link DIR-808L Manuel utilisateur

D-Link

D-Link DIR-867 Manuel utilisateur

D-Link

D-Link DSL-G2452GE Manuel utilisateur

D-Link

D-Link DGS-1008MP Manuel utilisateur

D-Link

D-Link DSL-G225 Manuel utilisateur

D-Link

D-Link RANGEBOOSTER N 650 Manuel utilisateur

D-Link

D-Link DSL-504T Manuel utilisateur

D-Link

D-Link DGS-3700 Series Manuel utilisateur

D-Link

D-Link DSL-504 Manuel utilisateur

D-Link

D-Link COVR-C1202 Manuel utilisateur

D-Link

D-Link DIR-826L Manuel utilisateur

D-Link

D-Link DWR-920 Mode d'emploi

D-Link

D-Link DWR-920 Manuel utilisateur

D-Link

D-Link DSL-564T Manuel utilisateur

D-Link

D-Link Xtreme N DGL-4500 Manuel utilisateur

D-Link

D-Link AirPlus XtremeG Ethernet-to-Wireless Bridge... Manuel utilisateur

D-Link

D-Link DES-1048G Manuel utilisateur

D-Link

D-Link DAP-1360U Manuel utilisateur

D-Link

D-Link DSL-2542B Manuel utilisateur

D-Link

D-Link DIR-820 Manuel utilisateur

D-Link

D-Link xStack DES-3800 Series Manuel utilisateur

D-Link

D-Link DSL-2750E Manuel utilisateur

Manuels Routeur réseau populaires d'autres marques

Allnet

Allnet ALL0333AU Manuel utilisateur

HomeSeer

HomeSeer HT-SEL Manuel utilisateur

Sercomm

Sercomm Genesis OC3505D Manuel utilisateur

Billion

Billion BIPAC 5102 Series Manuel utilisateur

TP-Link

TP-Link TD-8817 Manuel utilisateur

Motorola

Motorola MR1900 Manuel utilisateur

Digi

Digi IX14 Manuel utilisateur

Cisco

Cisco NCS 540 Manuel

XAVi

XAVi X8821e Manuel utilisateur

BEC

BEC 6200WZL Manuel utilisateur

MikroTik

MikroTik hAP ac3 Series Manuel utilisateur

Korenix

Korenix JetNet 5428G Series Manuel utilisateur

NETGEAR

NETGEAR FS526T - Switch Manuel utilisateur

Korenix

Korenix JetNet 5710G Series Manuel utilisateur

Automated Logic

Automated Logic ZN551 Manuel du propriétaire

Cisco

Cisco ASR 1000 Series Manuel de l'opérateur

EnGenius

EnGenius ESR-9710 Manuel utilisateur

Cisco

Cisco 805 Series Instructions d'utilisation et de sécurité