Safety Notices
Installation of inside wire may bring you close to
electrical wire, conduit, terminals and other electrical
facilities. Extreme caution must be used to avoid
electrical shock from such facilities. Avoid contact with
electrical current by following these guidelines:
• Use tools with insulated handles.
• Do not place telephone wiring or connections in any
conduit, outlet or junction box containing electrical
wiring.
Note: Do not work on your telephone wiring at all if you
wear a pacemaker. Telephone lines carry
electrical current.
• Telephone wiring must be at least 6 feet from bare
power wiring or lightning rods and associated wires,
and at least 6 inches from other wire (antenna
wires, doorbell wires, wires from transformers to
neon signs), steam or hot water pipes, and heating
ducts.
• Before working with existing inside wiring, check all
electrical outlets for a square telephone dial light
transformer and unplug it from the electrical outlet.
Failure to unplug all telephone transformers can
cause electrical shock.
• Do not place a jack where it would allow a person to
use the telephone while in a bathtub, shower,
swimming pool, or similar hazardous location.
• Protectors and grounding wire placed by the service
provider must not be connected to, removed, or
modified by the customer.
CAUTION: Do not touch telephone wiring during
lightning!
FCC Notices
Radio Frequency Interference (RFI) (FCC 15.105)
This card has been tested and found to comply with the
limits for Class B digital devices pursuant to Part 15 of
the Federal Communications Commission rules.
The RocketModem generates, uses, and can radiate
radio frequency energy, and if not installed and used in
accordance with this card, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, you are encouraged to try and correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and
the receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Labeling Requirements (FCC 15.19)
The RocketModem complies with part 15 of FCC rules.
Operation is subject to the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received,
including interference that may cause undesired
operation.
Modifications (FCC 15.21)
Changes or modifications to this equipment not
expressly approved by Comtrol Corporation may void
the user's authority to operate this equipment.
Cables (FCC 15.27)
This equipment is certified for Class B operation when
used with unshielded cables.
FCC Part 68 Notice
1. This equipment complies with Part 68 of FCC rules.
On the bottom panel of the unit is a label containing
the FCC registration number, ringer equivalence
number, and the USOC jack code.
2. The RocketModem uses FCC compliant modular
plugs, it is designed to be connected to the telephone
network or premises wiring using a compatible
modular jack which is FCC Part 68 compliant.
3. If this equipment causes harm to the telephone
network, the telephone company will notify you in
advance that temporary discontinuance of service
may be required. But, if advance notice is not
practical, the telephone company will notify you as
soon as possible. Also you will be advised of your
right to file a complaint with the FCC, if you believe
it is necessary.
4. The telephone company may make changes in its
facilities, equipment, operations, or procedures that
could affect the operation of the equipment. If this
happens, the telephone company will provide
advance notice in order for you to make necessary
modifications in order to maintain uninterrupted
service.
5. If the equipment is causing harm to the network,
the telephone company may request you to remove
the equipment from the network until the problem
is resolved. If so, contact Comtrol Corporation at
651-631-7654.
6. No repairs are to be made by you. Repairs are to be
made only by Comtrol or its licensees. Unauthorized
repairs void the warranty and the registration.
7. This equipment may not be used for public coin
phone service provided by the Telephone Company.
Connection to Party Line Service is subject to state
tariffs. (Contact the state public utility commission,
public service commission, or corporation
commission for information.)
8. The Telephone Consumer Protection Act of 1991
makes it unlawful for any person to use a computer
or other electronic device, including fax machines, to
send any message unless such message clearly
contains in a margin at the top or bottom of each
transmitted page or on the first page of the
transmission, the date and time it is sent, an
identification of the business or other entity, or other
individual sending the message, and the telephone
number of the sending machine or of such business,
other entity, or individual. (The telephone number
provided may not be a 900 number or any other
number for which charges exceed local or long-
distance transmission charges.) In order to program
this information into your fax software, you should
refer to the manual of the Fax software being used.
RocketModem - Canada
The RocketModem connects directly to off-premises
Common Carrier facilities using the standard two-wire
telephone connection. In some cases, the building’s
inside wiring associated with a single line individual
server may be extended by means of a certified
connector assembly (telephone extension card).
