Cisco CRS-1 - Carrier Routing System Router Guide de l'utilisateur

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced

Router System Description

Americas Headquarters

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

http://www.cisco.com

Tel: 408 526-4000

800 553-NETS (6387)

Fax: 408 527-0883

THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL STATEMENTS,

INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT WARRANTY OF ANY KIND,

EXPRESS OR IMPLIED. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS.

THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT SHIPPED WITH

THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED WARRANTY,

CONTACT YOUR CISCO REPRESENTATIVE FOR A COPY.

The Cisco implementation of TCP header compression is an adaptation of a program developed by the University of California, Berkeley (UCB) as part of UCB's public domain version of

NOTWITHSTANDING ANY OTHER WARRANTY HEREIN, ALL DOCUMENT FILES AND SOFTWARE OF THESE SUPPLIERS ARE PROVIDED “AS IS" WITH ALL FAULTS.

CISCO AND THE ABOVE-NAMED SUPPLIERS DISCLAIM ALL WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, WITHOUT LIMITATION, THOSE OF

MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT OR ARISING FROM A COURSE OF DEALING, USAGE, OR TRADE PRACTICE.

IN NO EVENT SHALL CISCO OR ITS SUPPLIERS BE LIABLE FOR ANY INDIRECT, SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES, INCLUDING, WITHOUT

LIMITATION, LOST PROFITS OR LOSS OR DAMAGE TO DATA ARISING OUT OF THE USE OR INABILITY TO USE THIS MANUAL, EVEN IF CISCO OR ITS SUPPLIERS

HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output, network

topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative content is unintentional

and coincidental.

All printed copies and duplicate soft copies of this document are considered uncontrolled. See the current online version for the latest version.

Cisco has more than 200 offices worldwide. Addresses and phone numbers are listed on the Cisco website at www.cisco.com/go/offices.

Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL:

https://www.cisco.com/c/en/us/about/legal/trademarks.html. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a

partnership relationship between Cisco and any other company. (1721R)

CONTENTS

Preface vii

PREFACE

Objective vii

Audience vii

Related Cisco CRS Documentation vii

Changes to This Document viii

Obtaining Documentation and Submitting a Service Request ix

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router Overview 1

CHAPTER 1

Chassis Overview 1

Overview 1

Cisco 8-Slot Chassis Components 2

Power Components 2

Routing and Switch Fabric Components 4

CRS 8-Slot System Architecture 5

Cisco CRS 8-Slot Line Card Chassis Enhanced Router Main Features 5

Chassis Slot Numbers 6

Cable Management 7

Exterior Cosmetic Components 8

Control Plane and Data Plane Overview 8

System Discovery and Inventory 8

High Availability 9

Control Plane Components 10

CRS Hardware Compatibility 12

Cisco CRS 8-Slot Line Card Chassis Enhanced Router Power Systems 15

CHAPTER 2

Cisco CRS 8-Slot Chassis Power Systems 15

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router System Description

iii

Power Systems Overview 15

Power Component Information Common to Two Types of Power System 16

Basic Chassis Power Details 16

Power System-Modular Configuration 16

Precautions and Recommendations 16

Grounding Guidelines 17

DC Power Systems 17

AC Power Systems 18

Enhanced Router Modular Configuration Power System 18

Overview-Modular Power Configuration 18

Modular Configuration Power Architecture 21

Modular Configuration DC Power 21

Modular Configuration AC Power 25

Cisco CRS 3-Phase AC Power Distribution Unit 30

Cooling System 33

CHAPTER 3

Cooling System 33

Cooling System Overview 33

Line Card Chassis Enhanced Router Airflow 34

Cooling System Operation 35

Cooling System Redundancy 36

Cisco CRS 8-Slot Line Card Chassis Enhanced Router Fan Tray 36

Switch Fabric 39

CHAPTER 4

Switch Fabric 39

Switch Fabric Overview 39

Switch Fabric Operation 40

Speed-up Function 41

S2 and S3 Buffering 41

Failure Operation 41

Switch Fabric Card Description 41

Line Cards and Physical Layer Interface Modules Overview 45

CHAPTER 5

Line Cards and Physical Layer Interface Modules Overview 45

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router System Description

Contents

Overview of Line Cards and Physical Layer Interface Modules 45

PLIM Physical Interface Module On Ingress 47

MSC Ingress Packet Engine 47

MSC To Fabric Section Queuing 48

MSC From Fabric Section 48

MSC Egress Packet Engine 48

Shaping and Queuing Function 48

PLIM Physical Interface Section On Egress 48

MSC CPU and CPU Interface 48

Line Card Physical Descriptions 49

Physical Layer Interface Modules 52

OC-768 Packet-Over-SONET (POS) PLIMs 53

OC-192 Packet-Over-SONET/Dynamic Packet Transport PLIMs 54

OC-48 Packet Over SONET/Dynamic Packet Transport PLIMs 55

10-Gigabit Ethernet XENPAK PLIM 58

8-Port 10-GE PLIM with XFP Optics Modules 59

4-Port 10-GE PLIM with XFP Optics Modules 61

1-Port 100-GE PLIM with CFP Optics Module 62

20-Port 10-GE PLIM with XFP Optics Modules 64

14-Port 10-GE PLIM with XFP Optics Modules 65

XFP Optics Power Management 67

PLIM Impedance Carrier 67

Route Processor 69

CHAPTER 6

Route Processor 69

Route Processor Overview 69

Active and Standby Arbitration 72

RP Card to Fabric Module Queuing 72

Distributed Route Processor 73

DRP Card 74

DRP PLIM 75

Limitations and Restrictions 76

Performance Route Processor 76

Performance Route Processor Front Panel 78

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router System Description

Contents

Performance Route Processor Overview 78

CRS 8-Slot Line Card Chassis Enhanced Router Specifications 83

APPENDIX A

Technical Specifications 83

Chassis Specifications 83

Modular Configuration Power Specifications 84

Environmental Specifications 85

Regulatory, Compliance, and Safety Specification 86

Product IDs 87

APPENDIX B

Product IDs 87

Chassis Product IDs 87

Optional MSC, FP, PLIM, SIP, and SPA Product IDs 89

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router System Description

Contents

Preface

This preface explains the objectives, intended audience, and organization of this Cisco CRS Carrier Routing

System 8-Slot Line Card Chassis Enhanced Router System Description , commonly referred to as the "system

description" in this document, and presents the conventions used in this manual .

•Objective, on page vii

•Audience, on page vii

•Related Cisco CRS Documentation, on page vii

•Changes to This Document, on page viii

•Obtaining Documentation and Submitting a Service Request, on page ix

Objective

This guide describes the Cisco CRS 8-Slot Line Card Chassis Enhanced router from a system point of view.

This guide focuses on the hardware elements, including descriptions of most of the major assemblies, such

as the power and cooling systems, the switch fabric, route processor, and modular services cards. It also

provides background information and the basic theory of operation for this routing system .

This guide can be read as a supplement to the Site Planning Guide, Installation Guide, and the related software

documents.

Audience

This guide is intended for service provider customers and Cisco installation partners who have substantial

background in configuring router-based internetworks and experience with routers and Cisco IOS XR software.

The system description provides a high-level introduction to the components and vocabulary used within the

Cisco CRS 8-Slot Line Card Chassis Enhanced router product.

Related Cisco CRS Documentation

For a complete listing of planning, installation, and configuration documents, see the following publications:

• Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router Unpacking, Moving, and

Securing Guide

• Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router Site Planning Guide

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router System Description

vii

• Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router Installation Guide

• Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide

• Cisco CRS Carrier Routing System Regulatory Compliance and Safety Information

Changes to This Document

Table 1: Changes to This Document

Change SummaryDate

Added information about the new back-to-back fabric

card CRS-8-FC400/M

April 2015

Added support for the CRS-MSC-X-L and

CRS-FP-X-L line cards.

December 2014

Added support for new 2x100GE-FLEX-40 PLIM.July 2014

Added updates to support the Cisco CRS-X, which

includes new line cards, switch fabric cards, and

PLIMs.

January 2014

Added updates to support new fan tray.September 2013

Added corrections based on unpacking, moving and

installing process changes.

May 2012

Initial release of this document.

This document introduces the Cisco CRS 8-Slot Line

Card Chassis Enhanced router. The Cisco CRS 8-Slot

Line Card Chassis Enhanced router includes the

following new features :

• The mid-plane on the Cisco CRS 16-Slot Line

Card Chassis Enhanced router is redesigned to

support 400G per slot.

• The Cisco CRS 8-Slot Line Card Chassis

Enhanced router has its own power and cooling

subsystems .

• A new power shelf with an upgraded 70 Amp

circuit breaker has been introduced for the new

Cisco CRS 8-Slot Line Card Chassis Enhanced

router .

• The Cisco CRS 8-Slot Line Card Chassis

Enhanced router removes the zone circuit breaker

and thus, eliminates power-zoning .

January 2012

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router System Description

viii

Preface

Changes to This Document

Obtaining Documentation and Submitting a Service Request

For information on obtaining documentation, using the Cisco Bug Search Tool (BST), submitting a service

request, and gathering additional information, see What's New in Cisco Product Documentation, at:

http://www.cisco.com/c/en/us/td/docs/general/whatsnew/whatsnew.html.

Subscribe to What's New in Cisco Product Documentation, which lists all new and revised Cisco technical

documentation as an RSS feed and delivers content directly to your desktop using a reader application. The

RSS feeds are a free service, and Cisco currently supports RSS Version 2.0.

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router System Description

Preface

Obtaining Documentation and Submitting a Service Request

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Enhanced Router System Description

Preface

Obtaining Documentation and Submitting a Service Request

Autres manuels pour CRS-1 - Carrier Routing System Router

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Cisco Matériel réseau

Cisco

Cisco ONS 15454 SDH E1-75 Manuel utilisateur

Cisco

Cisco ASR 9000 Series Manuel utilisateur

Cisco

Cisco GS7000 Mode d'emploi

Cisco

Cisco Octal-Port DMT ATU-C Line Card Manuel technique

Cisco

Cisco C7200-I - Input/Output Controller - Control... Manuel utilisateur

Cisco

Cisco 5400 Series Mode d’emploi

Cisco

Cisco SOURCEfire 3D500 Manuel utilisateur

Cisco

Cisco ASA Guide de démarrage rapide

Cisco

Cisco Linksys Business Series Network Storage System... Manuel utilisateur

Cisco

Cisco CSS11501 - 100Mbps Ethernet Load Balancing... Manuel utilisateur

Cisco

Cisco LightStream 1010 Manuel utilisateur

Cisco

Cisco UCS-FI-6332-16UP Manuel utilisateur

Cisco

Cisco OL-6109-01 Manuel utilisateur

Cisco

Cisco 3660 Series Manuel utilisateur

Cisco

Cisco IPS-4260-K9 - IPS Sensor 4260 Manuel utilisateur

Cisco

Cisco ASR 5500 Manuel utilisateur

Cisco

Cisco GS7000 Manuel utilisateur

Cisco

Cisco ONS 15454 Mode d’emploi

Cisco

Cisco 8011-2X2XP4L Manuel

Cisco

Cisco Wide Area Virtualization Engine 274 Manuel

Cisco

Cisco ONS 15454 SDH E1-75 Manuel utilisateur

Cisco

Cisco ASR 9000 Series Manuel utilisateur

Cisco

Cisco ASR 5000 Manuel utilisateur

Cisco

Cisco Firepower 1010 Manuel utilisateur

Manuels Matériel réseau populaires d'autres marques

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuel utilisateur

Yudor

Yudor YDS-16 Manuel utilisateur

D-Link

D-Link ShareCenter DNS-320L Manuel utilisateur

Samsung

Samsung ES1642dc Instructions d'utilisation

Honeywell Home

Honeywell Home LTEM-PV Instructions de montage

evertz

evertz 7700 Series Manuel utilisateur

D-Link

D-Link ShareCenter DNS-343 Manuel utilisateur

Asante

Asante AsanteBridge 1012 Manuel utilisateur

FireBrick

FireBrick FB2700 Manuel utilisateur

Audiovox Electronics

Audiovox Electronics ARWH2T Manuel utilisateur

ADC

ADC DSX-1 Manuel

NetComm

NetComm NF2 Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 5620 Manuel utilisateur

Dell EMC

Dell EMC XC6420 Series Manuel utilisateur

Lanner

Lanner NCA-1020A Manuel utilisateur

Allied Telesis

Allied Telesis AT-TN121-A Manuel utilisateur

Arista

Arista CCA-ETM-Q12 Manuel utilisateur