Checkpoint NGX R66 Manuel utilisateur

Connectra Appliance

Getting Started Guide

NGX R66

702365 November 5, 200

Health and Safety Information

Read the following warnings before setting up or using the appliance.

To prevent damage to any system board, it is important to handle it with care. The

following measures are generally sufficient to protect your equipment from static

electricity discharge:

•When handling the board, to use a grounded wrist strap designed for static

discharge elimination.

•Touch a grounded metal object before removing the board from the antistatic bag.

•Handle the board by its edges only. Do not touch its components, peripheral chips,

memory modules or gold contacts.

•When handling processor chips or memory modules, avoid touching their pins or

gold edge fingers.

•Restore the communications appliance system board and peripherals back into the

antistatic bag when they are not in use or not installed in the chassis. Some

circuitry on the system board can continue operating even though the power is

switched off.

•Under no circumstances should the Lithium battery cell used to power the

real-time clock be allowed to short. The battery cell may heat up under these

conditions and present a burn hazard.

Warning - Do not block air vents. A minimum 1/2-inch clearance is

required.

Warning - This appliance does not contain any user-serviceable parts.

Do not remove any covers or attempt to gain access to the inside of the

product. Opening the device or modifying it in any way has the risk of

personal injury and will void your warranty. The following instructions

are for trained service personnel only.

Warning - DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY

REPLACED. REPLACE ONLY WITH SAME OR EQUIVALENT TYPE

RECOMMENDED BY THE MANUFACTURER. DISCARD USED

BATTERIES ACCORDING TO THE MANUFACTURER'S INSTRUCTIONS

•Disconnect the system board power supply from its power source before you

connect or disconnect cables or install or remove any system board components.

Failure to do this can result in personnel injury or equipment damage.

•Avoid short-circuiting the lithium battery; this can cause it to superheat and cause

burns if touched.

•Do not operate the processor without a thermal solution. Damage to the processor

can occur in seconds.

distributed under licensing restricting their use, copying, distribution, and decompilation. No part of

this product or related documentation may be reproduced in any form or by any means without prior

written authorization of Check Point. hile every precaution has been taken in the preparation of

this book, Check Point assumes no responsibility for errors or omissions. This publication and

features described herein are subject to change without notice.

RESTRICTED RIGHTS LEGEND:

Use, duplication, or disclosure by the government is subject to restrictions as set forth in

subparagraph (c)(1)(ii) of the Rights in Technical Data and Computer Software clause at DFARS

252.227-7013 and FAR 52.227-19.

TRADEMARKS:

Please refer to http://www.checkpoint.com/copyright.html for a list of our trademarks.

For third party notices, see http://www.checkpoint.com/3rd_party_copyright.html.

Content

Chapter 1

Introduction to Connectra

Welcome.................................................................................12

Overview ................................................................................. 13

Shipping Carton Contents .........................................................14

Terminology ............................................................................15

Chapter 2

Deploying Connectra

Deployment Overview ...............................................................1

Deploying Connectra in the DMZ ...............................................19

Deploying Connectra on a LAN ..................................................20

Deploying a Connectra Cluster................................................... 21

Chapter 3

In talling and Configuring Connectra

Installation and Configuration Workflow .....................................24

Installation and Initial Configuration Stages ...................... 24

Installation and Initial Configuration Procedures .........................26

Step 1: Preparing for Centrally Managed Connectra............ 26

Step 2: Installing Connectra............................................. 2

Step 3: Identifying the Default Management Interface........ 31

Step 4: Connecting the Cables and Turning On.................. 31

Step 5: Connecting to the Administration User Interface..... 32

Step 6: Running the First Time Configuration Wizard ......... 34

Step 7: Installing the SmartConsole GUI Clients ................ 36

Step : Logging In for the First Time ................................ 37

Step 9: Defining Connectra Objects (Centrally Managed

Connectra) ..................................................................... 3

Post-Installation Procedures......................................................41

Step 10: Connecting Connectra to the Network .................. 41

Step 11: Configuring Access Control ................................. 41

Step 12: Performing a SmartDefense Update (Locally Managed

Connectra)...................................................................... 43

Step 13: Checking Your Setup.......................................... 44

Installing the NGX R66 Plug-in .................................................45

Installing the Plug-in on a SmartCenter ............................. 45

Installing the Plug-in on Provider-1/SiteManager-1 ............. 47

Uninstalling Connectra Plug-ins........................................ 50

Cluster Configuration—Deployment Tips ....................................51

SSL Acceleration Card Installation.............................................53

Enabling the Card ........................................................... 53

Disabling the Card........................................................... 53

SSL Acceleration Card Command Syntax ........................... 54

Further Information ..................................................................55

Chapter 4

Connectra Hardware

Overview .................................................................................57

Front Panel Components .................................................. 5

Rear Panel Components................................................... 64

Customer Replaceable Parts......................................................66

Power Supply.................................................................. 67

Cooling Fan .................................................................... 6

Expansion Line Card........................................................ 69

Hard Disk Drive............................................................... 71

Restoring Factory Defaults ........................................................74

Restoring Using the WebUI .............................................. 74

Restoring Using the Console Boot Menu ............................ 75

Restoring Using the LCD Panel......................................... 77

Table of Contents 9

Chapter 5

Upgrading Connectra

Introduction to Advanced Upgrade ............................................ 2

Advanced Upgrade to Locally Managed R66 .............................. 3

Preparing for Advanced Upgrade to Locally Managed R66 .. 3

Advanced Upgrade Procedure to Locally Managed R66 ...... 3

Completing the Advanced Upgrade to R66........................ 5

Upgrade to Centrally Managed R66 from R61/62/62CM ............. 7

Setting Up the SmartCenter and Installing the R66 Plug-in 7

Setting Up SIC Trust ...................................................... 90

Installing Policy ............................................................. 91

Completing the Upgrade by Merging Manual Changes ........ 91

Upgrading a Connectra Cluster to R66 ...................................... 92

Chapter 6

Unin talling Connectra Plug-in

Overview ................................................................................ 93

Uninstalling the R66 Plug-in for Central Management ................ 94

Before Uninstalling the R66 Plug-in:................................ 94

Uninstalling the R66 Plug-in ........................................... 94

Removing the R66 Compatibility Package......................... 95

Uninstalling the Connectra NGX R62CM Plug-in ........................ 97

Removing the R62CM Compatibility Package .................... 9

Uninstalling Plug-ins in Provider-1............................................ 99

Deactivating Plug-ins on the MDS .................................... 99

Uninstalling the R62CM Plug-in in Provider-1................... 99

Chapter 7

Regi tration and Support

Registration .......................................................................... 101

For Connectra Cluster Users .......................................... 101

Support.................................................................................102

Where To From Here? .............................................................103

Chapter 8

Note

My Connectra Appliance .........................................................105

Index .................................................................. 109

Table des matières

Autres manuels Checkpoint Matériel réseau

Checkpoint

Checkpoint 5000 Series Manuel utilisateur

Checkpoint

Checkpoint QUANTUM SMART-1 6000-L/6000-XL Manuel utilisateur

Checkpoint

Checkpoint QUANTUM SPARK 1500 Mode d’emploi

Checkpoint

Checkpoint 21000 Series Mode d’emploi

Checkpoint

Checkpoint TE2000XN Manuel utilisateur

Checkpoint

Checkpoint Smart-1 225 Manuel utilisateur

Checkpoint

Checkpoint Smart-1 5050 Mode d’emploi

Checkpoint

Checkpoint 730 Manuel utilisateur

Checkpoint

Checkpoint 5000 Series Manuel utilisateur

Checkpoint

Checkpoint 4200 Manuel utilisateur

Checkpoint

Checkpoint QUANTUM MAESTRO Manuel utilisateur

Checkpoint

Checkpoint TE250X Manuel utilisateur

Checkpoint

Checkpoint 770 Manuel utilisateur

Checkpoint

Checkpoint 12000 Manuel utilisateur

Checkpoint

Checkpoint Smart-1 205 Manuel utilisateur

Checkpoint

Checkpoint MHO170 Manuel utilisateur

Checkpoint

Checkpoint Smart-1 625 Mode d’emploi

Checkpoint

Checkpoint 910 Manuel utilisateur

Checkpoint

Checkpoint QUANTUM SMART-1 Manuel utilisateur

Checkpoint

Checkpoint 1500 Series Mode d’emploi

Checkpoint

Checkpoint 21000 Appliances G-70 Manuel utilisateur

Checkpoint

Checkpoint VPN-1 Edge X Series Manuel utilisateur

Checkpoint

Checkpoint 1570 Manuel utilisateur

Checkpoint

Checkpoint QUANTUM FORCE 19000 Manuel utilisateur

Manuels Matériel réseau populaires d'autres marques

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuel utilisateur

Yudor

Yudor YDS-16 Manuel utilisateur

D-Link

D-Link ShareCenter DNS-320L Manuel utilisateur

Samsung

Samsung ES1642dc Instructions d'utilisation

Honeywell Home

Honeywell Home LTEM-PV Instructions de montage

evertz

evertz 7700 Series Manuel utilisateur

D-Link

D-Link ShareCenter DNS-343 Manuel utilisateur

Asante

Asante AsanteBridge 1012 Manuel utilisateur

FireBrick

FireBrick FB2700 Manuel utilisateur

Audiovox Electronics

Audiovox Electronics ARWH2T Manuel utilisateur

ADC

ADC DSX-1 Manuel

NetComm

NetComm NF2 Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 5620 Manuel utilisateur

Dell EMC

Dell EMC XC6420 Series Manuel utilisateur

Lanner

Lanner NCA-1020A Manuel utilisateur

Allied Telesis

Allied Telesis AT-TN121-A Manuel utilisateur

Arista

Arista CCA-ETM-Q12 Manuel utilisateur