Cornelius 318569000 Manuel utilisateur

EIMI Cornelius Inc; 1999–2003

February 9, 1999

569000261

Revised: October 9, 2003

IMI CORNELIUS INC gOne Cornelius Place gAnoka, MN 55303-6234

Telephone (800) 238-3600 Facsimile (800) 535-4231

INSTALLATION INSTRUCTIONS

DISPENSING VALVES KEYED LOCK-OUT SWITCH KIT (P/N 569000262)

VANTAGE POST-MIX DISPENSERS

Read and understand these instructions thoroughly before installing this Dispensing Valves Keyed Lock-out

Switch Kit (P/N 569000262) on the Post-Mix Dispensers. The purpose of the Keyed Lock-Out Switch is to shut

off electrical power to the dispensing valves to prevent dispensing of product. Retain these instructions as part

of your equipment manual.

LOOSE-SHIPPED PARTS

Note: Only qualified personnel should install this Kit.

Unpack and inspect kit. Make sure items are present and in good condition.

Table 1. Loose-Shipped Parts

Item

No. Part No. Name Qty

1 560003869 Wiring Harness 1

2 560003870 Template, Hole Drilling 1

3 318948000 Lock Key 1

4 318949000 Hex Nut 1

5 318569000 Key-Lock Switch 1

6 569000261 Installation Instructions 1

KIT INSTALLATION

WARNING: To avoid possible fatal electrical shock or serious injury to Installer, make sure

Dispenser is disconneced from power source before attempting to install this kit.

1. Disconnect electrical power from the Dispenser

2. Remove hood from the Dispenser, then lift hood straight up off the Dispenser for access to the transformer

on the refrigeration deck.

3. Refer to Figure 1 for location of hole to be drilled in the Dispenser hood for installation of the KEY-LOCK

SWITCH (item 5).

4. Place TEMPLATE, HOLE DRILLING (item 2) in position on Dispenser hood as shown in Figure 1.

5. Drill hole in Dispenser hood as indicated on the hole drilling template, then remove template from the hood.

569000261

1.50

TEMPLATE

(ITEM 2)

HOOD

LOCK KEY

(ITEM 3)

KEY-LOCK SWITCH

(ITEM 5)

HEX NUT

(ITEM 4)

FIGURE 1. DISPENSER HOOD

6. Install KEY-LOCK SWITCH (item 5) in the hood as shown in Figure 1 and secure with HEX NUT (item 4).

7. Refering to Wiring Diagram (Figure 2) disconnect black electrical wire, with push-on terminal on it’s end,

from terminal on the transformer outlet.

8. Connect black electrical wire, disconnected from the transformer outlet terminal, to mating electrical wire

terminal on the WIRING HARNESS (item 1).

9. Connect other electrical wire of the wiring harness to output terminal on the transformer where the black

electrical wire was disconnected from in step 7 preceding.

10. Connect other two wiring harness terminals to two terminals on the Key-Lock Switch.

11. Install hood on the Dispenser.

12. Connect electrical power to the Dispenser, then check Dispenser for proper operation.

13. Insert LOCK KEY (item 3) in key-lock switch, then check Dispenser for proper operation.

KEY-LOCK SWITCH

(ITEM 5 )

WHITE

BLACK

MATING

TERMINALS

FIGURE 2. WIRING DIAGRAM

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Cornelius Distributeur

Cornelius

Cornelius ABS 2.0 Manuel utilisateur

Cornelius

Cornelius FCB POST-MIX DISPENSER Supplément

Cornelius

Cornelius HELIX Manuel utilisateur

Cornelius

Cornelius ED22 Series Manuel utilisateur

Cornelius

Cornelius SPIRE 4.2 Guide de sécurité

Cornelius

Cornelius FlavorFusion Manuel utilisateur

Cornelius

Cornelius SUBWAY PEPSI SPIRE 3.0 Guide de configuration

Cornelius

Cornelius IDC175-HD Manuel utilisateur

Cornelius

Cornelius Jetspray JT20-W25 Manuel utilisateur

Cornelius

Cornelius IDC PRO 255 Manuel utilisateur

Cornelius

Cornelius Brewed Iced Tea Supplément

Cornelius

Cornelius IntelliBlue R134 Kuwait Series Manuel utilisateur

Cornelius

Cornelius 2 Flavor Post-Mix Cold Coffee Dispenser Quest... Manuel utilisateur

Cornelius

Cornelius VIPER Manuel utilisateur

Cornelius

Cornelius NITROPRO MINI Manuel utilisateur

Cornelius

Cornelius Bubble Manuel

Cornelius

Cornelius Millenium II Manuel utilisateur

Cornelius

Cornelius IDC 255 PROGATE DRIVE THRU UNIT Manuel utilisateur

Cornelius

Cornelius UF-1 Guide de configuration

Cornelius

Cornelius QUEST ELITE 4290 Manuel utilisateur

Cornelius

Cornelius IDC Pro255 Manuel utilisateur

Cornelius

Cornelius IDC Pro Mode d’emploi

Cornelius

Cornelius Quest Elite 2000 Manuel utilisateur

Cornelius

Cornelius The Profile PR150 BC Manuel utilisateur

Manuels Distributeur populaires d'autres marques

Silver King

Silver King Majestic SK12MAJ Guide de démarrage rapide

Franke

Franke F3Dn Twin Manuel utilisateur

STIEBEL ELTRON

STIEBEL ELTRON UltraHot Plus Manuel utilisateur

DAN DRYER

DAN DRYER 282 Manuel utilisateur

Essity

Essity Tork 473208 Manuel utilisateur

CBS

CBS SD300BU-88 Guide de configuration

Sealey

Sealey MK77 Manuel utilisateur

Fluid Management

Fluid Management Accutinter 1600 Manuel utilisateur

Franke

Franke DVS SD99-010 Manuel utilisateur

Graco

Graco Dispensit 1053-10C Guide de dépannage

ITALTINTO

ITALTINTO i50 Manuel utilisateur

Coca-Cola

Coca-Cola FREESTYLE 9000 Manuel utilisateur

Graco

Graco ProMix 2KE Mode d’emploi

TECHCON SYSTEMS

TECHCON SYSTEMS TS1251 Manuel utilisateur

Wayne

Wayne GLOBAL VISTA CNG Manuel utilisateur

clarsen

clarsen H133 Manuel utilisateur

PicoBrew

PicoBrew Zymatic Manuel utilisateur

BOWMAN

BOWMAN BP-007 Manuel utilisateur