ControlByWeb X-432 Manuel utilisateur
See users manual for setup instructions:
www.ControlByWeb.com/support/
| Quick-Start Guide
X-432
Rev 1.0
1. Power the module and connect to network.
2. Set IP address on computer to be on the same network as
the module. (Example: Set computer to 192.168.1.50)
3. To configure the module, open a web browser and enter:
http://192.168.1.2/setup.html
4. Assign permanent IP address to module, then restart module.
5. Restore computer’s IP address, if necessary, and access the
module at its new IP address to finish setup.
Basic Setup Steps
IP Address: 192.168.1.2
Subnet Mask: 255.255.255.0
Control Page Web Address: http://192.168.1.2
Control Password: (no password set)
Setup Page Web Address: http://192.168.1.2/setup.html
Setup Username: admin
Setup Password: webrelay (all lower case)
Factory Default Settings
1681 West 2960 South, Nibley, UT 84321, USA
| Pinout Diagram
X-432
Input -
Input +
3K
Relay A
Relay B
Opto
Isolator
Relay
+5VRef
AinX
AGnd
5V REF
12-Bit
A/D
1K
Power
Supply
Vin+
Vin-
EGnd
+5VOut
Digital Input 17
Digital Input 18
+5V
+5V Gnd
Data
X16
X16
Power Supply In (9-28VDC)
Power Supply In (Ground)
Table des matières
Autres manuels ControlByWeb Matériel informatique
Manuels Matériel informatique populaires d'autres marques
EMC2
EMC2 VNX Series Manuel du propriétaire
Panasonic
Panasonic DV0PM20105 Manuel utilisateur
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manuel utilisateur
Raidon
Raidon iT2300 Manuel utilisateur
National Instruments
National Instruments PXI-8186 Manuel utilisateur
