CommScope NG4access ODF Platform Value-Added Module Manuel utilisateur
300001764826 Rev B
www.commscope.com
TECP-90-708
Issue 5, April 2017
24987-A
Installation Manual (Raised Floor)
NG4access®Frame
TECP-90-708 • Issue 5 • April 2017 • Preface
Page ii
COPYRIGHT
© 2016, CommScope Inc.
All Rights Reserved
REVISION HISTORY
TRADEMARK INFORMATION
CommScope and CommScope (logo), and NG4access are trademarks.
Telcordia is a registered trademark of Telcordia Technologies, Inc.
GORE is a registered trademark of W. L. Gore & Associates, Inc.
DISCLAIMER OF LIABILITY
Contents herein are current as of the date of publication. CommScope reserves the right to change the contents without prior notice.
In no event shall CommScope be liable for any damages resulting from loss of data, loss of use, or loss of profits and
CommScope further disclaims any and all liability for indirect, incidental, special, consequential or other similar damages.
This disclaimer of liability applies to all products, publications and services during and after the warranty period.
This publication may be verified at any time by contacting CommScope’s Technical Assistance Center at:
http://www.commscope.com/SupportCenter
ISSUE DATE REASON FOR CHANGE
1 9/2012 Original.
2 12/2012 Added instructions for installing Raised Floor Cable Clamp Bracket Kit.
3 7/2013 Added instructions for installing the Fiber Optic Storage Panel (FOTSP) and the Auxiliary Cable Spool
Bracket Kit.
4 July 2016 Reformatted for CommScope.
5 April 2017 Corrected Material ID on cover.
TECP-90-708 • Issue 5 • April 2017 • Preface
Page iii
© 2017, CommScope, Inc.
TABLE OF CONTENTS
Content Page
About This Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . v
Related Publications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . v
Admonishments . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .vi
General Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .vi
List of Acronyms and Abbreviations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .vi
1 TOOLS AND MATERIALS REQUIRED. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
2 FOOTPRINT OF FRAME AND FIBER OPTIC STORAGE PANEL (FOTSP) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
3 MOUNTING THE FRAME ON A RAISED FLOOR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
4 INSTALLING A FIBER OPTIC STORAGE PANEL (FOTSP). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30
5 INSTALLING A RAISED FLOOR CABLE BRACKET . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35
6 INSTALLING A SPOOL BRACKET ASSEMBLY (FOR FRAME WITH SPLICE CHASSIS). . . . . . . . . . . . . . . . . . . . . . . . . . 44
7 INSTALLING AUXILIARY CABLE SPOOLS (FOR FRAMES WITHOUT SPLICE CHASSIS) . . . . . . . . . . . . . . . . . . . . . . . . 46
8 GROUNDING THE FRAME . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48
9 SECURING TWO FRAMES TOGETHER. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 49
10 CUSTOMER INFORMATION AND ASSISTANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52
TECP-90-708 • Issue 5 • April 2017 • Preface
Page iv
© 2017, CommScope, Inc.
TABLE OF CONTENTS
Content Page
Blank
TECP-90-708 • Issue 5 • April 2017 • Preface
Page v
© 2017, CommScope, Inc.
ABOUT THIS MANUAL
This manual provides complete instructions for installing a NG4access frame on a raised floor.
Included are instructions for grounding the frame and joining two frames in a lineup.
RELATED PUBLICATIONS
Listed below are related manuals and their publication numbers. Copies of these publications
can be ordered by contacting the CommScope Technical Assistance Center at:
http://www.commscope.com/SupportCenter
NG4access ODF Platform Application and Planning Manual 90-701
Contains an NG4access overview and information for planning a NG4access
application.
NG4access Frame Installation Manual: Concrete Floor 90-702
Provides pictorial instructions for installing an NG4access frame on a concrete
floor and grounding the frame.
NG4access ODF Platform Standard Chassis Installation Manual 90-703
Provides installation instructions for the NG4access standard chassis.
NG4access ODF Platform Splice Chassis and Splice Tray
Installation Manual 90-704
Provides installation instructions for the NG4access standard chassis.
NG4access ODF Platform Patch Cord Routing Guide 90-705
Provides pictorial guidelines for routing patch cords on a lineup consisting of
one or more NG4access frames. This manual consists of laminated cards that
hang on the front of the frame.
NG4access ODF Platform Rear Side Routing Guide 90-706
Provides pictorial guidelines for routing cables and installing cabled modules
on the rear side of a lineup consisting of one or more NG4access frames. This
manual consists of laminated cards that hang on the rear of the frame.
Title/Description Publication Number
TECP-90-708 • Issue 5 • April 2017 • Preface
Page vi
© 2017, CommScope, Inc.
ADMONISHMENTS
Important safety admonishments are used throughout this manual to warn of possible hazards to
persons or equipment. An admonishment identifies a possible hazard and then explains what
may happen if the hazard is not avoided. The admonishments — in the form of Dangers,
Warnings, and Cautions — must be followed at all times. These warnings are flagged by use of
the triangular alert icon (seen below), and are listed in descending order of severity of injury or
damage and likelihood of occurrence.
GENERAL SAFETY PRECAUTIONS
LIST OF ACRONYMS AND ABBREVIATIONS
The following acronyms are used in this manual:
FOT Fiber Optic Terminal
IFC Intra Facility Cable
OSP Outside Plant
Danger: Danger is used to indicate the presence of a hazard that will cause severe personal
injury, death, or substantial property damage if the hazard is not avoided.
Warning: Warning is used to indicate the presence of a hazard that can cause severe personal
injury, death, or substantial property damage if the hazard is not avoided.
Caution: Caution is used to indicate the presence of a hazard that will or can cause minor
personal injury or property damage if the hazard is not avoided.
Danger: Infrared radiation is invisible and can seriously damage the retina of the eye. Do not
look into the ends of any optical fiber. Do not look directly into the optical adapters of the
adapter packs. Exposure to invisible laser radiation may result. An optical power meter should
be used to verify active fibers. A protective cap or hood MUST be immediately placed over any
radiating adapter or optical fiber connector to avoid the potential of dangerous amounts of
radiation exposure. This practice also prevents dirt particles from entering the adapter or
connector.
TECP-90-708 • Issue 5 • April 2017
Page 1
© 2017, CommScope, Inc.
1 TOOLS AND MATERIALS REQUIRED
The tools and materials required for mounting the NG4access frame on a raised floor are
specified in Table 1 and Table 2.
Table 1. Tools Required
TOOL PICTURE
Adjustable wrenches (2)
0.25 to 1 inch (8 to 25.4 mm)
Crow bar
Drill with metal and concrete drill bits
Ruler or tape measure
File
Torque wrench
Note: Capable of 60 ft.-lbs. (81 Nm)
Allen wrench (5/16-inch)
Note: Used for leveling frame
12494-B
12495-B
12496-B
cm
131
12825-a
12497-B
17721-A
18406-A
TECP-90-708 • Issue 5 • April 2017
Page 2
© 2017, CommScope, Inc.
Hacksaw
Hammer
Jigsaw: with blades for cutting floor tile
and metal
Level
Set of combination open end/box wrenches
0.25 to 1 inch (8 to 25.4 mm)
Set of sockets
0.25 to 1 inch (8 to 25.4 mm)
Crimping tool
0.25 to 0.3 inches (6.35 to 7.62 mm)
Note: Used for grounding frame
Table 1. Tools Required, continued
TOOL PICTURE
12499-B
12500-B
12501-B
12502-B
12506-B
12504-B
12824-A
TECP-90-708 • Issue 5 • April 2017
Page 3
© 2017, CommScope, Inc.
Flat tip and Phillip screwdrivers
(#1, #2, and #3)
Vacuum
Table 2. Ground Wire Kit Components (Accessory)
ITEM DESCRIPTION/PICTURE
Ground cable (13 ft.) #6 AWG (4.1 mm) solid copper wire
Nylon cable clamps (8)
12-24 x 0.5 inch screws
2-hole copper compression lug (1) with
0.75-inch hole spacing.
Note: Accommodates #6 AWG wire
Table 1. Tools Required, continued
TOOL PICTURE
12503-B
12505-B
18413-A
18414-A
12498-B
TECP-90-708 • Issue 5 • April 2017
Page 4
© 2017, CommScope, Inc.
Table 3. Other Components Used
ITEM PICTURE
Hold-down washer (4)
(provided with frame)
Concrete floor frame
installation kit
(four anchor bolts)
Zone 2/Zone 4 Raised Floor
Mounting Kit Refer to Table 4
Raised Floor Cable Clamp
Bracket Kit (separately ordered) This kit is required if cables will be routed into the frame from under the
floor. For more information, refer to Section 5 on Page 35
Large Cable Clamp Kit
(separately ordered) This kit is required, in addition to the Raised Floor Cable Clamp Bracket
Kit if large cables will be routed into the frame from under the floor.
Large cables are defined as having an Outside Diameter (OD) of 0.8 in.
(2.03 cm) up to 1.03 in. (2.61 cm). For more information, refer to
Section 5 on Page 35
21899-A
STUD
TORQUE LIMITING HEX NUT
METAL SLEEVE
NYLON SPACER
EXPANDABLE CONE
FLATWASHER
TOP FLANGE
(SHEARS OFF)
PLASTIC COVER
NOTE: ONE PIECE
TORQUE NUT
18008-B
Autres manuels pour NG4access ODF Platform Value-Added Module
4
Table des matières
Manuels Matériel informatique populaires d'autres marques
EMC2
EMC2 VNX Series Manuel du propriétaire
Panasonic
Panasonic DV0PM20105 Manuel utilisateur
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manuel utilisateur
Raidon
Raidon iT2300 Manuel utilisateur
National Instruments
National Instruments PXI-8186 Manuel utilisateur
