Chamberlain 953EV Manuel utilisateur

3-BUTTON REMOTE CONTROLS

MODELS 953EV, 953EVC, 956EV AND 956EVC

To prevent possible SERIOUS INJURY or

DEATH from a moving gate or garage door:

• ALWAYS keep remote controls out of

reach of children. NEVER permit children

to operate or play with remote controls.

• Activate gate or door ONLY when it can be

seen clearly, is properly adjusted and there

are no obstructions to door travel.

• ALWAYS keep gate or garage door in sight

until completely closed. NEVER permit

anyone to cross path of moving gate or

door.

For use with Chamberlain 315 MHz or 390 MHz garage door openers manufactured after

January 1, 1993. The garage door opener activates when the programmed button on the

remote control is pressed. The remote control can activate up to three garage door openers.

Make sure the garage door opener has a working light bulb because it is a programming

indicator.

LED LED

Locate the Program button on the

remote control.

Locate the Learn

button on the garage

door opener.

NOTE: Your garage door

opener may look different.

OR OR

Learn

LED

Learn

LED

Learn

LED

Green

Red/Orange

Purple Yellow Program Button

Program Button

Press and release the Learn

button on the garage door

opener.

3To exit programming mode,

press any remote control

button except the button

that was just programmed.

Install the visor clip.

Press the remote control button

programmed in step 2 until the

garage door opener lights ﬂash

or two clicks are heard.

To test, press the programmed

button on the remote control...

Within 30 seconds...

The Learn LED will light.

Press and hold the program button

the remote control until the LED on

the front of the remote control

turns on.

Learn

Button

Click

The garage door

opener will activate.

2Press and release the remote control button you wish to use the

number of times that corresponds with the garage door opener type:

# of Presses Garage Door Opener Type

Security+ 2.0TM (Yellow Learn Button)

315 MHz Security+®(Purple Learn Button)

390 MHz Security+®(Red/Orange Learn Button)

390 MHz Billion Code (Green Learn Button)

MODELS 953EV AND 953EVC MODELS 956EV AND 956EVC

GARAGE ACCESS SYSTEM

REMOTE

GARAGE ACCESS SYSTEM

KEYCHAIN REMOTE

PREPARE

PROGRAM THE REMOTE CONTROL (953EV & 953EVC)

953EV &

953EVC

956EV &

956EVC

Press and release the Learn

button on the garage door

opener.

3To exit programming mode,

press any remote control

button except the button

that was just programmed.

Press the remote control button

programmed in step 2 until the

garage door opener lights ﬂash

or two clicks are heard.

Within 30 seconds...

The Learn LED will light.

Press and hold the program button

the remote control until the LED on

the front of the remote control

turns on.

Safety pin or

paper clip

Learn

Button

Click

2Press and release the remote control button you wish to use the

number of times that corresponds with the garage door opener type:

# of Presses Garage Door Opener Type

Security+ 2.0TM (Yellow Learn Button)

315 MHz Security+®(Purple Learn Button)

390 MHz Security+®(Red/Orange Learn Button)

390 MHz Billion Code (Green Learn Button)

To test, press the programmed button on the remote control...

The garage door opener

will activate.

NOTICE: To comply with FCC and or Industry Canada rules (IC),

adjustment or modifications of this receiver and/or transmitter

are prohibited, except for changing the code setting or replacing

the battery. THERE ARE NO OTHER USER SERVICEABLE

PARTS.

This device complies with Part 15 of the FCC rules and IC RSS-

210. Operation is subject to the following two conditions: (1)

this device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

BATTERY

The LED on your remote will stop flashing when the battery is low and needs to be replaced.

To replace battery, open the case as shown. Insert battery positive side up (+). Replace the battery

with only 3V CR2032 coin cell batteries. Dispose of old battery properly. To prevent possible SERIOUS INJURY or

DEATH:

• NEVER allow small children near batteries.

• If battery is swallowed, immediately notify

doctor.

To reduce risk of fire, explosion or chemical

burn:

• Replace ONLY with 3V CR2032 coin

batteries.

• DO NOT recharge, disassemble, heat

above 212° F (100° C) or incinerate.

1-800-528-9131

REPLACEMENT PARTS

Battery . . . . . . . . . . . . . . . . . . . . . . . . . . 10A20

Visor Clip

(Models 953EV & 953EVC ONLY) . . . . 29B137

WARRANTY

www.chamberlain-diy.com

ONE YEAR LIMITED WARRANTY

The Chamberlain Group, Inc. warrants to the first retail purchaser of this product that is free from

defect in materials and/or workmanship for a period of 1 year from the date of purchase.

Pry open the case with a screwdriver blade.

956EV & 956EVC

Pry open the case first in the middle (1), then

at each side (2 and 3) with the visor clip.

953EV & 953EVC

PROGRAM THE REMOTE CONTROL (956EV & 956EVC)

Ce manuel convient aux modèles suivants

Autres manuels Chamberlain Télécommande

Chamberlain

Chamberlain 811LM Manuel utilisateur

Chamberlain

Chamberlain 4330E Manuel utilisateur

Chamberlain

Chamberlain Passport PPV3 Manuel utilisateur

Chamberlain

Chamberlain LiftMaster 333LM Manuel utilisateur

Chamberlain

Chamberlain LiftMaster Professional 412HM Manuel utilisateur

Chamberlain

Chamberlain LiftMaster Professional 82LM Manuel utilisateur

Chamberlain

Chamberlain 956CB Manuel utilisateur

Chamberlain

Chamberlain LiftMaster 375LM Manuel utilisateur

Chamberlain

Chamberlain KLIK3U-BK2 Manuel utilisateur

Chamberlain

Chamberlain KLIK3U-BK2 Manuel utilisateur

Chamberlain

Chamberlain Security+ 953-315CB Manuel utilisateur

Chamberlain

Chamberlain KLIK5U-WP Manuel utilisateur

Chamberlain

Chamberlain LIFT-MASTER 83LM Manuel utilisateur

Chamberlain

Chamberlain 955CD Manuel utilisateur

Chamberlain

Chamberlain Security+ 963CD Manuel utilisateur

Chamberlain

Chamberlain Clicker KLIK1U Manuel utilisateur

Chamberlain

Chamberlain TX2EV Manuel utilisateur

Chamberlain

Chamberlain 33LMC Manuel utilisateur

Chamberlain

Chamberlain Power Drive Whisper Drive Security+ 953D Manuel utilisateur

Chamberlain

Chamberlain CPT4 Manuel utilisateur

Chamberlain

Chamberlain KLIK3U Manuel utilisateur

Chamberlain

Chamberlain Security+ 956-315CB Manuel utilisateur

Chamberlain

Chamberlain SECURITY+ 535LM Manuel utilisateur

Chamberlain

Chamberlain MC100C Manuel utilisateur

Manuels Télécommande populaires d'autres marques

Panasonic

Panasonic EUR7622KB0 Manuel utilisateur

Bang & Olufsen

Bang & Olufsen Beo4 Manuel utilisateur

Sunwave Tech.

Sunwave Tech. RemoteComm SRC-7000 Manuel utilisateur

Multiplex

Multiplex PROFI TX 9 Manuel utilisateur

One Remote

One Remote RMB4 Manuel utilisateur

FUTABA

FUTABA 9ZAP - PART2 Manuel utilisateur

HR Matic

HR Matic HR MULTI 3 Manuel utilisateur

Yamaha

Yamaha ACC-GNRST-30-20 Manuel utilisateur

EisSound

EisSound KBSOUND Manuel utilisateur

Marantz

Marantz RC101 Manuel utilisateur

Conrad

Conrad FS20 TC6 Manuel utilisateur

Anritsu

Anritsu MP1777A Manuel utilisateur

Niles

Niles WVC100 Guide de dépannage

RCA

RCA RCU1300 Manuel utilisateur

Bang & Olufsen

Bang & Olufsen BEO6 Manuel utilisateur

GE 94901 Manuel utilisateur

Onbon

Onbon YQ1-75 Manuel utilisateur

FUTABA

FUTABA R7108SB Instructions d'installation