Canon Pixma MG3500 Series Manuel utilisateur

PIXMA MG3500

Setup Guide

series

Setup Guide

This guide provides information for setting up a network connection for the printer.

Network Connection

Wireless Connection

Preparation for Connection

Connection Using WPS

Troubleshooting

Network Connection

Wireless Connection

aPreparation for Connection

Before Starting Wireless Connection Setup

1. Make sure that the printer is turned on.

If the power is on, the (green) POWER lamp (A) will be lit.

Notes on Wireless Connection

Make sure that the computer is connected to the access point (A) (or wireless network router) you want to connect your

printer to. For details on how to check the settings, refer to the manual supplied with the router or contact its manufacturer.

The conguration, router functions, setup procedures and security settings of the network device vary depending on your

system environment. For details, refer to the manual of your network device or contact its manufacturer.

Check if your device supports IEEE802.11n (2.4 GHz), IEEE802.11g or IEEE802.11b.

If your device is set to the "IEEE802.11n only" mode, WEP or TKIP cannot be used as a security protocol. Change the

security protocol for your device to something other than WEP and TKIP or change the setting to something other than

"IEEE802.11n only."

For ofce use, consult your network administrator.

Take added care when connecting to a network that is not protected with security measures, as there is a risk of disclosing

data such as your personal information to a third party.

An "Ad-hoc connection," which establishes a direct connection to the computer over a wireless connection without an

access point, is not supported. Be sure to prepare an access point.

•

bConnection Using WPS

1. Make sure that the button on the access point is ready to be pressed.

2. Hold down the Wi-Fi button (A) on the printer until the (orange) Alarm lamp (B) ﬂ ashes once, then

release the Wi-Fi button after the ﬂ ash.

3. Make sure that the (blue) Wi-Fi lamp (C) ﬂ ashes quickly and the (green) POWER lamp is lit as shown

in the illustration on the right above, then press and hold the button on the access point within 2

minutes.

4. Make sure that the (blue) Wi-Fi lamp and the (green) POWER lamp are lit.

The network connection setup is now complete.

Troubleshooting

WPS

When the (blue) Wi-Fi lamp ﬂ ashes slowly and the (orange) Alarm lamp is lit:

Press the button on only one access point.

Check the security settings of the access point.

After checking the above points, wait for a while and con gure wireless connection setting again.

For details on how to check the security settings of the access point, refer to the manual supplied with the access

point or contact its manufacturer.

When the (blue) Wi-Fi lamp ﬂ ashes quickly and the (orange) Alarm lamp is lit:

Is the network device (router, etc.) turned on? If the network device is already turned on, turn it off, then turn it back

on.

Are the computer and network device con gured?

Are the access point and printer installed in an open space where wireless communications are possible?

Is the access point operating in IEEE802.11n (2.4 GHz), IEEE802.11g or IEEE802.11b?

Wait for a while, then bring the access point and printer close to each other, and con gure wireless connection

settings again within a speci ed time.

For details on how to check the settings of the access point, refer to the manual supplied with the access point or

contact its manufacturer.

To conﬁ gure wireless connection settings again

To con gure wireless connection settings again, press the Color button (A).



•



•



Autres manuels pour Pixma MG3500 Series

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Canon Imprimante

Canon

Canon imageCLASS MF3010 Guide de sécurité

Canon

Canon PIXMA MX512 Manuel utilisateur

Canon

Canon TS8200 Series Manuel utilisateur

Canon

Canon imagePROGRAF W2200S Manuel utilisateur

Canon

Canon GP200 Manuel utilisateur

Canon

Canon laser Shot LBP 3300 Manuel utilisateur

Canon

Canon BW Remote Operators Software Kit-A1 Manuel utilisateur

Canon

Canon iPF510 - imagePROGRAF Color Inkjet Printer Manuel utilisateur

Canon

Canon Arizona 2300 Series Manuel utilisateur

Canon

Canon PIXMA iP2000 Series Instructions d'utilisation

Canon

Canon PIXMA MP630 Manuel utilisateur

Canon

Canon imagePROGRAF iPF6350 Manuel utilisateur

Canon

Canon MK3000 Manuel utilisateur

Canon

Canon imageRUNNER 2204 Manuel utilisateur

Canon

Canon TS7450 Guide de configuration

Canon

Canon PIXMA G7010 Manuel utilisateur

Canon

Canon imageFORMULA DR-G2140 Manuel utilisateur

Canon

Canon PIXMA iP4000R Series Manuel utilisateur

Canon

Canon PIXMA PRO-1 Series Manuel utilisateur

Canon

Canon G3410 Manuel utilisateur

Canon

Canon SELPHY SQUARE QX10 Manuel utilisateur

Canon

Canon S630 Manuel utilisateur

Canon

Canon imagePRESS C7000VP Series Manuel technique

Canon

Canon iP5200R - PIXMA Color Inkjet Printer Manuel utilisateur

Manuels Imprimante populaires d'autres marques

Lexmark

Lexmark 1400 Series Manuel

Evolis

Evolis Elypso Manuel utilisateur

Kyocera

Kyocera FS-9530DN Manuel utilisateur

Samsung

Samsung BIXOLON SRP-350plusF Manuel utilisateur

Dell

Dell Color Laser Printer 2130cn Manuel utilisateur

Tektronix

Tektronix Phaser 840 Manuel utilisateur

Epson

Epson ET-7750 Mode d'emploi

Eltron

Eltron P210 Guide Manuel utilisateur

Ricoh

Ricoh MD-P1 Manuel utilisateur

Epson

Epson SC-F7100 series Manuel utilisateur

Epson

Epson Stylus C40UX Manuel utilisateur

IRA3D

IRA3D POETRY4 Manuel utilisateur

Ricoh

Ricoh Aficio AP400 Manuel utilisateur

BIXOLON

BIXOLON SRP-352plusV Manuel utilisateur

Epson

Epson Stylus Photo PX700W Instructions de montage

Ricoh

Ricoh SP204SF Manuel utilisateur

Star Micronics

Star Micronics futurePRNT TSP100 Manuel utilisateur

Epson

Epson TM-TM88V-i Manuel d'utilisation et d'entretien