2S-12S LiPo & LiFe battery Monitor and Saver BS12 V2.3
www.chargery.com page 5 total 6
When two packs is connected in series or parallel or short circuit the jump port, you can connect any
combo battery pack to socket 1 and socket 2 on condition that the total cell count less than 12, such
as 6S+6S, 2S+6S, 5S+6S, 6S+3S, 6S+5S and so on.
Specifications:
Battery range: 2S-12S LiPo & LiFe battery pack
Over charge warning cell voltage: 3.00~4.30V step 0.05V, default 4.25V
Over discharge warning cell voltage: 2.00~4.00V step 0.05V, default 3.30V
Wait time when start to warn: 0.0S~20S, step 0.5 second, default 0.5S
Alarm time range:1S~60S, step 1 second, default 2S
LCD Back-light time range:1min, 5min, 10min, 20min and always on, default 5min
Accurate scope of the warning voltage: -20mV/+20mV
Cell voltage display range:0.50V~4.99V, NO display when under 0.50V
Pins distance: 2.54mm
Size:62*44.5*6 ( L*W*T, mm)
Weight: 30g
Warning LED: 11000mCd, @ 2.0V, 20mA
Two Warning beepers: 100db @ 12V and 10cm
Package: transparent heat shrink tube
Program setup
Before flight, you can enter into Program setup menu, and set up the parameter according to your
need such as over charge voltage, LCD back-light time etc.
1. Connect 2S (LiPo 7.4V, LiFe 6.4V) or under 6S
battery to the socket 1.
2. Press SET button for 3 seconds enter into
Program Setup menu.
3. Press UP/DOWN button select the item, press
SET shortly make the value flash, and press UP
/ DOWN change the value. Press SET button
shortly confirm the change. After finish all
setup, press SET for 3 seconds save change
and quit the setup menu.
4. Over charge warning voltage range is 3.00~4.30V per cell, step 0.05V, default 4.25V. During
charge, when any cell voltage over the value, the unit will alarm.
5. Over discharge warning voltage range is 2.00~4.00V step 0.05V, default 3.00V. During flight,
when any cell voltage under the value, the unit will alarm.
6. Delay time when start to warn range is 0.0S~20S, step 0.5 second, default 2.0S. Delay time
means the waiting time from cell voltage reach set up value to start alarming.
7. Warning time range is 1S~60S, step 1 second, default 2S.
8. LCD back-light time range is 1, 5, 10, 20min and always ON, default 5min. when LCD
back-light “ON” time reach setup value, it will turn off, and press any button to resume. If the
back-light time is always on, it is invalid.
9. When quit setup mode, the device will remember all parameters till next change.
